Search results for " Chemical Engineering"
showing 10 items of 2965 documents
Influence of the passive film properties and residual stresses on the micro-electrochemical behavior of duplex stainless steels
2010
In the present paper, the chemical composition of passive films formed on both phases of two types of duplex stainless steels (UNS S31803 and UNS S32304) is determined at the micro-scale using Auger electron spectroscopy (AES). Samples were either mechanically polished (down to diamond pastes) or electrochemically etched in acidic solutions. The micro-electrochemical behavior of samples was then determined in sodium chloride media by means of the electrochemical micro-cell technique (capillary diameters of 30 μm). The results obtained were analyzed considering the passive film chemical composition. Quantitative relationships between electrochemical parameters and the distribution of chromiu…
Influence of the grain orientation spread on the pitting corrosion resistance of duplex stainless steels using electron backscatter diffraction and c…
2013
Abstract The corrosion behavior of UNS S32202 duplex stainless steel was studied by combining electron backscatter diffraction (EBSD) measurements and critical pitting temperature tests at the microscale. The grain orientation spread (GOS) value was determined in grains of both phases from EBSD data. It was shown that austenitic sites containing extremely small ferrite grains having a GOS value greater than 1.3° were precursor sites for pitting in 4 M NaCl. The critical pitting temperature range was 45–90 °C. All the other sites of both phases remained passive up to 100 °C.
Passive properties of lean duplex stainless steels after long-term ageing in air studied using EBSD, AES, XPS and local electrochemical impedance spe…
2013
Abstract Passivity of duplex stainless steel was studied after long-term ageing in air using local electrochemical impedance spectroscopy, AES, XPS and EBSD. After mechanical polishing, the passive film was homogeneous and had a capacitive behaviour described by the CPE. After long-term ageing, a small thickening was detected and O2−/OH− was significantly higher in the austenite than in the ferrite. Austenite behaved as a blocking electrode whereas two capacitive loops were observed in the ferrite (low value of O2−/OH). The loop at high frequencies was related with the oxygen reduction and the loop at low frequencies was connected with the passive film.
Relationships between the Impedance of Oxide Scales on Martensitic and Austenitic Steels and Corrosion Rate in Liquid Lead-Bismuth Eutectic
2004
Abstract The impedance properties (resistance and capacitance) of oxide scales on the martensitic/ferritic steel HT-9 and austenitic stainless steel Type 316L (UNS S31603) were examined during immersion in lead-bismuth eutectic (LBE) using a technique similar to electrochemical impedance spectroscopy. These scales were created by preoxidizing the samples in an air/water vapor environment at 800°C for various times prior to immersion in LBE. Calculation of oxide conductivity for samples immersed in LBE at 200°C for 200 h yielded σHT9 ≈ 4 × 10−7 (Ω × cm)−1 while σ316 ≈ 3 × 10−8 (Ω × cm)−1. The influence of temperature alone gave the anticipated Arrhenius behavior with Ea equal to 0.12 eV, whi…
Influence of preoxidation on the corrosion of steels in liquid lead-bismuth eutectic
2004
Abstract Oxidation studies of martensitic/ferritic and austenitic steels have been conducted in static lead bismuth eutectic (LBE). Samples were preoxidized in an air/H2O gas mixture prior to immersion in LBE. Preoxidation films grown on HT-9 at 800°C for 48 h had a bilayer structure, an outer Fe-rich layer, and an inner Cr-rich layer. Glancing angle x-ray diffraction data found that two distinct structures were present in this oxide: Fe1+xCr2−xO4 spinel (cubic, face-centered cubic [fcc]) and (Cr,Fe)2O3 (rhombohedral, corundum). Magnetite formation (Fe3O4) was ruled out. Immersion in LBE resulted in the growth of an Fe-rich film on top of the preoxidation layer. It was concluded that the gr…
A corrosion study of austenitic and martensitic steels under boiler conditions by means of 57Fe conversion electron mössbauer spectroscopy
1978
Abstract The growth of protective oxide layers on a martensitic FeCr (1.4122) and two austenitic FeCrNi steel samples (1.4550 and Incoloy 800) was studied by means of the 57Fe Conversion Electron Mossbauer Spectroscopy (CEMS). Scanning electron microscopy was applied to characterize the topographical nature of the oxide layers. Following a technical procedure of running-in steam generators, the steel specimens were oxidized in oxygen-free water at 295°C, 142 bar and a pH value between 9 and 10 for periods up to 70 h. In the case of the steels 1.4122 and 1.4550 the only oxide phase detected was non-stoichiometric magnetite, whereas nickel ferrite of nonstoichiometric composition was found…
Tracing, authenticating and dating archaeological metal using the voltammetry of microparticles
2011
Electrochemical techniques provide information of archaeometric interest. An overview on the application and future developments of the voltammetry of microparticles to the study of archaeological metals and their alteration products is presented. A report on the state of the art and future developments of this technique with regard to identification and origin studies of materials, authentication, chronology and dating of archaeological metal is provided.
1994
Liquid crystalline side chain polymers containing photoreactive azobenzene chromophores in the dark-adapted trans form and phenylbenzoate groups as co-mesogens have been prepared and investigated as monomolecular layers at the water/air interface and as multilayer assemblies deposited onto solid supports by the Langmuir–Blodgett–Kuhn (LBK) technique. Pressure area isotherms at variable temperatures together with reflection absorption spectra and Brewster angle microscopic pictures have been taken and analyzed (i) to derive information about the structural order and the packing properties of the mesogenic side groups within the monolayers of different homo- and co-polymeric systems and ii) t…
Chiral donor–π-acceptor azobenzene dyes
2009
Abstract Four chiral donor–π-acceptor azobenzene dye conjugates were synthesized and characterized. Chiral moieties, namely (S)-(+)-2-(6-methoxy-2-naphthyl)propionic acid (naproxen) and (S)-2-aminopropionic acid ( l -alanine), were attached to either the donor end or the acceptor site of the azo compound using ester or amide bonds, respectively. The structures of the molecules were verified using 1H NMR, 13C NMR and ESI TOF mass spectrometry; spectral properties were evaluated with UV–vis and CD spectrometry whilst thermal stability was determined by TGA. The compounds displayed a broad absorption maximum in the visible region between 433 and 483 nm. All compounds showed relatively high the…
Comparative Ab Initio Calculations of ReO3, SrZrO3, BaZrO3, PbZrO3 and CaZrO3 (001) Surfaces
2020
We performed, for first time, ab initio calculations for the ReO2-terminated ReO3 (001) surface and analyzed systematic trends in the ReO3, SrZrO3, BaZrO3, PbZrO3 and CaZrO3 (001) surfaces using first-principles calculations. According to the ab initio calculation results, all ReO3, SrZrO3, BaZrO3, PbZrO3 and CaZrO3 (001) surface upper-layer atoms relax inwards towards the crystal bulk, all second-layer atoms relax upwards and all third-layer atoms, again, relax inwards. The ReO2-terminated ReO3 and ZrO2-terminated SrZrO3, BaZrO3, PbZrO3 and CaZrO3 (001) surface band gaps at the &Gamma