How composition and process parameters affect volatile active compounds in biopolymer films

2012

Abstract Active edible films based on chitosan and containing an active aroma compound have been investigated. The influence of the composition of the film forming solution (solvent, plasticizers, nanoparticles, emulsifiers and aroma traps) and process parameters (temperature and viscosity) on drying kinetics, water content, colour, aroma compound retention and partition coefficient was studied. Solvent evaporation rate was increased by addition of ethanol. Water evaporation was delayed by glycerol. The aroma retention during film drying was directly related to the water content. The drying temperature had opposite influences according to the composition of the solvent and additives. Increa…

Carvacrol affects interfacial, structural and transfer properties of chitosan coatings applied onto polyethylene

2012

Different chitosan coating solutions were tested with the aim of investigating their adhesion and wettability onto polyethylene film to improve packaging performance and provide antimicrobial properties. Surface wetting kinetics was monitored by contact angle measurements. Addition of ethanol and carvacrol improved wettability and adhesion of the thin chitosan layer. Structure, water vapour, O2, CO2 and air permeabilities of self supported chitosan films and coated polyethylene were determined. The formation of a thin chitosan layer on polyethylene improved gas barrier properties decreasing the Permeability Coefficient for oxygen and carbon dioxide ( [Formula: see text] , [Formula: see text…

Effect of relative humidity on carvacrol release and permeation properties of chitosan based films and coating

2014

International audience; The influence of water vapour conditions on mass transport and barrier properties of chitosan based films and coatings were studied in relation to surface and structural properties. Water contact angles, material swelling, polymer degradation temperature, barrier properties (PO2, PCO2, WVP) and aroma diffusion coefficients were determined. The solvent nature and the presence of carvacrol influenced the surface and structural properties and then the barrier performance of activated chitosan films. Increasing RH from 0% to 100% led to a significant increase in material swelling. The plasticization effect of water was more pronounced at high humid environment, while at …

Surface, mechanical and barrier properties of bio-based composite films based on chitosan and whey protein

2014

Mono-component and composite bilayer and blend films composed of chitosan and whey protein were made. Colour, microstructure, water contact angles, swelling, water vapour sorption, barrier properties (oxygen, water vapour), water vapour diffusion coefficients and mechanical properties were determined. The influence of water vapour on barrier properties was studied in relation to the surface and structural properties. Mono-component and bilayer films were transparent with a homogeneous surface. Contrarily, blend films were translucent. Bilayer films had significantly lower water vapour permeability in comparison to mono-component and blend films. In all bilayer films, the air side (chitosan)…

Bio‐based Materials

2021

Characterization of Food Packaging Films with Blackcurrant Fruit Waste as a Source of Antioxidant and Color Sensing Intelligent Material

2021

Chitosan and pectin films were enriched with blackcurrant pomace powder (10 and 20% (w/w)), as bio-based material, to minimize food production losses and to increase the functional properties of produced films aimed at food coatings and wrappers. Water vapor permeability of active films increased up to 25%, moisture content for 27% in pectin-based ones, but water solubility was not significantly modified. Mechanical properties (tensile strength, elongation at break and Young’s modulus) were mainly decreased due to the residual insoluble particles present in blackcurrant waste. FTIR analysis showed no significant changes between the film samples. The degradation temperatures, determined by D…

Aroma behaviour during steam cooking within a potato starch-based model matrix.

2012

To help understand the organoleptic qualities of steam cooked foods, the kinetics of aroma release during cooking in a potato starch based model matrix was studied. Behaviour of components having a major impact in potato flavour were studied using solid phase micro extraction-gas chromatography (SPME-GC). Evolution of microstructure of potato starch model-matrix during steam cooking process was analyzed using environmental scanning electron microscopy (ESEM). Both aroma compounds that are naturally present in starch matrix and those that were added were analyzed. Both the aroma compounds naturally presented and those added had different behaviour depending on their physico-chemical properti…

Structure and thermal properties of a chitosan coated polyethylene bilayer film

2012

The thermal and the structural properties of chitosan coated polyethylene (PE) films were studied. The coating process did not significantly influence the thermal stability and the PE surface structure and/or composition of the polyolefin. Dehydration temperature of chitosan films reflected the strength of water/acetic acid/chitosan chains interactions. Glycerol, used as a plasticizer, formed new hydrophilic centres in the film matrix. Moreover it was better integrated in the CSEGLY than in CSAGLY network. Besides, the addition of a plasticizer in the chitosan films decreased the film degradation temperature. There were two main steps for the PE chitosan coated films degradation. The first …

Novel functional chitosan and pectin bio-based packaging films with encapsulated Opuntia-ficus indica waste

