Crystal structure and microstructure of synthetic hexagonal magnesium–cobalt cordierite solid solutions (Mg2−2xCo2xAl4Si5O18)

Co2+-containing cordierite glasses, of nominal compositions (Mg1−xCox)2Al4Si5O18(withx= 0, 0.2, 0.4, 0.6, 0.8 and 1), were prepared by melting colloidal gel precursors. After isothermal heating at 1273 K for around 28 h, a single-phase α-cordierite (high-temperature hexagonal polymorph) was synthesized. All materials were investigated using X-ray powder diffraction and field-emission scanning electron microscopy. The crystal structure and microstructure were determined from X-ray diffraction patterns. Rietveld refinement confirmed the formation of magnesium–cobalt cordierite solid solutions. The unit-cell volume increased with the increase of cobalt content in the starting glass. The crysta…

Microstructural evolution of mullites produced from single-phase gels

The crystalline microstructure of mullites obtained by heating monophasic gels has been investigated. Gels with alumina to silica molar ratio of 3:2 (as in secondary mullite) and 2:1 (as in primary mullite) were prepared by gelling mixtures of aluminium nitrate and tetraethylorthosilicate. Phase transformations were induced by heating the gel precursors, with different final treatment temperatures between 1173 and 1873 K. The mullites formed as a result of thermal treatment were studied by means of X-ray diffraction, scanning electron microscopy and transmission electron microscopy. The crystalline structure (unit-cell parameters) and microstructure were determined from X-ray diffraction pa…

X-ray diffraction microstructure analysis of mullite, quartz and corundum in porcelain insulators

Abstract The X-ray diffraction microstructure analysis has been performed on commercial samples of the silica and alumina porcelain insulators obtained at 1300 °C, with the same time of firing. The study was carried out on mullite, corundum and quartz by applying several integral breadth methods (i.e. the Williamson–Hall analysis, the Langford method and the Halder–Wagner approximation) and the Fourier analysis (Warren–Averbach method). The apparent crystallite sizes determined for the mullite are direction-dependent (anisotropic) and within each group of samples, on average, the greatest values are obtained along the direction [0 0 1]. With regard to the microstructure of the corundum and …

A new interpretation and practical aspects of the direct-methods modulus sum function. VIII

Since the first publication of the direct-methods modulus sum function [Rius (1993). Acta Cryst. A49, 406-409], the application of this function to a variety of situations has been shown in a series of seven subsequent papers. In this way, much experience about this function and its practical use has been gained. It is thought by the authors that it is now the right moment to publish a more complete study of this function which also considers most of this practical knowledge. The first part of the study relates, thanks to a new interpretation, this function to other existing phase-refinement functions, while the second shows, with the help of test calculations on a selection of crystal stru…

Quantitative X-ray diffraction phase analysis of airborne particulate collected by a cascade impactor sampler using the Rietveld full-pattern fitting method

Samples of airborne particulate were collected at the “El Ingenio” site in Castellón (Spain) using a cascade impactor sampler. Quantitative analysis of present phases in the aerosol was performed using the full-pattern fitting Rietveld method. Quantitative information was obtained from refined individual scale factors and unit-cell volumes, obtained with a Rietveld refinement program. Quartz, calcite, and gypsum were encountered as major phases, and their size distribution and concentration in the atmosphere were calculated.

Quantitative X-Ray Powder Diffraction Analysis of Some Feldspars Used as Raw Material in Ceramics

Crystal structure determination of 1-pentanol from low-temperature powder diffraction data by Patterson search methods

5 pages.-- PACS: 61.66.Hq; 61.50.Lt

Crystal Data for Metal Cimetidine Isotiocionates: M(CM)2(NCS)2 (M = Co(II), Ni(II), Cu(II))

AbstractMetal cimetidine isothiocyanates, M(C10H16SN6)2(NCS)2, where M = Co(II), Ni(II) and Cu(II), have been investigated by means of X-ray powder diffraction. Unit cell dimensions were determined from powder diffractometer data. Refined cell parameters (monoclinic with a primitive cell), powder data, calculated densities and Z value are presented.

Effect of TiO2 on the mullite formation and mechanical properties of alumina porcelain

Abstract The effect of adding TiO 2 to standard alumina porcelain on its microstructure and flexural strength was investigated. A series of alumina porcelain bodies containing increasing amounts of TiO 2 were prepared by extruding mixtures of raw materials and TiO 2 . Porcelain rods were fired under industrial scheduling in a manufacturing kiln. The overall degree of crystalline and amorphous phase content within the porcelain bodies was quantitatively determined using a Rietveld analysis. Results indicated a higher amount of mullite formation in porcelain bodies containing TiO 2 . Examination of the product materials using field emission scanning electron microscopy showed a high density o…

X-ray powder diffraction phase analysis and thermomechanical properties of silica and alumina porcelains

Chemical and mineralogical characterization, using the Rietveld method, of some silica and alumina rich porcelains and its relationship with thermomechanical properties have been studied in this work. X-ray powder diffraction analysis allows to differ clearly between silica and alumina porcelains. X-ray study shows that both porcelains have a content of vitreous phase. This vitreous phase is higher in the silica than in the alumina porcelain. Dilatometric studies combined with powder diffraction methods shows a strong relationship between silica content and a lower expansion coefficients and between alumina content and a higher crash resistance. Lower contents in vitreous phase in porcelain…

