Search results for " absorption"
showing 10 items of 1056 documents
The effect of cathartic agents on transmucosal electrical potential difference in the human rectum.
1980
Active ion transport in the colon is generating a transmucosal electrical potential difference (PD) of about 40 mV. Cathartic agents inhibit electrolyte and water net-absorption or cause net-secretion which should be reflected in a change of PD. In 83 normal subjects the effect of an isotonic eletrolyte solution (control) and different cathartic agents on rectal PD was tested: Laxatives (bisacodyl, rhein), bile acids (cholic and deoxycholic acid), fatty acids (oleic and ricinoleic acid) and cardiac glycosides (meproscillarin, digitoxin, digoxin). Bisacodyl, deoxycholic acid in high concentration, meproscillarin and digitoxin significantly decreased PD, while the other substances did not. Ca…
ESR response to gamma-rays of alanine pellets containing B(OH)3 or Gd2O3.
2007
ESR response to gamma-irradiation (1-50 Gy) of blends containing alanine and either B(OH)(3) or Gd(2)O(3) is reported. The sensitivity of the alanine--B(OH)(3) blend is comparable to the sensitivity of pure alanine, although its lowest detectable dose, LDD, is smaller ( approximately 1.3 Gy) than that of pure alanine ( approximately 2.9 Gy). Alanine with Gd(2)O(3) is about two times more sensitive than pure alanine, and its LDD is 0.8 Gy. The better sensitivity and LDD are probably due to the high atomic number (Z=64) of gadolinium, which enhances the interaction probability with photons and, consequently, the radical yield. This study suggests that other high-Z atoms may be useful for incr…
The defined adsorption site of sodium on the TiO2(110)–(1×1) surface
2004
The adsorption site of sodium on the TiO2(1 1 0)–(1 × 1) surface was studied by extended X-ray absorption fine structure. For coverage ranging between 0.25 and 0.5 ML, we find that sodium is on an ‘in-between' site where it is bound to two bridging oxygen atoms at 2.25 Å and one in-plane oxygen atom at 2.40 Å, in full agreement with DFT calculations. At higher coverage the site becomes an hollow site where the sodium atom is equidistant to the three oxygen atoms at 2.30 Å, while metallic sodium clusters are also formed at the surface.
Defects in yttrium aluminium perovskite and garnet crystals: atomistic study
2000
Native and impurity point defects in both yttrium aluminium perovskite (YAP) and garnet (YAG) crystals are studied in the framework of the pair-potential approximation coupled with the shell model description of the lattice ions. The calculated formation energies for native defects suggest that the antisite disorder is preferred over the Frenkel and Schottky-like disorder in both YAP and YAG. The calculated values of the distortion caused by the antisite YAl x in the lattice turn out to be in an excellent agreement with the EXAFS measurements. In non-stoichiometric compounds, the calculated reaction energies indicate that excess Y2 O3 or Al2 O3 is most likely to be accommodated by the forma…
Influence of the electro-optical properties of an a-Si:H single layer on the performances of a pin solar cell
2012
We analyze the results of an extensive characterization study involving electrical and optical measurements carried out on hydrogenated amorphous silicon (α-Si:H) thin film materials fabricated under a wide range of deposition conditions. By adjusting the synthesis parameters, we evidenced how conductivity, activation energy, electrical transport and optical absorption of an α-Si:H layer can be modified and optimized. We analyzed the activation energy and the pre-exponential factor of the dark conductivity by varying the dopant-to-silane gas flow ratio. Optical measurements allowed to extract the absorption spectra and the optical bandgap. Additionally, we report on the temperature dependen…
High-pressure flow-injection assembly. Indirect determination of glycine by atomic absorption spectrometry.
1991
A procedure for the determination of glycine is described. The method is based on the reaction of the analyte with finely powdered, solid copper(II) carbonate in a continuous-flow assembly. The optimum experimental conditions of pH, temperature, sample volume, flow-rate, column length and internal diameter, and the linear range of calibration, were studied. Interference from foreign substances that accompany this amino acid in pharmaceutical formulations was studied, and the method was applied to the determination of glycine.
Optimization of selenium determination in human milk and whole blood by flow injection hydride atomic absorption spectrometry.
1998
abstract A flow injection hydride atomic absorption spectrometry (FI-HAAS) method was developed for determining selenium in human milk and whole blood after microwave digestion of the sample. The sample (2 mL human milk or 0.25 mL blood) was introduced into the microwave vessel with 1.5 mL HN03 and 0.25 mL H202 and 300 W (4 min) and 600 W (4 min) were applied. The digestion was completed by heating to 140 C (2-3 h). Se (VI) was reduced to Se (IV) with hydrochloric acid. The instrumental conditions for FI-HAAS (concentrations of reducing agent and carrier acid, flow rate of argon carrier gas, and sample volume injected) were optimized. The detection limit of the proposed method was 0.23 ng/m…
Ultraviolet Filters in Cosmetics
2018
Abstract UV filters are used in sunscreen cosmetics to protect skin from the sunlight. Nowadays, they are also incorporated into other daily-use cosmetics. However, many concerns about their safety have been raised, because they can be absorbed through the skin, further metabolized and eventually bioaccumulated and/or excreted. These percutaneous absorption processes may result in various adverse health effects (i.e., allergic contact dermatitis) and other more serious systemic effects, such as carcinogenic and oestrogenic activity. For this reason, UV filters as well as their maximum allowed concentrations have been regulated by the legislations in force. In this sense, analytical control …
Photocatalytic activity of anatase-nickel ferrite heterostructures
2015
The simple co-precipitation route was used to couple commercial TiO2 anatase nanopowder with nickel ferrite (NiFe2O4). The morphology and the crystalline structure of composite nanoparticles were characterised by TEM, N2 adsorption-desorption, XRD and Rietveld refinement, XPS and XAS. The optical and magnetic properties were investigated. After co-precipitation NiFe2O4 nanoparticles, composed of spinel ferrite crystal phase, were formed on the surface of TiO2 anatase nanopowder. The TiO2/NiFe2O4 composite oxide demonstrated large specific surface area, high visible light absorption efficiency and efficient charge carrier separation, compared to pristine anatase TiO2 or pristine NiFe2O4, rep…
Physicochemical characterization of metal hexacyanometallate–TiO2composite materials
2015
The paper describes the synthesis and characterization of novel TiO2–metal hexacyanometallates (MHCMs) composite materials. The starting material, TiO2, was modified by addition of cobalt-hexacyanoferrate (CoHCF) or iron-hexacyanocobaltate (FeHCC) at various concentrations. The resulting composites were characterized as follows: cyclic voltammetry (CV) followed the formation of TiO2–MHCM clusters, TEM micrographs studied their morphology, XAS and XPS data indicated that MHCM bonds to TiO2 through the nitrogen atom of its –CN group and modifies the environment of Ti compared to that of pure anatase. As expected, and confirmed by UV-Vis and XP-valence band data, the electronic properties of T…