Search results for " Emission"

showing 10 items of 1496 documents

Minimum detection limits and applications of proton and helium induced X-ray emission using transition-edge sensor array

2017

Abstract We have determined minimum detection limits, MDLs, for elements 14 ⩽ Z ⩽ 86 using a transition-edge sensor array, TES array, and as a comparison using an Amptek X-123SDD silicon drift detector, SDD. This was done using a 3 MeV proton beam and a 5.1 MeV helium beam. MDLs were determined for a thin film sample on top of C substrate, and for a bulk sample containing mostly Al. Due to the higher peak-to-background ratio, lower detection limits were obtainable using the TES array for most of the elements. However, for elements 30 ⩽ Z ⩽ 45 the performance of the TES array was not as good as the SDD performance. This is due to the limitations of the TES used at energies >10 keV. The great…

helium-induced x-ray emissionNuclear and High Energy PhysicsSilicon drift detectorProtonAnalytical chemistrychemistry.chemical_element02 engineering and technologySubstrate (electronics)01 natural sciencesSensor array0103 physical sciencesPIXEThin film010306 general physicsInstrumentationHeliumPhysicsta114minimum detection limit021001 nanoscience & nanotechnologychemistryTransition edge sensor0210 nano-technologyTESBeam (structure)
researchProduct

An X-ray characterization of the central region of the supernova remnant G332.5-5.6

2015

Aims. We present an X-ray analysis of the central region of supernova remnant (SNR) G332.5-5.6 through an exhaustive analysis of XMM-Netwon observations with complementary infrared observations. We characterize and discuss the origin of the observed X-ray morphology, which presents a peculiar plane edge over the west side of the central region. Methods. The morphology and spectral properties of the X-ray SNR were studied using a single full frame XMM-Netwon observation in the 0.3 to 10.0 keV energy band. Archival infrared WISE observations at 8, 12 and 24 μm were also used to investigate the properties of the source and its surroundings at different wavelengths. Results. The results show th…

individual objects: G332.5-5.6 [ISM]Ciencias AstronómicasISM: individual objects: G332.5-5.6InfraredSupernova remnantsCiencias FísicasAstrophysics::High Energy Astrophysical PhenomenaAstrophysicsAstrophysics::Cosmology and Extragalactic AstrophysicsRadiation//purl.org/becyt/ford/1 [https]Interstellar mediumIonizationX-raysRadiation mechanismsISM [X-rays]Supernova remnantCiencias Exactas y NaturalesAstrophysics::Galaxy AstrophysicsG332.5-5.6 (ISM individual objects)ISM: supernova remnantsPhysicssupernova remnants [ISM]Atomic emission spectroscopyAstronomy and AstrophysicsPlasma//purl.org/becyt/ford/1.3 [https]Thermal mechanismsRadiation mechanisms: thermalX-rays: ISMInterstellar mediumISM: individual objects: G332.5-5.6 ISM: supernova remnants X-rays: ISM radiation mechanisms: thermalAstronomíaWavelengthSpace and Planetary Sciencethermal [Radiation mechanisms]CIENCIAS NATURALES Y EXACTAS
researchProduct

La evolución energética del sector español de baldosas cerámicas

2014

espanolEl presente texto analiza como ha ido evolucionando el consumo y la eficiencia energetica de la industria espanola de baldosas ceramicas durante el siglo XX, y explora las posibilidades que se le plantean en el siglo XXI. Durante el pasado siglo este sector industrial acometio tres transiciones radicales al pasar de los combustibles tradicionales de biomasa a los hidrocarburos liquidos (fueloleo y gasoleo), y posteriormente a los gaseosos, principalmente gas natural. Aunque la informacion que permite evaluar de manera fiable la eficiencia energetica real en las plantas de fabricacion no es facil de obtener, los datos disponibles indican que se ha llegado a una elevada eficiencia con …

industria cerámicaceramic industrybiomasseficiencia energéticaconsumo energéticoWelfare economicsEficiència industrialIndustrial and Manufacturing Engineeringlcsh:TP785-869biomasalcsh:Clay industries. Ceramics. GlassCarbon oxideMechanics of Materialsenergy consumptionPolitical scienceCeràmicaCeramics and Compositesemisiones de dióxido de carbonocarbon dioxide emissionsCeramic industryEnergy sourceenergy efficiency
researchProduct