A rietveld study of the cation substitution between uvarovite and yttrium-aluminum synthetic garnets, obtained by sol-gel method

A series of synthetic garnets solid solutions with compositions between Y 3 Al 2 Al 3 O 12 (Y-Al garnet) (YAG) and Ca 3 Cr 2 Si 3 O 12 (uvarovite) was synthesized using the sol-gel method. The expected general formula is (Ca x Y 1-x ) 3 (Cr x Al 1-x ) 2 (Si x Al 1-x ) 3 O 12 where x=0 to x=1. The cation distribution in dodecahedral, octahedral and tetrahedral sites and bond distances in these synthetic garnets were determined using the Rietveld method. It shows the incomplete substitution in small sites. The smaller site the smaller substitution there is

Quantitative Phase Analysis of Mixtures of Three Components using Rietveld and Rius Standardless Methods. Comparative Results

Eight samples, supplied by the Commission on Powder Diffraction of the International Union of Crystallography, through the Round Robin on quantitative phase analysis, were analized using standardless methods. Samples were mixtures of corundum, zincite and fluorite in different ratios. The Rietveld method, using the DBW 3.2 and FULLPROF software, and the Rius method, using MENGE-PC software, were used. Results obtained agree well with the real composition supplied (a posteriori) by the IUCr.

An X-ray powder diffraction study of the microstructural evolution on heating 3:2 and 2:1 mullite single-phase gels

Single-phase gels with compositions 3Al2O3·2SiO2 and 2Al2O3·SiO2 were prepared by gelling mixtures of aluminium nitrate and tetraethylorthosilicate. Gels were fast heated at different temperatures between 900°C and 1600°C. The phase transformation and microstructural changes of both mullite precursor gels over the temperature range were followed by X-ray powder diffraction (XRD), lattice parameter determination (LP), and scanning and transmission electron microscopies (SEM and TEM). The distribution of crystallite sizes and strains were determined by linewidth refinements of X-ray diffraction patterns using the integral breadth method of Langford and the Warren-Averbach analysis. XRD of bot…

Crystal Data for Nickel Cimetidine Chloride: Ni (CM)2 CL2·2H2O

AbstractNickel Cimetidine Chloride, Ni(C10H16SN6)2Cl2·2H2O has been investigated by means of X-ray powder diffraction. Unit cell dimensions were determined by indexing programs, from diffractometer data obtained with copper radiation. A primitive monoclinic cell was found: a = 11.836(3)Å, b = 13.322(5)Å, c = 10.487(2)Å, β = 113.08 (2)°, Z = 2, Dx = 1.462 g/cm3, M.W. = 670.32. These data are consistent with values reported in the literature for other cimetidine complexes.

Caracterización mineralógica de materias primas cerámicas por métodos cuantitativos de difracción de rayos x

[ES] El objetivo de este trabajo es la caracterización de fases minerales presentes en materias primas utilizadas en la industria cerámica. Para ello se utilizan dos métodos cuantitativos basados en la difracción de rayos X, el método de Rietveld y un método sin estándar. Los resultados obtenidos por difracción rayos X de estos materiales policristalinos se comparan con los correspondientes análisis químicos y la composición normativa calculada. La precisión y reproducibilidad de los resultados obtenidos, en concordancia con los del análisis químico, son una de las más importantes ventajas de la difractometría cuantitativa que facilitan su utilización en la industria cerámica en el control …

Crystal Data for Complexes of Co(II) and Ni(II) Perchlorates with Mepirizole

AbstractMetal mepirizole perchlorates, M(C11H14N4O2)3 (C104)2 where M = Co(II) and Ni(II) have been investigated by means of X-ray powder diffraction. Unit cell dimensions were determined by indexing programs from diffractometer data. Refined cell parameters (monoclinic with a C-centered cell), calculated density and Z values are presented.

Solubility and microstructural development of TiO2-containing 3Al2O3·2SiO2 and 2Al2O3·SiO2 mullites obtained from single-phase gels

Abstract The interdependence of the titanium oxide amount and the anisotropic growth of mullites prepared from single-phase gels were investigated. Gels with stoichiometries 3(Al2−xTixO3)·2(SiO2) and 2(Al2−xTixO3)·(SiO2), with 0 ≤ x ≤ 0.15 were prepared by the semialkoxide method. Gels and specimens heated at temperatures between 1200 and 1600 °C were characterized by using infrared spectroscopy (IR), X-ray diffraction (XRD) and transmission and field emission scanning electron microscopies (TEM and FESEM). Al2TiO5 as minor impurity was detected in both series of mullites for gel precursor compositions x = 0.10 and x = 0.15, obtained at temperatures between 1200 and 1600 °C. Variations of l…

A tangent formula derived from Patterson-function arguments. VII. Solution of inorganic structures from powder data with accidental overlap

Accidental overlap constitutes one of the principal limitations for the solution of crystal structures from powder diffraction data, since it reduces the number of available intensities for direct-methods application. In this work, the field of application of the direct-methods sum function is extended to cope with powder patterns with relatively large amounts of accidental overlap. This is achieved by refining not only the phases of the structure factors but also the estimated intensities of the severely overlapped peaks during the structure solution process. This procedure has been specifically devised for inorganic compounds with uncertain cell contents and with probable severe atomic di…