Search results for "clean energy"
showing 10 items of 2594 documents
Modelling hydrolysis: Simultaneous versus sequential biodegradation of the hydrolysable fractions
2018
Hydrolysis is considered the limiting step during solid waste anaerobic digestion (including co-digestion of sludge and biosolids). Mechanisms of hydrolysis are mechanistically not well understood with detrimental impact on model predictive capability. The common approach to multiple substrates is to consider simultaneous degradation of the substrates. This may not have the capacity to separate the different kinetics. Sequential degradation of substrates is theoretically supported by microbial capacity and the composite nature of substrates (bioaccessibility concept). However, this has not been experimentally assessed. Sequential chemical fractionation has been successfully used to define i…
Redshifted Cherenkov Radiation for in vivo Imaging: Coupling Cherenkov Radiation Energy Transfer to multiple Förster Resonance Energy Transfers
2017
AbstractCherenkov Radiation (CR), this blue glow seen in nuclear reactors, is an optical light originating from energetic β-emitter radionuclides. CR emitter 90Y triggers a cascade of energy transfers in the presence of a mixed population of fluorophores (which each other match their respective absorption and emission maxima): Cherenkov Radiation Energy Transfer (CRET) first, followed by multiple Förster Resonance Energy transfers (FRET): CRET ratios were calculated to give a rough estimate of the transfer efficiency. While CR is blue-weighted (300–500 nm), such cascades of Energy Transfers allowed to get a) fluorescence emission up to 710 nm, which is beyond the main CR window and within t…
Pd-Cu catalysts supported on anion exchange resin for the simultaneous catalytic reduction of nitrate ions and reductive dehalogenation of organochlo…
2019
International audience; The present work proposes the simultaneous removal of these classes of pollutants by a catalytic hydrotreatment processes. For this purpose, bimetallic Pd-Cu catalysts (with mass ratio Pd:Cu of 4:1) supported on macroporous strong base anion resin were prepared by different methods. The catalysts were characterized (by XRD, SEMEDX, XPS, AAS and H-2 chemisorption) and tested in a continuous flow system. The selected catalyst preparation protocol consists in a two-step method, which implies the deposition of palladium by ion exchange and the subsequent deposition of copper by controlled reaction on the surface of the pre-reduced palladium. The effectiveness of the cata…
Combustion wave structure during the MoSi2 synthesis by Mechanically-Activated Self-propagating High-temperature Synthesis (MASHS): In situ time-reso…
2006
Abstract In situ synchrotron time-resolved X-ray diffraction experiments coupled with an infrared imaging camera have been used to reveal the combustion wave structure during the production of MoSi2 by Mechanically Activated Self-propagating High-temperature Synthesis (MASHS). The fast combustion front exhibits a form described as an ‘equilibrium structure’ where the chemical reaction is the sole major driving force. In the MASHS process, oxide-free interfaces between Mo and Si nanocrystallites enhance the reaction Mo+2Si→MoSi2. Exhaustive time-resolved investigations show a possible solid-state process in the first second of the reaction within the combustion front. If preheating is added,…
Residual Phase Noise Measurement of Optical Second Harmonic Generation in PPLN Waveguides
2017
We report on the characterization, including residual phase noise and fractional frequency instability, of fiber-coupled PPLN non-linear crystals. These components are devoted to frequency doubling 871 nm light from an extended-cavity diode laser to produce a 435.5 nm beam, corresponding to the ytterbium ion electric quadrupole clock transition. We measure doubling efficiencies of up to 117.5 %/W. Using a Mach-Zehnder interferometer and an original noise rejection technique, the residual phase noise of the doublers is estimated to be lower than ${\rm -35\, dBrad^2/Hz}$ at 1 Hz, making these modules compatible with up-to-date optical clocks and ultra-stable cavities. The influence of externa…
Ab-Initio Calculations of Oxygen Vacancy in Ga2O3 Crystals
2021
The research has been funded by the Science Committee of the Ministry of Education and Science of the Republic of Kazakhstan (Grant No. AP08856540). J. Purans and A.I.Popov acknowledge the ERAF project 1.1.1.1/20/A/057 “Functional Ultrawide Bandgap Gallium Oxide and Zinc Gallate Thin Films and Novel Deposition Technologies”. The Institute of Solid State Physics, University of Latvia (Latvia) as the Centre of Excellence has received funding from the European Union’s Horizon 2020 Framework Programme H2020-WIDESPREAD01-2016-2017-Teaming Phase2 under grant agreement No. 739508, project CAMART2.
Switch in Relative Stability between cis and trans 2-Butene on Pt(111) as a Function of Experimental Conditions: A Density Functional Theory Study
2018
International audience; The adsorption of cis and trans 2-butenes on Pt(111) has been studied as a function of hydrogen coverage OH by means of calculations based on density functional theory (DFT) with the inclusion of dispersion forces. All hydrogen coverages have been considered, from 0 to 1.00 monolayer (ML). For each case, the di-sigma and pi adsorption geometries of the olefins have been compared at a surface coverage of theta(C4H8) = 0.11 ML. Calculations of the Gibbs free energies of these systems have identified the most stable 2-butene isomer (cis or trans) as a function of coverage, temperature, and pressure. In particular, focus was placed on two sets of conditions, namely, one …
Ash in composting of source-separated catering waste.
2004
Our earlier experiments in small composters (220 l) indicated the favourable effect of ash from co-incineration of sorted dry waste on the composting of catering waste. The aim of this new study was to clarify further, at a scale of 10 m3, the feasibility of using similar ash as an additive in composting.Source-separated catering waste was mixed with bulking agent (peat and wood chips) and fuel ash from a small (4 MW) district heating power plant. Three compost mixes (CM) were obtained: CM I with 0%, CM II with 10% and CM III with 20 wt.% of fuel ash. These three different mixes were composted in a 10-m3 drum composter as three parallel experiments for 2 weeks each, from January to April 20…
Ultrasound assisted method to increase soluble chemical oxygen demand (SCOD) of sewage sludge for digestion
2004
The aim of this study was to clarify the possibilities to increase the amount of soluble chemical oxygen demand (SCOD) and methane production of sludge using ultrasound technologies with and without oxidising agents. The study was done using multivariate data analyses. The most important factors affected were discovered. Ultrasonically assisted disintegration increased clearly the amount of SCOD of sludge. Also more methane was produced from treated sludge in anaerobic batch assays compared to the sludge with no ultrasonic treatment. Multivariate data analysis showed that ultrasonic power, dry solid content of sludge (DS), sludge temperature and ultrasonic treatment time have the most signi…
Alkaline pretreatment to enhance one-stage CH4 and two-stage H2/CH4 production from sunflower stalks: Mass, energy and economical balances
2015
Abstract Biological production of second generation biofuels such as biohydrogen (H2) or methane (CH4) represents a promising alternative to fossils fuels. Alkaline pretreatments of lignocellulosic biomass are known to enhance the accessibility and the bioconversion of hollocelluloses during anaerobic digestion and dark fermentation processes. In the present study, four different configurations were investigated: one-stage CH4 continuous and two-stage H2 batch/CH4 continuous process with and without alkaline pretreatment of sunflower stalks (55 °C, 24 h, 4 g NaOH/100 g TS). The results showed that two stage H2/CH4 (150 ± 3.5 mL CH4 g−1 VS) did not improve methane yields compared to one stag…