Search results for " Geology"

A multi-technique characterisation of cronstedtite synthetized by iron-clay interaction in a step by step cooling procedure

2013

International audience; The cooling of steel containers in radioactive-waste storage was simulated in a step-by-step experiment from 90 to 40 degrees C. Among newly formed clay minerals observed in run products, cronstedtite was identified by a number of analytical techniques (powder X-ray diffraction, transmission electron microscopy, and scanning electron microscopy). Cronstedtite has not previously been recognized to be so abundant and so well crystallized in an iron-clay interaction experiment. The supersaturation of experimental solutions with respect to cronstedtite was due to the availability of Fe and Si in solution, as a result of the dissolution of iron metal powder, quartz, and m…

Collapsible intact soil stabilisation using non-aqueous polymeric vehicle

2020

Abstract This paper presents the results of an experimental study that had the goal of understanding the effects of treatment with polyethylene glycol (PEG)/nanolime mixtures on collapsible soil behaviour. In a previous study, the use of pure PEG offered a good improvement in the stability of collapsible soil, but the stabilisation effect only lasted for a limited time. To investigate the stabilisation potential of PEG/nanolime systems for collapsible sand, different mixtures were prepared at increasing nanolime weight ratios. The suitability of the stabilised soil was examined on the basis of collapsibility, oedometer, shear, and water vapour permeability tests, and through optical microsc…

Electrochemical discrimination of manufacturing types of pottery from Magna Mater Temple and Fora of Nerva and Caesar (Rome, Italy)

2018

Abstract The voltammetry of immobilized microparticles (VIMP) methodology is applied to a series of pottery samples from the Roman sites of Nerva's Forum (second half of 9th-early 11th A.D), Caesar's Forum (second half of 9th-early 11th A.D) and Magna Mater Temple (III century). The VIMP sampling applied to voltammetric and electrochemical impedance spectroscopy (EIS) measurements was applied by the first time to acquire archaeometric information on archaeological pottery. VIMP measurements using pressed sample pellets on gold electrodes in contact with air-saturated 0.10 M H2SO4 have permitted to detect voltammetric signals for the reduction/oxidation of Fe and Mn minerals as well as catal…

Coupled hydro-mechanical analysis of compacted bentonite behaviour during hydration

2021

Abstract This study analyses the response of compacted bentonites upon hydration based on a coupled hydro-mechanical elasto-plastic framework. As an alternative to multi-porosity interpretation, the framework was selected based on the experimental evidence of adsorbed water behaviour in bentonites and the volumetric response at saturated states, apparently independent of its initial state. Based on these premises, a water retention model was formulated using an explicit distinction between adsorbed water and free water, enabling the postulation of the water properties and behaviour depending on its state. In order to effectively account for the transition between unsaturated to saturated st…

Effect of Soil Moisture on the Angular Variation of Thermal Infrared Emissivity of Inorganic Soils

2014

Emissivity is influenced by different factors. This study deals with the effect of the soil moisture (SM) content on the zenithal (θ) variation of ratio-to-nadir emissivity (εr), for a wide variety of inorganic bare soils. To retrieve εr, a goniometer assembly was used, together with two identical CIMEL Electronique CE312-2 radiometers working at six spectral bands within 7.7-14.3 μm, performing simultaneous radiance measurements at different combinations of zenith and azimuth angles. The results showed that the effect of SM upon εr(θ) is different depending on the spectral range and textural composition of the sample. Sandy soils showed a decrease of εr(θ) from nadir up to 0.132 for θ ≥ 40…

On the hydro-mechanical behaviour of a lime-treated embankment during wetting and drying cycles

2018

Abstract The paper presents some experimental results obtained on samples extracted from a full-scale embankment obtained by compacting a lime-treated clayey soil. A comprehensive test programme was carried out in order to highlight the improvement of mechanical behaviour induced by lime treatment as well as to assess the durability of the improved material, which may be affected by severe seasonal wetting and drying cycles. Direct shear tests, triaxial compression tests, swelling potential measurement and oedometric tests were performed on samples cured in controlled environmental conditions for at least 18 months. Wetting and drying cycles were applied in a very wide range of suction valu…

Microfocus X-ray computed tomography analysis of corroded glass objects

2009

Abstract Microfocus X-ray computed tomography (µCT) is a useful tool for non-destructive analysis of corroded archaeological glass objects and for monitoring restoration and conservation processes for these materials. This was demonstrated by µCT analysis of artificially corroded laboratory-produced glasses and corroded archaeological glasses retrieved from soil environments. Corrosion layers with a thickness of 20 µm or more can be detected as areas with lower X-ray attenuation values than the non-corroded glass. Features that are revealed by µCT analyses include the degree and patterns of corrosion and the presence of various internal structures in the corrosion layers. The study of resto…

Project duration evaluated using affine arithmetic

2016

A civil engineering work can be performed by organizing the available resources (manpower, equipment and materials) in many different ways. Each different configuration results in a realization time and a cost that a building company has to bear. To produce reliable duration forecasts and money savings, it is essential to take into account all the uncertainties involved in the project operations. Generally, since it is impractical to process numerous uncertain variables - also undefined from a statistical point of view -, traditional probabilistic methods involve application difficulties for complex environments such as construction sites. To properly handle this issue, the authors propose …

Journal of Structural Geology: Student Author of the Year Award for 2013

2014

The effect of observation timescales on the characterisation of extreme Mediterranean precipitation

2018

Abstract. This paper analyses the behaviour of five rainfall indicators (maximum intensity, cumulative rainfall, irregularity, probability of rain and persistence of rain) over different observation timescales ranging from 5 min to 24 h. It covers a large area on the Mediterranean side of the Iberian Peninsula (River Júcar Water Authority, 43 000 km2) on a continuous basis over a period of 14 years (1994–2007). The results show that the behaviour of extreme Mediterranean rainfall is heavily dependent on the observation timescale. There are a number of turning points in the indicator trends which occur on different timescales (1 and 6 h in the case of rain intensity and irregularity, 6 h for…