Search results for " Batteries"
showing 10 items of 45 documents
Room-Temperature Micropillar Growth of Lithium-Titanate-Carbon Composite Structures by Self-Biased Direct Current Magnetron Sputtering for Lithium Io…
2019
Here, an unidentified type of micropillar growth is described at room temperature during conventional direct-current magnetron sputtering (DC-MS) deposition from a Li4Ti5O12+graphite sputter target under negative substrate bias and high operating pressure. These fabricated carbon-Li2O-TiO2 microstructures consisting of various Li4Ti5O12/Li2TiO3/LixTiO2 crystalline phases are demonstrated as an anode material in Li-ion microbatteries. The described micropillar fabrication method is a low-cost, substrate independent, single-step, room-temperature vacuum process utilizing a mature industrial complementary metal-oxide-semiconductor (CMOS)-compatible technology. Furthermore, tentative considerat…
Performance of Thin-Film Lithium Energy Cells under Uniaxial Pressure
2008
The objective of this study was two-fold. The first objective was to determine if the all-solid-state thin-film lithium energy cells could withstand the minimal 550 kPa uniaxial pressure required for composite manufacturing, which both specimens successfully did. The second objective was to determine the upper boundary uniaxial pressure limit of operation for the all-solid-state thin-film lithium energy cells. The two all-solid- state thin-film lithium energy cells tested in the present study under uniaxial pressure performed well even when subjected to uniaxial pressures up to about 2.0 MPa. However, pressures higher than this value led to their degradation. The observed degradation was du…
Nanostructured Material Fabrication for Energy Conversion
2011
The electrochemical deposition is a suitable via to fabricate nanostructured materials for energy conversion, and for other purposes. This paper deals with the electrochemical synthesis of nanostructured alloys and ruthenium oxide, which can be used in Li-ion batteries and polymer electrolyte membrane electrolyzers.
Electrochemical Fabrication of Sn-Co Nanowires in Anodic Alumina Templates
2008
LEAD-ACID BATTERIES WITH NANOSTRUCTURED ELECTRODES
2020
Ultrafast lead-acid battery with nanostructured Pb and PbO2 electrodes
2018
Lead-acid batteries (LABs) are still extensively used in the field of energy storage, owing to a well-known and reliable technology. LABs can deliver high power and store energy for a very long time. In addition, they are reliable and easy to produce. The raw materials for their manufacture are practically unlimited, and about 95% of the materials can be recovered and reused. However, the lower specific energy storage (about 30-40 Wh kg-1), in comparison with other storage systems, limits their use in the most emerging and challenging applications, like electrical mobility, due to the high atomic weight of lead [1]. One of the principal limitations in the use of LABs in electric vehicles (E…
ULTRAFAST LEAD ACID BATTERIES USING NANOSTRUCTURED ELECTRODES
2012
Fabrications of Nanostructures And Nano-Structured Devices Using Electrochemical Methods
2013
Nanostructured Lead Electrodes with Reduced Graphene Oxide for High-Performance Lead–Acid Batteries
2022
Nanostructured Pb electrodes consisting of nanowire arrays were obtained by electrodeposition, to be used as negative electrodes for lead–acid batteries. Reduced graphene oxide was added to improve their performances. This was achieved via the electrochemical reduction of graphene oxide directly on the surface of nanowire arrays. The electrodes with and without reduced graphene oxide were tested in a 5 M sulfuric acid solution using a commercial pasted positive plate and an absorbed glass mat separator in a zero-gap configuration. The electrodes were tested in deep cycling conditions with a very low cut-off potential. Charge–discharge tests were performed at 5C. The electrode wi…