Search results for "fuel"

Characterization and pilot scale fluidized bed gasification of herbaceous biomass: A case study on alfalfa pellets

2015

Abstract Pilot-scale bubbling fluidized bed gasification tests of alfalfa pellets were performed at two different operational periods ranged on the basis of the two given equivalence ratio (ER) (the ratio between actual air and the stoichiometric air) namely as 0.25 and 0.30. During the test, the solid feeding rate was kept constant at 4.7 kg/h while the air input was varied and thus the ER. Increasing air from 4.16 to 4.99 N m3/h contributed to the evolution pattern of several parameters such as the rise in gas lower heating value (LHV) and gas yield, the average maximum of which were 4.2 MJ/N m3 and 1.5 N m3/kg respectively. Gas composition was mainly boosted by the concentration of CO, a…

Preferential CO oxidation over catalysts with well-defined inverse opal structure in microchannels

2008

Catalyst supports of CeO 2 /SiO 2 and Al 2 O 3 with three-dimensionally ordered macroporous structure were fabricated in microchannels by application of PMMA opals as templates. Pt-Rh supported on CeO 2 /SiO 2 showed high efficiency for CO removal in preferential CO oxidation in the presence of excess hydrogen. Pt-Rh supported on Al 2 O 3 with an inverse opal structure showed higher reactivity than that supported on wash-coated Al 2 O 3 layers in microchannel reactor.

Evaluation of the fuel potential of sewage sludge mixtures with beech sawdust and lignite

2018

Sewage sludge (SS) from municipal wastewater treatment has drawn serious attention of scientists around the world in the attempt to find feasible disposal methods. Therefore, in this work, a solution for valorisation of SS as solid fuel is proposed based on an advanced compositional investigation of SS versus conventional solid fuels, namely, lignite (L) and beech sawdust (BS). A characterisation in terms of proximate analysis and ultimate analysis was performed for the studied materials, both to SS, L, and BS as single fuel and to bi-component mixture formulas of SS and L/BS, in variable proportions of 30:70, 50:50, and 70:30. SS:BS based blends had higher hydrogen (from 4.43 wt. % to 5.14…

Enhancement of biomass retention in an EGSB reactor used to treat 1-methoxy-2-propanol

2017

Melt flow instability and vortex structures in Czochralski growth under steady magnetic fields

2002

Abstract The hydrodynamics of melt motion in the CZ-process of silicon single crystal growth in axial and axial–radial magnetic fields is studied using a physical model. The modeling liquid is eutectics InGaSn. Most attention is paid to the problem of flow stability. A multi-channel system gathering data is used to define the pattern and dynamics of velocity disturbances. Instant spatial distributions of the electric potential induced by motion in the melt are obtained. Temporal evolution of the instant distributions in vertical and horizontal planes of the working volume is under investigation.

Interference of EDTA in the treatment of metal plating wastewater by biosorption

2012

Double cross-linked polyetheretherketone proton exchange membrane for fuel cell

2012

Abstract The proton exchange membrane based on polyetheretherketone was prepared via two steps of cross-linking. The properties of the double cross-linked membrane (water uptake, proton conductivity, methanol permeability and thermal stability) have been investigated for fuel cell applications. The prepared membrane exhibited relatively high proton conductivity, 3.2 × 10 −2  S cm −1 at room temperature and 5.8 × 10 −2  S cm −1 at 80 °C. The second cross-linking significantly decreased the water uptake of the membrane. The performance of direct methanol fuel cell was slightly improved as compared to Nafion ® 117 due to its low methanol permeability. The results indicated that the double cros…

Catalytic performance of CoAlZn and NiAlZn mixed oxides in hydrogen production by bio-ethanol partial oxidation

2013

CoAlZn and NiAlZn mixed oxides were prepared by sol-gel method and tested in partial oxidation of bio-ethanol (POE). At lower temperatures, CoAlZn showed higher ethanol conversion and higher selectivity to H2 and CO than NiAlZn. At higher temperatures, ethanol conversion on both catalysts reached 100%, while selectivity (S) to H2 and CO became higher on NiAlZn. At 750 C, NiAlZn showed S(H2) of 95%, S(CO) of 90%, while for CoAlZn these values were 90% and 83% respectively. Both catalysts were resistant to coking, but the amount of carbon deposits was still lower on NiAlZn. During 50 h on-stream, ethanol conversion and selectivity to H2 and CO on NiAlZn remained unchanged demonstrating stable…

First-principles modelling of complex perovskite (Ba1-xSrx)(Co1-yFey)O3-δ for solid oxide fuel cell and gas separation membrane applications

2010

The results of the first principles spin-polarized DFT calculations of the atomic and electronic structure of a complex perovskite (Ba1-xSrx)(Co1-yFey)O3-δ (BSCF) used as a cathode material for solid oxide fuel cells (SOFC) and gas separation membranes are presented and discussed. The formation energies of oxygen vacancies are found to be considerably smaller than in other magnetic perovskites, e.g. (La,Sr)MnO3, which explains the experimentally observed strong deviation of this material from stoichiometry. The presence of oxygen vacancies induces a local charge redistribution, associated with the local lattice perturbation, and expansion of the equilibrium volume, in line with the experime…

Riga experience in spallation neutron target related investigations

2002

Abstract Mercury has awakened interest as a potential material for spallation neutron source targets. Institute of Physics, University of Latvia has a 30 years experience of investigations in mercury. As specially projected building includes a 350 m2 experimental hall. The largest loop, containing 5×103 kg of Hg, can be transferred for solution of different tasks. As the first example results are presented when integral developed pressure and local (distribution of void fraction) characteristics of a two-phase mercury/gas riser were investigated. Second example – investigation of velocity fields and heat transfer conditions close to the beam entrance window in the SINQ target thermohydrauli…