Search results for " Constitutive Model"

Stress-strain models for normal and high strength confined concrete: Test and comparison of literature models reliability in reproducing experimental…

2017

SUMMARY: The adoption of proper constitutive laws for confined concrete is basic for seismic assessment of new and existing reinforced concrete civil structures. The deformation capacity of reinforced concrete (RC) columns subjected to axially centred and eccentric loads depends on the effectiveness confinement action. A proper assignment of the stressstrainlaws for concrete allows obtaining an adequate definition of the ductility of the crosssections and correctly identifying mechanical nonlinearities in computational models.Several studies concerning the behaviour of confined concrete have been carried out, highlighting the role of different geometrical and mechanical parameters to the ov…

On the behavior of a three-dimensional fractional viscoelastic constitutive model

2016

In this paper a three-dimensional isotropic fractional viscoelastic model is examined. It is shown that if different time scales for the volumetric and deviatoric components are assumed, the Poisson ratio is time varying function; in particular viscoelastic Poisson ratio may be obtained both increasing and decreasing with time. Moreover, it is shown that, from a theoretical point of view, one-dimensional fractional constitutive laws for normal stress and strain components are not correct to fit uniaxial experimental test, unless the time scale of deviatoric and volumetric are equal. Finally, the model is proved to satisfy correspondence principles also for the viscoelastic Poisson’s ratio a…

Case Study of the Structural Behavior of a Catalan Bricks Masonry Vault

2015

Catalan vaults are a peculiar type of low thickness vaulted brick masonry structure. Knowledge of load-deflection response and load bearing capacity are important aspects to consider with the aim of preserving these structural members as part of the cultural heritage. In order to investigate these aspects, complete knowledge of the constituent materials and geometry (dimension, thickness, constructive section) is necessary in such a way as to predict the load-deflection response and the effective load-carrying capacity; the latter can be determined utilizing simplified models (limit analysis) or by means of a numerical analysis (finite element method). With this aim, the structural behaviou…

HEXCALIBER TEST SECTION. Thermo-mechanical analysis

2009

The inhomogeneous mechanical behaviour of Ascending Thoracic Aortic Aneurism (ATAA)

2017

Surgical management of ascending thoracic aortic aneurysms (aTAAs) relies on maximum diameter, growth rate, and presence of connective tissue disorders. The surgical decision however is often not considering that dissection and rupture do occur in patients who do not meet criteria for surgical repair [1,2]. In this study the authors aim to investigate the mechanical properties of aTAAs to be implemented in computational biomechanics models for a preclinical risk evaluation. Additionally, in some recent studies, some data about the biomechanical properties of the aTAAs have been reported [3], but without any relation to bicuspidal or tricuspidal aTAA. The aim of this study was to investigate…

Non-linear analysis of plane steel prestressed truss in fire

2002

The concept of analysis of 2-D static loaded prestressed steel trusses till failure during fire using a modified method of forces is presented. Failure of steel trusses in fire is based on the criterion of stresses. Behaviour of steel is described by non-linear constitutive model (based on hypo-elastic Ramberg-Osgood formula and Dorn creep theory) and Plem proposition (for string). Both models are approximated in calculations by hyperbolic Norton-Bailey rule. Fire simulates thermal force as an action of high temperature that increases linearly up to some level. The complete formulation of this method is illustrated by the algorithm of model parameters identification. Analysis of results for…