Modeling the interactions between light and crystallizing polymer during fast cooling

2004

In this work, an experimental set-up able to quench thin polymer films whilst recording the sample thermal history as well as the overall and depolarized light intensities of a laser beam emerging from the sample is described. The interactions between the light beam and the crystallizing material have been modeled accounting for absorption and scattering phenomena. The proposed model was found to be able to reproduce the ex- perimentally observed behavior of light intensities and it was validated by comparison with conventional DSC analysis. On the basis of this model, a method to obtain crystallinity evo- lution is proposed and applied to some fast cooling runs. The method was applied to q…

Ruolo della Simulazione Realistica Tramite Laerdal SimMan® nell’Addestramento per la Gestione di Emergenze Intra ed Extraospedaliere

2008

Analysis of gate freeze-off time in injection molding

2004

Gate solidification time is an important topic in injection molding technology, as it determines cycle time, which itself is an important issue in the economics of the production process. In this work, a study of the effect of both gate and cavity geometries on gate solidification time was conducted, using a commercial polymer, injection molded with constant holding pressure into a rectangular cavity. Three cavity lengths were used, and for each, two cavity thicknesses were adopted. Spe- cial dies containing different gates were assembled in the mold. Gate thickness was found to be the most important factor determining gate sealing time. However, the cavity geometry is also quite important.…