Injection molding of syndiotactic polystyrene/clay nanocomposites

2006

This study aims at exploring the effect of a commercial organoclay montmorillonite (MMT) on the final properties of syndiotactic polystyrene (sPS) injection-molded samples. To this goal, injection-molded specimens made from neat sPS and commercial MMT modified with various organic compounds were prepared in different molding conditions. Dispersion of clay was attained via melt blending, directly in the injection chamber of the injection-molding machine. The obtained specimens were analyzed by IR spectroscopy, X-ray diffraction, thermogravimetry, and differential thermal analysis, with the aim of elucidating the effect of clay on the microstructures of the samples. Results clearly show that,…

GRICU2019 special issue section preface

2020

Sul Miglioramento della Processabilità del Nanocomposito a base di Polistirene Sindiotattico e Argille Modificate

2004

Sul Miglioramento della Processabilità del Nanocomposito a base di Polistirene Sindiotattico e Argille Modificate

Analysis of gate freeze-off time in injection molding

2004

Gate solidification time is an important topic in injection molding technology, as it determines cycle time, which itself is an important issue in the economics of the production process. In this work, a study of the effect of both gate and cavity geometries on gate solidification time was conducted, using a commercial polymer, injection molded with constant holding pressure into a rectangular cavity. Three cavity lengths were used, and for each, two cavity thicknesses were adopted. Spe- cial dies containing different gates were assembled in the mold. Gate thickness was found to be the most important factor determining gate sealing time. However, the cavity geometry is also quite important.…