showing 8 related works from this author
Applications of spray-drying in microencapsulation of food ingredients: An overview
2007
International audience; Spray-drying process has been used for decades to encapsulate food ingredients such as flavors, lipids, and carotenoids. During this drying process, the evaporation of solvent, that is most often water, is rapid and the entrapment of the interest compound occurs quasi-instantaneously. This required property imposes a strict screening of the encapsulating materials to be used in addition to an optimization of the operating conditions. Likewise, if the encapsulated compound is of hydrophobic nature, the stability of the feed emulsion before drying should also be considered. Thus, spray-drying microencapsulation process must rather be considered as an art than a science…
Effect of high methoxyl pectin on pea protein in aqueous solution and at oil/water interface
2010
International audience; The effect of the addition of high methoxyl pectin on the stability of pea protein isolate emulsions was investigated. Except for low pectin concentrations at acidic pHs where bridging flocculation occurred the addition of pectin improved emulsion stability to pH changes and depletion flocculation induced by maltodextrin addition. The mechanism of pectin induced stability was probed by measuring protein-pectin complex formation in solution, zeta potential of the emulsions droplets and the change in surface viscoelasticity on pectin addition. The phase diagrams of pectin-pea protein isolate in solution and pectin-pea protein-stabilized emulsions were established based…
Enrobages comestibles et emballages actifs pour la conservation d’aliments périssables présentation et premiers résultats du projet de coopération Fr…
2017
International audience; Les différentes étapes pour la préparation de films à base de biopolymères contenant des biomolécules antimicrobiennes et/ou antioxydantes applicables pour la conservation d’aliments périssables sont illustrées par les études réalisées par 4 équipes de recherche associées à un programme de coopération Franco-Thaïlandaise. Ces grandes étapes sont : (i) le choix de la formulation des ingrédients entrant dans la composition du film, (ii) les paramètres associés aux procédés d’élaboration des films, (iii) la caractérisation des propriétés physico-chimiques des films et l’évaluation in vitro de leur activité antimicrobienne ou antioxydante et (iv) leur application in situ…
Design of biopolymeric matrices entrapping bioprotective lactic acid bacteria to control Listeria monocytogenes growth: Comparison of alginate and al…
2014
In order to design biopolymeric matrices entrapping bioprotective lactic acid bacteria (LAB) to control undesirable microorganisms growth in foods, the performances of alginate and alginate-caseinate (an aqueous two-phase system) matrices entrapping Lactococcus lactis subsp. lactis LAB3 cells were compared. Since efficient matrices should preserve the culturability and the antimicrobial activity of entrapped LAB3 cells for prolonged periods, they were both monitored for 12 days storage at 30 °C. Maximal cell density (∼109 CFU mL−1) was reached after 24 h whatever the matrix type. Then, the LAB3 cells population decreased: 107 and 106 CFU mL−1 were enumerated after 12 days in alginate-casein…
Utilisation of pectin coating to enhance spray-dry stability of pea protein-stabilised oil-in-water emulsions
2010
International audience; In this study, development of pea (Pisum sativum) protein stabilised dry and reconstituted emulsions is presented. Dry emulsions were prepared by spray-drying liquid emulsions in a laboratory spray-dryer. The effect of drying on the physical stability of oil-in-water emulsions containing pea protein-coated and pea protein/pectin-coated oil droplets has been studied. Oil-in-water emulsions (5 wt.% Miglyol 812 N, 0.25 wt.% pea protein, 11% maltodextrin, pH 2.4) were prepared that contained 0 (primary emulsion) or 0.2 wt.% pectin (secondary emulsion). The emulsions were then subjected to spray-drying and reconstitution (pH 2.4). The stability of the emulsions to dry pro…
Preferential localization of Lactococcus lactis cells entrapped in a caseinate/alginate phase separated system.
2013
International audience; This study aimed to entrap bioprotective lactic acid bacteria in a sodium caseinate/sodium alginate aqueous two-phase system. Phase diagram at pH = 7 showed that sodium alginate and sodium caseinate were not miscible when their concentrations exceeded 1% (w/w) and 6% (w/w), respectively. The stability of the caseinate/alginate two-phase system was also checked at pH values of 6.0 and 5.5. Lactococcus lactis subsp. lactis LAB3 cells were added in a 4% (w/w) caseinate/1.5% (w/w) alginate two-phase system at pH = 7. Fluorescence microscopy allowed to observe that the caseinate-rich phase formed droplets dispersed in a continuous alginate-rich phase. The distribution of …
Properties of spray-dried food flavours microencapsulated with two-layered membranes: Roles of interfacial interactions and water
2012
International audience; Engineering the interface of oil-in-water emulsion droplets with biopolymers that modify its permeability could provide a novel technique to improve flavour retention in dry powders. The objective of this study was to determine if volatile compounds were more retained in dry emulsions stabilized by pea protein isolate (PPI)/pectin complex than that stabilized by PPI alone. The retention of ethyl esters during spray-drying increased with decreasing volatility of the encapsulated compound and ranged from 28% to 40%. The addition of pectin to feed emulsions was quite effective in markedly improving the retention of the three studied flavour compounds. In our previous wo…
Preservation of viability and anti-Listeria activity of lactic acid bacteria, Lactococcus lactis and Lactobacillus paracasei, entrapped in gelling ma…
2015
In order to control undesirable microorganisms growth in foods, the performance of alginate and alginate-caseinate (an aqueous two-phase system) matrices entrapping lactic acid bacteria (LAB) (Lactobacillus paracasei LAB1 and Lactococcus lactis LAB3) was investigated. Polymeric matrices were initially loaded with Lcells at similar to 10(8-10) or similar to 10(4-6) CFU mL(-1), and were monitored, in liquid and gelled form (beads), for 12 days at 30 degrees C. In the liquid form, maximum cell density (similar to 10(9) CFU mL(-1)) was reached after 24 h whatever the matrix. Then, the Lpopulation decreased but remained higher in alginate-caseinate matrices: 10(7) and 10(6) CFU mL(-1) of LAB3 ce…