Search results for " photonic"
showing 10 items of 720 documents
Comparison of conventional and dense dispersion managed systems for 160 Gb/s transmissions
2006
International audience; In this paper, we carry out, by numerical simulations and experiments on recirculating loop.. a comparative analysis of the performances of two types of dispersion management techniques for 160 Gb/s transmission systems, which correspond to short-period dispersion maps (dense dispersion management) and long-period dispersion maps (conventional dispersion management), respectively. We show that the dense dispersion management system suffers performance degradation by the effects of polarization mode dispersion (PMD) and fiber splicing losses, in a more dramatic manner than in the system with long-period map. We experimentally find that, at constant PMD, dense dispersi…
Wavelength-selective directional coupling with dielectric-loaded plasmonic waveguides
2009
International audience; We consider wavelength-selective splitting of radiation using directional couplers (DCs) formed by dielectric-loaded surface-plasmon-polariton waveguides (DLSPPWs). The DCs were fabricated by depositing subwavelength-sized polymer ridges on a gold film using large-scale UV photolithography and characterized at telecommunications wavelengths with near-field microscopy. We demonstrate a DLSPPW-based 45-mu m-long DC comprising 3 mu m offset S bends and 25-mu m-long parallel waveguides that changes from the "through" state at 1500 nm to 3 dB splitting at 1600 nm, and show that a 50.5-mu m-long DC should enable complete separation of the radiation channels at 1400 and 162…
Measurement of UV-induced absorption and scattering losses in photosensitive fibers
2018
UV-assisted fabrication of gratings using photosensitive fibers is a well-established technique, based on the UV-induced permanent modification of the refractive index of the fiber material. As a result, the absorption coefficient is also changed. Here, we exploit the thermal sensitivity of whispering gallery mode resonances of the fiber itself to measure the profile of the heating along an irradiated fiber versus the input power and for different UV radiation intensities. Our technique allows discriminating between the absorption and scattering contributions to the overall losses, by comparing the results obtained with our technique with direct transmission measurements. Different photosen…
Photocatalytic H2 production over inverse opal TiO2 catalysts
2019
Abstract The influence of BiVO4 and CuO on the chemico-physical properties of TiO2-based systems is reported. The performances of these systems were investigated in the photocatalytic H2 production both under UV and solar light irradiation. The characterization data pointed out that the obtained TiO2 samples have highly porous inverse opal structures with interconnected macropores. Inverse opal TiO2 exhibited higher activity in the H2 production than the commercial TiO2 due to the peculiar porosity that allows photons to enter inside the photocatalyst. A further improvement in terms of photoactivity was verified by addition of increasing amounts of BiVO4. On the contrary a small CuO content…
Infrared laser threshold magnetometry with a NV doped diamond intracavity etalon
2019
International audience; We propose a hybrid laser system consisting of a semiconductor external cavity laser associated to an intra-cavity diamond etalon doped with nitrogen-vacancy color centers. We consider laser emission tuned to the infrared absorption line that is enhanced under the magnetic field dependent nitrogen-vacancy electron spin resonance and show that this architecture leads to a compact solid-state magnetometer that can be operated at room-temperature. The sensitivity to the magnetic field limited by the photon shot-noise of the output laser beam is estimated to be less than 1 pT/ √ Hz. Unlike usual NV center infrared magnetometry, this method would not require an external f…
Cladding-Pumped Erbium/Ytterbium Co-Doped Fiber Amplifier for C-Band Operation in Optical Networks
2021
Space-division multiplexing (SDM) attracts attention to cladding-pumped optical amplifiers, but they suffer from a low pump power conversion efficiency. To address this issue, ytterbium (Yb3+) and erbium (Er3+) co-doping is considered as an effective approach. However, it changes the gain profile of Er3+-doped fiber amplifiers and induces the gain difference between optical wavelengths in the C-band, significantly limiting the effective band of the dense wavelength-division multiplexed (DWDM) system. This paper is devoted to a detailed study of a cladding-pumped Er3+/Yb3+ co-doped fiber amplifier (EYDFA) through numerical simulations aiming to identify a configuration, before assembling a s…
Spontaneous intercalation of Ga and In bilayers during plasma-assisted molecular beam epitaxy growth of GaN on graphene on SiC
2019
The formation of a self-limited metallic bilayer is reported during the growth of GaN by plasma-assisted molecular beam epitaxy on graphene on (0001) SiC. Depending on growth conditions, this layer may consist of either Ga or In, which gets intercalated between graphene and the SiC surface. Diffusion of metal atoms is eased by steps at SiC surface and N plasma induced defects in the graphene layer. Energetically favorable wetting of the (0001) SiC surface by Ga or In is tentatively assigned to the breaking of covalent bonds between (0001) SiC surface and carbon buffer layer. As a consequence, graphene doping and local strain/doping fluctuations decrease. Furthermore, the presence of a metal…
Transmission properties at microwave frequencies of two-dimensional metallic lattices
1999
The transmission properties of different metallic photonic lattices (square and rectangular) have been experimentally studied. A numerical algorithm based on time domain finite differences has been used for simulating these photonic structures. The introduction of defects in the two-dimensional metallic lattice modifies its transmission spectrum. If metal rods are eliminated from (or added to) the lattice, extremely narrow peaks are observed at some particular frequencies below (or above) the band pass edge. Vicente.Such@uv.es ; Enrique.Navarro@uv.es
Tunable dual-wavelength operation of an all- fiber thulium-doped fiber laser based on tunable fiber Bragg gratings
2018
Tunable dual-wavelength emission of a Tm-doped fiber laser based on two fiber Bragg gratings (FBGs) is experimentally demonstrated. By using two FBGs with central wavelengths at 2069.30 and 2069.44 nm, stable dual-wavelength laser generation in the 2 ?m wavelength region is achieved by adjusting the differential loss of the two wavelengths in the laser cavity. Strain applied on the FBG allows independent tuning of the simultaneously generated wavelengths with separation between the laser lines in a range from 0.54 to 9 nm. The laser has output power fluctuations less than 0.093% for an output power of 77.3 mW.
Fabrication of long period fiber gratings of subnanometric bandwidth.
2017
This paper reports on the fabrication of long period fiber gratings having subnanometric bandwidth in the 1500 nm spectral region. Large gratings have been photo-inscribed in a high NA fiber, the grating pitch and the order of the HE cladding mode are optimized to produce gratings with a large number of periods and preventing the coupling to TE, TM or EH modes. Resonances with a FWHM of 0.83 nm and 0.68 nm have been achieved for gratings 15 and 20 cm long respectively, the free spectral range between transmission notches is 125 nm. The polarization effects and the sensitivity of the gratings to temperature and to strain variations are presented as well. © 2015 Optical Society of America Thi…