0000000000681877
AUTHOR
Steven Legowik
showing 3 related works from this author
Mobile Robot and Mobile Manipulator Research Towards ASTM Standards Development
2016
International audience; Performance standards for industrial mobile robots and mobile manipulators (robot arms onboard mobile robots) have only recently begun development. Low cost and standardized measurement techniques are needed to characterize system performance, compare different systems, and to determine if recalibration is required. This paper discusses work at the National Institute of Standards and Technology (NIST) and within the ASTM Committee F45 on Driverless Automatic Guided Industrial Vehicles. This includes standards for both terminology, F45.91, and for navigation performance test methods, F45.02. The paper defines terms that are being considered. Additionally, the paper de…
Calibration of mobile manipulators using 2D positional features.
2018
International audience; Robotic manipulators are increasingly being attached to Automatic Ground Vehicles (AGVs) to aid in the efficiency of assembly for manufacturing systems. However, calibrating these mobile manipulators is difficult as the offset between the robotic manipulator and the AGV is often unknown. This paper provides a novel, simple, and low-cost method for calibrating and measuring the performance of mobile manipulators by using data collected from a laser retroreflector that digitally detects the horizontal two-dimensional (2D) position of reflectors on an artifact as well as a navigation system that provides the heading angle and 2D position of the AGV. The method is mathem…
Mobile manipulator performance measurement towards manufacturing assembly tasks
2016
Mobile manipulator performance measurement research is relatively minimal as compared to that of robot arms. Measurement methods, such as optical tracking systems, are useful for measuring the performance of mobile manipulators, although at a much higher relative cost as compared to artifacts. The concept of using test artifacts demonstrates to potential manufacturers and users of mobile manipulator systems that relatively low cost performance measurement methods exist. This paper discusses the concept of reconfigurable mobile manipulator artifacts that were designed and built. An artifact was then used through experimentation to measure the performance of a mobile manipulator to demonstrat…