Search results for " Crystals"
showing 10 items of 237 documents
Structure and composition heterogeneity of a FeAl alloy prepared by one-step synthesis and consolidation processing and their influence on grain size…
2006
Abstract This paper aims to characterize a bulk dense FeAl (47 at.%) alloy synthesized and consolidated by one-step current-activated pressure-assisted processing of nanocrystalline elemental powders. The end-product was analyzed using a combination of scanning (SEM) and transmission electron microscopies (TEM), electron back-scattering diffraction (EBSD) as well as electron probe microanalysis (EPMA). Special attention was paid to verify the grain size (32–89 nm) previously determined by X-ray diffraction peak profile analysis. It has been found that this material displays equiaxed grains (0.8–4 μm in size) and contains limited structural defects like subgrains and dislocations. The EPMA r…
Towards ductilization of high strength 7XXX aluminium alloys via microstructural modifications obtained by friction stir processing and heat treatmen…
2021
Abstract High strength 7XXX aluminium series reach exceptional strength, higher than all other industrial aluminium alloys. However, they suffer from a lack of ductility compared to softer series. This work presents a procedure to improve the ductility of 7475 Al alloy in high strength condition, reaching a true fracture strain of 70% at full 500 MPa T6 yield strength. Using friction stir processing (FSP) and post-FSP heat treatments, 100% of industrial rolled material T6 yield stress is maintained but a 180% increase in fracture strain is measured for the processed material. This ductility improvement is studied by in-situ synchrotron X-ray tomography and is explained by the reduction of i…
XRD microstructural analysis of mullites obtained from kaolinite–alumina mixtures
2000
Abstract A microstructural study of mullite obtained by the reaction sintering of kaolinite–α–alumina mixtures in the range 1150–1700°C has been performed by using X-ray line profile analyses together with scanning and transmission electron microscopy equipped with microanalysis by energy dispersion (SEM-EDS, TEM-AEM). Two kinds of morphology corresponding to primary (elongated grains) and secondary (equiaxed grains) mullite have been observed. A bimodal crystallite size distribution has been detected through XRD microstructural analysis from 1300°C. The results obtained by this method are compared with SEM/TEM data.
Nanoscale chemistry and atomic-scale microstructure of a bulk Ni3Sn material built using selective laser melting of elemental powder blends
2021
Abstract Cubic specimens of the intermetallic Ni3Sn compound were built using selective laser melting of elemental powder blends. A specimen built at a laser power of 200 W and a scanning speed of 0.5 m/s was determined to have a homogeneous distribution of Ni and Sn on a mesoscopic scale in spite of a 2 at.% Sn deficiency. Characterization of the microstructure using the HAADF-STEM technique reveals a dispersion of ultrafine Ni particles, nanoscale chemical inhomogeneity and the formation of antiphase nanodomains in the matrix of equiaxed Ni3Sn grains. While a mesoscopic homogeneity of the specimen demonstrates a prospect of additive manufacturing of a bulk intermetallic material using sel…
The Role of Zr in the High-Temperature Oxidation of Fe<sub>3</sub>Al
2008
The paper describes an examination of the effect of the addition of zirconium as a third element on the heat-resisting properties and explains the high temperature oxidation mechanism of Fe3Al intermetallic compounds. The Fe3Al and Fe3Al-0,05Zr specimens have been isothermally oxidized in the temperature range of 1173-1473 K in synthetic air for 100 hrs. The formed oxide layer, about 1,5-2 μm thick, was Al2O3. An examination of the cross-sectioned scales by SEM-EDS showed that the alumina layer consisted of a small inner columnar layer and an outer equiaxed grain layer. Additionally, very fine (50-150 nm) oxide grains rich in Zr, further identified as ZrO2, were found across the alumina sca…
2-(N,N-Diethylaminomethyl)-6,7-trihydroquinolinyl-8-ylideneamine-Ni(ii) chlorides: application in ethylene dimerization and trimerization
2020
A series of Ni(II) complexes with the general formula [2-((NEt2)Me)-8-{N(Ar)}C9H8N]NiCl2, where Ar = 2,6-Me2C6H3 in Ni1, 2,6-Et2C6H3 in Ni2, 2,6-i-Pr2C6H3 in Ni3, 2,4,6-Me3C6H2 in Ni4, 2,6-Et2-4-MeC6H2 in Ni5, and 2,4,6-t-Bu3C6H2 in Ni6, has been prepared using a one-pot reaction of 2-(N,N-diethylaminomethyl)-6,7-dihydroquinolin-8(5H)-one with the corresponding aniline and nickel dichloride hexahydrate. The resultant complexes were characterized using elemental analysis and FT-IR spectroscopy, while the mononuclear Ni1 and Ni3 were also the subject of single-crystal X-ray diffraction study. On activation with MMAO, the complexes Ni1–Ni6 displayed good activity in ethylene oligomerization, f…
Template-Based Fabrication of Nanometer-Scaled Actuators from Liquid-Crystalline Elastomers
2010
Spatial Simultons in 2D Photonic Crystals of Nonlinear Origin
2007
We observed for the very first time quadratic spatial solitons (simultons) in a two dimensional photonic lattice defined by periodic sign inversion of its susceptibilty. This is the first demonstration of quadratic self-confinement in a 2D purely nonlinear photonic crystal.
Coherent Control of Stimulated Emission inside one dimensional Photonic Crystals:Strong Coupling regime
2006
The present paper discusses the stimulated emission, in strong coupling regime, of an atom embedded inside a one dimensional (1D) Photonic Band Gap (PBG) cavity which is pumped by two counter-propagating laser beams. Quantum electrodynamics is applied to model the atom-field interaction, by considering the atom as a two level system, the e.m. field as a superposition of normal modes, the coupling in dipole approximation, and the equations of motion in Wigner-Weisskopf and rotating wave approximations. In addition, the Quasi Normal Mode (QNM) approach for an open cavity is adopted, interpreting the local density of states (LDOS) as the local density of probability to excite one QNM of the ca…
SYNTHESIS AND CHARACTERISATION OF NEW AZOLE BUILDING BLOCKS FOR FUNCTIONAL IONIC SYSTEMS
The synthesis of a series of 27 salts based on 5-(4-(alkyloxy)phenyl)-1,4-dimethyl-3-(perfluoroalkyl)-1,2,4-triazol-4-ium structures, differing in the length of the alkyl and perfluoroalkyl chains, as well as in the counter ions is reported. Some properties of this new family of salts as perspective liquid-crystalline ionic liquids (LC-ILs) are described and the influence of the varying moieties in the modulation of the properties is discussed.