Search results for "fluids"
showing 10 items of 1936 documents
Resonance ionization of holmium for ion implantation in microcalorimeters
2016
Abstract The determination of the electron neutrino mass by calorimetric measurement of the 163 Ho electron capture spectrum requires ultra-pure samples. Several collaborations, like ECHo or HOLMES, intend to employ microcalorimeters into which 163 Ho is implanted as an ion beam. This makes a selective and additionally very efficient ion source for holmium mandatory. For this purpose, laser resonance ionization of stable holmium 165 Ho was studied, using a three step excitation scheme driven by pulsed Ti:sapphire lasers. Five measurements with sample sizes of 10 14 and 10 15 atoms were performed for the efficiency investigation. In average, an excellent ionization efficiency of 32(5) % coul…
Application and development of ion-source technology for radiation-effects testing of electronics
2017
Abstract Studies of heavy-ion induced single event effect (SEE) on space electronics are necessary to verify the operation of the components in the harsh radiation environment. These studies are conducted by using high-energy heavy-ion beams to simulate the radiation effects in space. The ion beams are accelerated as so-called ion cocktails, containing several ion beam species with similar mass-to-charge ratio, covering a wide range of linear energy transfer (LET) values also present in space. The use of cocktails enables fast switching between beam species during testing. Production of these high-energy ion cocktails poses challenging requirements to the ion sources because in most laborat…
Inner shell ionization of argon in ECRIS plasma
2018
Abstract The volumetric K α emission rate of argon emitted from the electron cyclotron resonance (ECR) heated plasmas of the JYFL (University of Jyvaskyla, Department of Physics) 14 GHz ECR ion source (ECRIS) and the 14.5 GHz Grenoble Test Source (GTS) at iThemba Laboratory for Accelerator Based Sciences have been measured to gain an understanding of the influence of the ion source tune parameters on the absolute inner shell ionization rate. It was observed that the behaviour of the ionization rate and the extracted ion beam currents react differently, depending the parametric sweep performed. The neutral gas pressure and incident microwave power was found to have the strongest influence on…
Improved EDGE2D-EIRENE simulations of JET ITER-like wall L-mode discharges utilising poloidal VUV/visible spectral emission profiles
2015
A discrepancy in the divertor radiated powers between EDGE2D-EIRENE simulations, both with and without drifts, and JET-ILW experiments employing a set of NBI-heated L-mode discharges with step-wise density variation is investigated. Results from a VUV/visible poloidally scanning spectrometer are used together with bolometric measurements to determine the radiated power and its composition. The analysis shows the importance of D line radiation in contributing to the divertor radiated power, while contributions from D radiative recombination are smaller than expected. Simulations with W divertor plates underestimate the Be content in the divertor, since no allowance is made for Be previously …
Modelling of JET hybrid plasmas with emphasis on performance of combined ICRF and NBI heating
2018
International audience; During the 2015--2016 JET campaigns, many efforts have been devoted to the exploration of high-performance plasma scenarios envisaged for DT operation in JET. In this paper, we review various key recent hybrid discharges and model the combined ICRF NBI heating. These deuterium discharges with deuterium beams had the ICRF antenna frequency tuned to match the cyclotron frequency of minority H at the centre of the tokamak coinciding with the second harmonic cyclotron resonance of D. The modelling takes into account the synergy between ICRF and NBI heating through the second harmonic cyclotron resonance of D beam ions, allowing us to assess its impact on the neutron rate…
Development of a liquid Pb-Bi target for high-power ISOL facilities
2016
Abstract This paper describes some R&D activities conducted in support of the design and safe operation of a high-power liquid Pb-Bi target within the LIEBE (Liquid Eutectic Lead Bismuth Loop Target for EURISOL) project. The target material is lead bismuth eutectic (LBE) which also acts as a primary coolant. As a consequence of interaction of the highly pulsed 1.4-GeV protons at ISOLDE with the target, heat powers of the order of 2 GW would be instantaneously deposited in the target during a bunch. Considerable R&D effort is thus required to demonstrate its continued coolability and structural integrity. This paper mainly reports on the conjugate flow (CFD) and heat deposition (Monte Carlo)…
Radiation-induced effects in neutron- and electron-irradiated lithium silicate ceramic breeder pebbles
2020
Abstract Ceramic breeder (CB) pebbles consisting of lithium orthosilicate (Li4SiO4) as the main phase and lithium metasilicate (Li2SiO3) as a secondary phase were analysed with respect to radiation-induced defects and radiolysis products. Therefore, pebbles that were irradiated with neutrons in the so-called HICU experiment ( H igh neutron fluence i rradiation of pebble sta c ks for f u sion) were compared to pebbles irradiated with accelerated electrons and to an unirradiated sample. Fourier transformation infrared spectroscopy was used to investigate changes in the phase composition. Beside an expected increase in the second phase in the neutron-irradiated samples, no further significant …
TRITIUM RELEASE CHARACTERISTICS OF NEUTRON-IRRADIATED REFERENCE BERYLLIUM PEBBLES FOR THE HELIUM COOLED PEBBLE BED (HCPB) BLANKET
2011
In this paper, we present results on tritium release from the beryllium pebbles irradiated for 294 full power days from 17 April 2003 to November 2004 to the neutron fluence of 1.5-2 × 1025 m-2 (E>...
Germanium Doped CHxMicroshells for LMJ Targets
2011
AbstractAt the CEA Laser “Megajoule” facility, amorphous hydrogenated carbon (a-C:H or CHx) is the nominal ablator used to achieve inertial confinement fusion experiments. These targets are filled with a fusible mixture of deuterium-tritium in order to perform ignition.Since the achievement of ignition greatly depends on the physical properties of the shell, there must be precise control of thicknesses, doping concentration, and roughness. Experimental devices associated with suitable characterizations are described in this paper. The tolerances and yields for each specification are also presented. Some specifications are largely reached; high-frequency surface roughness due to isolated sur…
Effect of double frequency heating on the lead afterglow beam currents of an electron cyclotron resonance ion source
2017
International audience; The effect of double frequency heating on the performance of the CERN GTS-LHC 14.5 GHz ElectronCyclotron Resonance (ECR) ion source in afterglow mode is reported. The source of the secondary microwave frequency was operated both in pulsed and continuous wave (CW) modes within the range of 12–18 GHz. The results demonstrate that the addition of the secondary frequency can significantly impact the extracted beam currents and the temporal stability of the beam during the afterglow discharge. For example, up to a factor of 2.6 increase was achieved for 208Pb35+ and a factor of 3.1 for 208Pb37+ compared to single frequency afterglow currents. It is shown that these effect…