2021

Abstract The aim of this work was to study the effect of adding red prickly pear, as wasted source of antioxidants on various characteristics of novel functional (antioxidant) chitosan and pectin film formulations. Four types of prickly pear material were used: fruit pulp or peel, as powdered extracts and as aqueous extracts. Prickly pear peel extract was shown to possess higher antioxidant properties than fruit pulp. The antioxidant power of extracts was pretty high, around 1000 mgAAE∙100 g−1 for extract and that of all films around 100 mgAAE∙100 g−1 for films. Even though some changes in thickness, moisture content, water solubility, oxygen permeability and water vapor permeability of fil…

Antioxidants and Bioactive Compounds in Food: Critical Review of Issues and Prospects

2022

International audience; This review paper gives an insight into the effective delivery mechanisms for health-promoting substances and highlights the challenges of using antioxidants and bioactives in foods. The selection criteria for choosing bioactives and their extraction in bioavailable form with their adequate incorporation techniques and delivery mechanisms are covered. Moreover, an overview of existing methods for determination of bioactivity is given. The importance of scientifically evaluating the effects of foods or food components on consumer health before making claims about the healthiness is aligned. Finally, a scientific perspective on how to respond to the booming demand for …

Effect of high power ultrasound on physical–chemical properties of polypropylene films aimed for food packaging: structure and surface features

2019

International audience; Biaxially oriented polypropylene (BOPP) coated with acrylic/polyvinylidene chloride (BOPPAcPVDC) and biaxially oriented coextruded polypropylene (BOPPcoex) films have been treated with high power ultrasound (HPUS) while submerged in water. Polymer structure and the surface morphology changes were noticed, and obtained results were correlated with the physical properties of tested materials. In anticipation of sonochemically enhanced reactions, physical–chemical profile of film samples was determined using thermogravimetric analysis, differential scanning calorimetry, Fourier-transform infrared spectroscopy, UV spectrophotometry and environmental scanning electron mic…

Influence of high power ultrasound on physical-chemical properties of polypropylene films aimed for food packaging: barrier and contact angle features

2017

Investigation was focused on the impact of high power ultrasound (HPUS), also called thermosonication, on the oxygen permeation properties (permeability, solubility and diffusion coefficients) of barrier films aimed for food packaging. For this purpose, biaxially oriented polypropylene (BOPP) coated with acrylic/polyvinylidene chloride (BOPPAcPVDC) and biaxially oriented coextruded polypropylene (BOPPcoex) were used. The physical–chemical profile of the samples was determined using goniometry. There is a significant impact only of extreme HPUS conditions (the longest time and the highest amplitude) on the permeability, solubility and diffusion coefficients of oxygen through the BOPP films. …

Barrier properties of chitosan coated polyethylene

2012

The transfer properties of chitosan coated polyethylene (PE) films were studied. The barrier properties of non coated PE were not affected by relative humidity changes. The presence of the hydrophilic chitosan layer acted as a water reservoir on the polyethylene film surface which significantly promoted its sensitivity to the water vapour. The water vapour permeability increased 1.85 times at a higher RH. Coated PE films showed more than two-order decrease in the oxygen permeability (PO2) and three-order-decrease in the carbon dioxide permeability (PCO2). When the chitosan coated PE surface was exposed to the water vapour, the PO2 and the PCO2 were significantly increased. However, the perm…

Barrier, structural and mechanical properties of bovine gelatin-chitosan blend films related to biopolymer interactions

2014

BACKGROUND The increased use of synthetic packaging films has led to a high ecological problem due to their total non-biodegradability. Thus, there is a vital need to develop renewable and environmentally friendly bio-based polymeric materials. Films and coatings made from polysaccharide polymers, particularly chitosans and gelatins have good gas barrier properties and are envisaged more and more for applications in the biomedical and food fields, as well as for packaging. In this study a casting method was used to develop an edible plasticised film from chitosan and gelatin. Aiming to develop a blend film with enhanced properties, the effects of mixing chitosan (CS) and gelatin (G) in diff…

Contribution à la compréhension de l'influence des paramètres de formulation et de procédé sur la structure et les propriétés fonctionnelle de films …

2012

The aim of this study is the analysis of structure and transfer mechanisms through chitosan based food packaging materials with incorporated carvacrol as a model of antimicrobial active substance. Integration of composition parameters, structure, processing and drying of chitosan systems is correlated to its physico chemical and functional properties. Understanding and detailed analyses of processing parameters is crucial in production of active chitosan coatings applied on conventional materials such as polyethylene. So, the knowledge of composition and microstructure in association to environmental conditions, control the retention and the release kinetics of carvacrol from chitosan film.…