Search results for " Ingegneri"

showing 10 items of 809 documents

PLLA scaffolds with controlled architecture as potential microenvironment for in vitro tumor model

2019

Abstract The "microenvironment" where a tumor develops plays a fundamental role in determining its progression, the onset of metastasis and, eventually, its resistance to therapies. Tumor cells can be considered more or less invasive depending both on the nature of the cells and on the site where they are located. Commonly adopted laboratory culture protocols for the investigation of tumor cells take usually place on standard two-dimensional supports. However, such cultures do not allow for reproduction of the biophysical properties of the tumor’s microenvironment, thus causing the cells to lose most of their relevant characteristics. In this work MDA-MB 231 breast cancer cells were cultiva…

3D tumor modelPolyestersCellBreast Neoplasms02 engineering and technologyBiologyModels BiologicalMetastasis03 medical and health scienceschemistry.chemical_compoundCell Line TumorTumor MicroenvironmentmedicineHumansViability assayDAPICell adhesion030304 developmental biologySettore ING-IND/24 - Principi Di Ingegneria Chimica0303 health sciencesTissue ScaffoldsSettore ING-IND/34 - Bioingegneria IndustrialeBreast cancer cellCell BiologyGeneral Medicine021001 nanoscience & nanotechnologymedicine.diseaseIn vitroLactic acidStainingmedicine.anatomical_structurechemistryBiophysicsFemaleThermally induced phase separation0210 nano-technologyPoly-L-Lactic acidDevelopmental BiologyTissue and Cell
researchProduct

Nitrous oxide emission from a moving bed membrane biofilm reactor: the effect of the sludge retention time

2016

The aim of the present study was to investigate the nitrous oxide (N2O) emissions from a University of Cape Town (UCT) moving bed membrane bioreactor pilot plant. An experimental campaign was carried out during 60 days with three different sludge retention time (SRT). The pilot plant reactor was provided of funnel shape covers that guaranteed gas accumulation in the headspace. The results highlighted that N2O concentrations significantly increased when the biofilm concentrations increased within the aerobic and anoxic compartments. Furthermore, results have shown an increase of N2O with the decrease of SRT. Moreover, the MBR tank resulted the key emission source (up to 70% of the total N2O …

Activated SludgeSettore ICAR/03 - Ingegneria Sanitaria-AmbientaleNitrous OxideUCTMB-MBRNitrous Oxide; IFAS; UCT; MB-MBR; Activated SludgeIFAS
researchProduct

Aeration tank and secondary clarifier as one system. in "Activated Sludge Separation Problems: Theory, Control Measures, Practical Experieces. Eds. R…

2017

Traditionally the activated sludge process is treated as two stage process. The first stage (aeration basin) is described in terms of biological processes while the description of the second stage concentrates on processes of biomass separation and thickening. The modern approach to the activated sludge process looks at both the biological and the separation stage as one system. The aim of this chapter is to explain the interactions between the two parts of the activated sludge system.

Activated sludge secondary clarification state point analysisSettore ICAR/03 - Ingegneria Sanitaria-Ambientale
researchProduct

Effect of biomass features on oxygen transfer in conventional activated sludge and membrane bioreactor systems

2019

Abstract The aim of the present study was to compare the oxygen transfer efficiency in a conventional activated sludge and a membrane bioreactor system. The oxygen transfer was evaluated by means of the oxygen transfer coefficient and α-factor calculation, under different total suspended solids concentration, extracellular polymeric substances, sludge apparent viscosity and size of the flocs. The oxygen transfer coefficient and α-factor showed an exponential decreasing trend with total suspended solid, with a stronger oxygen transfer coefficient dependence in the conventional activated sludge compared to the membrane bioreactor. It was noted that the oxygen transfer coefficient in the conve…

Aeration efficiency activated sludge properties EPS Membrane Bioreactor Oxygen transferSuspended solidsMembrane reactorSettore ICAR/03 - Ingegneria Sanitaria-AmbientaleRenewable Energy Sustainability and the EnvironmentChemistry020209 energyStrategy and Management05 social scienceschemistry.chemical_element02 engineering and technologyApparent viscosityMembrane bioreactorNitrogenIndustrial and Manufacturing EngineeringEnergy consumptionActivated sludgeExtracellular polymeric substanceChemical engineering050501 criminology0202 electrical engineering electronic engineering information engineering0505 lawGeneral Environmental ScienceTotal suspended solids
researchProduct

Effect of biomass features on oxygen transfer in Conventional Activated Sludge and Membrane BioReactor systems

2018

The present study reports the results on the comparison between the oxygen transfer efficiency in a conventional activated sludge (CAS) and membrane bioreactor (MBR) system. The oxygen transfer was evaluated by means of the oxygen transfer coefficient (kLa)20 and α-factor calculation, under different operating conditions and with different activated sludge features, including total suspended solids (TSS) concentration, extracellular polymeric substances (EPS) content and composition, sludge viscosity and size of the flocs. The (kLa)20 and α-factor showed an exponential decreasing trends with TSS in the CAS and MBR, even if it was noted that the (kLa)20 dependence on TSS was stronger in the …

