Search results for " Concrete"

Il recupero parziale di opere in muratura di interesse storico in zona sismica

2011

Increasing the shear capacity of reinforced concrete beams using pretensioned stainless steel ribbons

2017

In this work, the second part of an experimental campaign investigating the efficiency of an alternative retrofitting method for increasing the flexural and/or shear capacity in reinforced concrete beams, based on the use of prestressed stainless steel ribbons and steel angles, is presented and analytically reproduced. This group of tests focuses on the ability of the adopted retrofitting method to improve the shear strength and ultimate deformation of reinforced concrete structural elements. As described in a companion paper, the adopted retrofitting method is alternative to traditional techniques of reinforced concrete retrofitting, being easy to install and usually reversible, and charac…

Ultrasonic inspection for the detection of debonding in CFRP-reinforced concrete

2017

Fibre-reinforced plastic (FRP) composites are extensively used to retrofit civil structures. However, the quality and the characteristics of the bond between the FRP and the structure are critical to ensure the efficacy of the retrofit. For this reason, effective non-destructive evaluation (NDE) methods are often necessary to assess the bonding conditions. This article presents an ultrasonic technique for detecting defects at the FRP-substrate interface. The technique uses the Akaike Information Criterion, to detect automatically the onset of the ultrasonic signals, and the novel Equivalent Time Lenght (ETL) parameter, to quantify the energy of the propagating ultrasonic signals along the i…

Creep of polymer concrete in the nonlinear region

2000

Two polyester-based polymer concretes with various volume content of diabase as an extender and aggregate are tested in creep under compression at different stress levels. The phenomenological and structural approaches are both used to analyze the experimental data. Common features of changes in the instantaneous and creep compliances are clarified, and a phenomenological creep model which accounts for the changes in the instantaneous compliance and in the retardation spectrum depending on the stress level is developed. It is shown that the model can be used to describe the experimental results of stress relaxation and creep under repeated loading. Modeling of the composite structure and su…

Pumice concrete for structural wall panels

2003

Some properties of lightweight pumice stone concrete (LWPSC) are discussed, on account of a possible structural use of this material. Then the results of an experimental investigation are described, in order to show that pumice can really be considered an alternative to common artificial lightweight aggregates, taking into account the performance pointed out by loading tests carried out on structural systems made of LWPSC. Three different kinds of reinforced wall panels were made using LWPSC, lightweight expanded clay concrete and normal weight concrete; then their structural responses under horizontal cyclic and constant vertical forces were compared, above all with reference to lateral st…

Influence of axial force and corrosion on failure of prestressed concrete structures considering M-V interaction

2021

Abstract Existing prestressed concrete structures suffer from degradation of prestressing for two main reasons: a defect of the sheath infills (cement grout) of bonded tendons, and corrosion of steel strands. These two causes, often concomitant, lead to a reduction over time of the effectiveness of initial prestressing, in addition to the ordinary tension losses due to concrete shrinkage and creep, and to steel relaxation. In many cases a consequence of bad grouting in bonded tendons is that the structure shows an intermediate behavior between that of external prestressing and that of internal bonded prestressing. This, added to damage to wires due to corrosion, makes it essential for the d…

Improvements in aggregate-paste interface by the hydration of steelmaking waste in concretes and mortars

2019

[EN] The objective of the experimental work is to study the mechanical properties in self-compacting concretes (SCC) in which part of the limestone aggregate has been replaced by granulated blast furnace slag (GBFS) in different percentages ranging from 0% to 60%. The results show that at early ages the SCC with the largest content in slag tend to have lower compressive strengths due to the poor compacting of the aggregates, although in the long-term their strength increases due to the reactivity of the slag. In fact, at the age of 365 days, the mortars made with the substitution of 50% of cement by ground GBFS reach compressive strength similar to that of the mortar made with 100% of cemen…

Behavior of fiber-reinforced concrete columns under axially and eccentrically compressive loads

2010

An experimental investigation into the behavior of 16 short, confined, reinforced concrete columns with and without steel fibers was carried out. The columns with square sections had a concrete core 165 x 165 mm (6.49 x 6.49 in.) at the midsection and were hunched at the ends to apply eccentric loading and prevent boundary effects. The specimens were tested to failure at different strain rates under two loading schemes: concentric compression and eccentric compression with a constant eccentricity. The axial load and axial strains were obtained to evaluate the effects of the presence of steel fibers, the thickness of the cover concrete, and the eccentricity of the applied axial load. The com…

Flexural and Shear Resistance of Steel Fiber–Reinforced Lightweight Concrete Beams

2014

In the present paper an analytical model is proposed that is able to determine the shear resistance of lightweight reinforced concrete beams with longitudinal bars, in the presence of reinforcing steel fibers. The model is based on the evaluation of the resistance contribution resulting from beam and arch actions. For the resistance contribution of main bars in tension, the residual bond adherence of steel bars and the crack spacing of reinforced concrete (RC) beams in the presence of fibers are considered. The contribution in terms of postcracking resistance in the tension zone of the beams is also included. The model was verified on the basis of experimental data available in the literatu…

A strategy for the finite element modeling of FRP-confined concrete columns subjected to preload

2018

Abstract Compressive behavior of columns strengthened by means of an outer elastic confinement provided e.g. by fiber-reinforced polymer (FRP) jackets has become a main topic in the field of structural retrofitting. In details, the problem of the response assessment of strengthened columns is still under study. Many analytical formulations have been proposed to describe the compressive behavior of confined concrete under both monotonic and cyclic loads. However, the effect of a stress/strain level in the columns already present prior to apply the confinement has been generally neglected until now, also because of the lack of well defined strategies of modeling. In this frame, here, (1) a FE…