Determination of selenium, zinc and cadmium in antidandruff shampoos by atomic spectrometry after microwave assisted sample digestion

2000

Microwave assisted pre-treatments for atomic spectrometric determination (inductive coupled plasma-optical emission spectrometry, ICP-OES or flame atomic absorption spectrometry, FAAS) of metallic elements, usually present in antidandruff shampoos, are proposed. They are based on the digestion of the sample with HNO(3) into a closed reactor, which is irradiated at 800 W for a few minutes. Selenium was determined by ICP-OES. The limit of detection was 0.11 mg l(-1); the relative standard deviation (R.S.D.) for the selenium content in the samples was in the 0.6-3.6% range. The results obtained were in agreement with the label contents and the recovery of the proposed method was in the 100-106…

inorganic chemicalsDetection limitCadmiumChromatographyMicrowave ovenAnalytical chemistrychemistry.chemical_elementZincAnalytical Chemistrylaw.inventionchemistryAshinglawInductively coupled plasma atomic emission spectroscopyAtomic absorption spectroscopySeleniumTalanta
researchProduct

Synthesis and preliminary in vivo evaluation of well-dispersed biomimetic nanocrystalline apatites labeled with positron emission tomographic imaging…

2015

In recent years, biomimetic synthetic apatite nanoparticles (AP-NPs), having chemical similarity with the mineral phase of bone, have attracted a great interest in nanomedicine as potential drug carriers. To evaluate the therapeutic perspectives of AP-NPs through the mechanisms of action and organs they interact with, the noninvasive monitoring of their in vivo behavior is of paramount importance. To this aim, here the feasibility to radiolabel AP-NPs ("naked" and surface-modified with citrate to reduce their aggregation) with two positron emission tomographic (PET) imaging agents ([F-18]NaF and Ga-68-NO(2)AP(BP)) was investigated. [F-18]NaF was used for the direct incorporation of the radi…

inorganic chemicalsMalepositron emission tomographyMaterials scienceNanoparticleNanotechnologyPilot ProjectsDiffusionNanocapsulesIn vivoBiomimetic MaterialsApatitesMaterials TestingmedicineAnimalsGeneral Materials ScienceChelationWhole Body ImagingColloidsParticle SizeRats Wistarmedicine.diagnostic_testtechnology industry and agriculturenanomedicinecalcium phosphatesPositron emission tomographyIsotope LabelingPositron-Emission Tomographydrug deliveryDrug deliverySurface modificationNanomedicineFeasibility StudiesNanoparticlesRadiopharmaceuticalsDrug carrierCrystallizationACS applied materialsinterfaces
researchProduct

Low-Intensity Neutron Emission from TiDx Samples Under Nonequilibrium Conditions

2001

Several experiments were performed that loaded titanium samples with deuterium from the gas phase, changed the temperature of the samples over a wide range, and monitored the neutron emission. Neutron emissions in very low intensity bursts, still significantly above the background, were recorded, revealing that low-energy nuclear reactions in condensed matter can be produced at a very low rate, which occasionally can be high enough to become detectable.

inorganic chemicalsNuclear reactionRange (particle radiation)Materials scienceNeutron emissionAstrophysics::High Energy Astrophysical Phenomena020209 energytechnology industry and agricultureGeneral EngineeringAnalytical chemistryfood and beverages02 engineering and technology01 natural sciences010305 fluids & plasmasNuclear physicsNeutron generatorDeuterium0103 physical sciences0202 electrical engineering electronic engineering information engineeringNeutron cross sectionlipids (amino acids peptides and proteins)NeutronNuclear ExperimentIntensity (heat transfer)Fusion Technology
researchProduct

Beta-Decay Half-Lives and Neutron-Emission Probabilities of Very Neutron-Rich Y to Tc Isotopes

