0000000000525268
AUTHOR
Z. Tang
showing 4 related works from this author
First measurement of the |t|-dependence of coherent J/ψ photonuclear production
2021
The first measurement of the dependence on $|t|$, the square of the momentum transferred between the incoming and outgoing target nucleus, of coherent J/ψ photoproduction is presented. The data were measured with the ALICE detector in ultra-peripheral Pb-Pb collisions at a centre-of-mass energy per nucleon pair $\sqrt{s_{\rm NN}} = 5.02$ TeV with the J/$\psi$ produced in the central rapidity region $|y| < 0.8$, which corresponds to the small Bjorken-$x$ range $(0.3 − 1.4) \times 10 ^{−3}$. The measured $|t|$-dependence is not described by computations based only on the Pb nuclear form factor, while the photonuclear cross section is better reproduced by models including shadowing according t…
Measurements of mixed harmonic cumulants in Pb–Pb collisions at sNN=5.02 TeV
2021
Correlations between moments of different flow coefficients are measured in Pb–Pb collisions at sNN=5.02 TeV recorded with the ALICE detector. These new measurements are based on multiparticle mixed harmonic cumulants calculated using charged particles in the pseudorapidity region |η|<0.8 with the transverse momentum range 0.2<pT<5.0 GeV/c. The centrality dependence of correlations between two flow coefficients as well as the correlations between three flow coefficients, both in terms of their second moments, are shown. In addition, a collection of mixed harmonic cumulants involving higher moments of v2 and v3 is measured for the first time, where the characteristic signature of ne…
General Economic Order Quantity Model for Lot Sizing with Quality Loss and Process Analysis
1995
In this paper a new model GEOQ is proposed to decide the optimal lot sizing in production. The GEOQ modifies the classical EOQ method in several aspects. First it considers that there is always a probability that the production goes out-of-control; then it takes the time the process goes out-of-control as a stochastic quantity; and finally it adds quality loss to the economic models. The quality loss is calculated according to Taguchi’s quadratic loss function. and depends on the process failure models. Therefore, the optimal lot sizing is decided not only by the set-up cost and the holding cost but also by the quality loss during the manufacturing process.
On Line Tool Life Prediction for Tool Replacement Strategy in FMS Workstation
1993
In FMS environment a large variety of tools are shared resources being employed to process different part type varying the cutting parameters during their useful life. The paper suggests a new methodology to predict the tool life on line using the information deriving from the control station of the production system to gain information about the tool wear.