1996

Neutron-rich {sub 39}Y to {sub 43}Tc isotopes have been produced by fission of uranium with a 50MeV H{sub 2}{sup +} beam. Beta-decay half-lives, delayed neutron-emission probabilities, and production yields have been measured and compared with theory. Beta decay of 4 new isotopes is reported, and the {beta}-delayed neutron-emission mode has been discovered for 12 isotopes of the elements niobium and technetium. The results compared to quasiparticle random phase approximation predictions indicate the increasing importance of fast {beta} transitions to high-lying states of nuclei with large neutron excess. {copyright} {ital 1996 The American Physical Society.}

inorganic chemicalsPhysicsNUCLEISTABILITYIsotopeFissionNeutron emissionAstrophysics::High Energy Astrophysical PhenomenaNuclear Theorytechnology industry and agriculturePREDICTIONSGeneral Physics and Astronomychemistry.chemical_elementUraniumFISSIONBeta decayYttrium IsotopesNuclear physicschemistryProduction (computer science)NeutronNuclear ExperimentPhysical Review Letters
researchProduct

Search for Neutrons as Evidence of Cold Fusion

1992

In this paper investigations performed at the University of Palermo in an attempt to reproduce the cold fusion experiment are reported. The search was devoted to detecting neutron emission from palladium electrodes electrolytically charged with deuterium. In no test was neutron emission significantly over the background observed, either in bursts or continuous. Results of a few tests are reported. For the more sensitive test, an upper limit for D(d,n) cold fusion (at 98% confidence level) of {lambda}{sub f} {lt} 3.6 {times} 10{sup {minus}24} fusion/s {center dot} d-d pair is determined.

inorganic chemicalsPhysicsNuclear physicsNuclear reactionFusionDeuteriumNeutron emissionGeneral EngineeringCenter (category theory)NeutronSensitivity (control systems)Atomic physicsCold fusionFusion Technology
researchProduct

Nitrous oxide emissions in a membrane bioreactor treating saline wastewater contaminated by hydrocarbons

2016

The joint effect of wastewater salinity and hydrocarbons on nitrous oxide emission was investigated. The membrane bioreactor pilot plant was operated with two phases: i. biomass acclimation by increasing salinity from 10 gNaCl L−1 to 20 gNaCl L−1 (Phase I); ii. hydrocarbons dosing at 20 mg L−1 with a constant salt concentration of 20 gNaCl L−1 (Phase II). The Phase I revealed a relationship between nitrous oxide emissions and salinity. During the end of the Phase I, the activity of nitrifiers started to recover, indicating a partial acclimatization. During the Phase II, the hydrocarbon shock induced a temporary inhibition of the biomass with the suppression of nitrous oxide emissions. The r…

inorganic chemicalsSalinityEnvironmental Engineering0208 environmental biotechnologyBiomassBioengineering02 engineering and technology010501 environmental sciencesSodium ChlorideWastewaterMembrane bioreactor01 natural sciencesWaste Disposal FluidEnvironmental protectionGreenhouse gas emissionchemistry.chemical_compoundBioreactorsBiomassWaste Management and Disposal0105 earth and related environmental scienceschemistry.chemical_classificationNitrous oxideSettore ICAR/03 - Ingegneria Sanitaria-AmbientaleRenewable Energy Sustainability and the EnvironmentChemistryEnvironmental engineeringGeneral MedicineNitrous oxideequipment and suppliesHydrocarbons020801 environmental engineeringSalinity and hydrocarbonSalinityHydrocarbonPilot plantBiodegradation EnvironmentalWastewaterEnvironmental chemistryMembrane bioreactorAerationWater Pollutants ChemicalEnvironmental protection; Greenhouse gas emissions; Membrane bioreactors; Nitrous oxide; Salinity and hydrocarbon; Bioengineering; Environmental Engineering; Waste Management and Disposal
researchProduct

Determination of copper, iron, molybdenum and silicon in hydrometallurgically roasted molybdenite concentrate solution by inductively coupled plasma …

1997

Abstract Inductively coupled plasma atomic emission spectrometry has been applied for the estimation of major constituents in molybdenite concentrate solutions produced by hydrometallurgical alkaline digestion. Copper, iron, molybdenum and silicon were considered as major constituents to be determined. Multiple linear regression was utilized for the control of matrix effects. Using simple acid-based standards, all the elements investigated could be determined with satisfactory results using an appropriate method of calculation.

inorganic chemicalsSiliconAnalytical chemistrychemistry.chemical_elementBiochemistryCopperAnalytical ChemistrychemistryMolybdenumMolybdeniteInductively coupled plasma atomic emission spectroscopyEnvironmental ChemistryInductively coupled plasmaSpectroscopyAtomic emission spectrometryAnalytica Chimica Acta
researchProduct