Aeration CAS EPS MBR Oxygen transferSettore ICAR/03 - Ingegneria Sanitaria-Ambientale
researchProduct

Tuning The Selectivity To Aldehyde Via Ph Regulation In The Photocatalytic Oxidation Of 4-Methoxybenzyl Alcohol And Vanillyl Alcohol By Tio2 Catalysts

2021

Abstract The influence of pH on the photocatalytic partial oxidation of 4-methoxybenzyl alcohol (MBA) and vanillyl alcohol (VA) to their corresponding aldehydes in aqueous suspension under UVA irradiation was investigated by using poorly crystalline home-prepared and crystalline commercial TiO2 (BDH, Merck and Degussa P25) photocatalysts. The results clearly show as tuning pH can strongly impart selectivity and activity to photocatalytic processes which are often quite unselective in aqueous suspensions. It was found that pH effect on reaction rate and product selectivity strongly depended on TiO2 crystallinity and substrate type. In the case of MBA oxidation, photoreactivity and selectivit…

Alcohol02 engineering and technology010501 environmental sciences01 natural sciencesAldehydeGreen synthesis p-Anisaldehyde pH effect Photocatalysis TiO2 VanillinCatalysisVanillyl alcoholchemistry.chemical_compoundChemical Engineering (miscellaneous)Partial oxidationWaste Management and Disposal0105 earth and related environmental scienceschemistry.chemical_classificationSettore ING-IND/24 - Principi Di Ingegneria ChimicaAqueous solutionProcess Chemistry and Technology021001 nanoscience & nanotechnologyPollutioneye diseaseschemistryPhotocatalysissense organsSettore CHIM/07 - Fondamenti Chimici Delle Tecnologie0210 nano-technologySelectivityNuclear chemistry
researchProduct

Effect of Temperature on N2O and NO Emission in a Partial Nitrification SBR Treating Reject Wastewater

2017

Temperature is a very important parameter during nitritation, having a direct effect on ammonia oxidation rate (AOR) and enzymatic activities which relate to both N2O and NO emission. This study aims at investigating the effect of temperature on AOR, N2O and NO production in an enriched ammonia oxidizing bacteria (AOB) sequencing batch reactor (SBR) performing partial nitrification (PN) of synthetic reject wastewater. To achieve that, a SBR was subject to several shifts in temperature (in the range of 30 to 15 °C, 5 °C for each decrease). Cycle studies, which contain two aeration phases, were conducted under each temperature. The results showed that AOR specific exponentially correlates wit…

Ammonia oxidation rate Nitrous oxide Nitric oxide Reject wastewater TemperatureSettore ICAR/03 - Ingegneria Sanitaria-AmbientaleInorganic chemistryNitrous OxideReject WastewaterTemperatureSequencing batch reactorAmmonia-oxidizing bacteriaNitrous oxideNitric Oxideequipment and suppliesPulp and paper industryAmmoniachemistry.chemical_compoundAmmonia Oxidation RatechemistryWastewaterNitrificationNo productionAeration
researchProduct

Anaerobic moving bed biofilm reactor followed by aerobic granular sludge for brewery wastewater treatment

2018

Small and medium breweries discharging to municipal sewers without treatment generate significant loads with typical concentrations reported by Valta et al. (2014) as 2-6 g COD L-1, 25-80 mg TN L-1, 10-50 mg TP L-1, with pH between 4.5 and 12. Treatment of the high-strength wastewater requires specialized low footprint processes, such as aerobic granular sludge (AGS), capable of high-rate degradation, as well as simultaneous nitrogen and phosphorous removal (Wang et al., 2007). The objective of this study was to evaluate the start-up period of AGS receiving brewery wastewater after initial anaerobic pre-treatment.

Anaerobic moving bed biofilm reactorSettore ICAR/03 - Ingegneria Sanitaria-AmbientaleAerobic granular sludge
researchProduct

Home-prepared anatase, rutile, and brookite TiO2 for selective photocatalytic oxidation of 4-methoxybenzyl alcohol in water: reactivity and ATR-FTIR …

2009

5th European Meeting on Solar Chemistry and Photocatalysis -- OCT 04-08, 2008 -- Palermo, ITALY

AnataseSettore ING-IND/24 - Principi Di Ingegneria ChimicaAldehydesCatalystsChemistryBrookiteInorganic chemistryAlcoholSelective photooxidation 4-methoxybenzylalcohol TiO2 ATR-FTIRP-anisaldehydeCatalysischemistry.chemical_compoundOrganic-chemistryGreen routeRutilevisual_artvisual_art.visual_art_mediumPhotocatalysisAqueous suspensionReactivity (chemistry)Partial oxidationSettore CHIM/07 - Fondamenti Chimici Delle TecnologiePhysical and Theoretical Chemistry
researchProduct

Photocatalytic thin films of TiO2 formed by a sol-gel process using titanium tetraisopropoxide as the precursor

2008

Abstract Thin TiO 2 films were prepared with the dip-coating technique by using sols deriving from titanium tetraisopropoxide. TiO 2 films were formed on glass substrates previously covered by a SiO 2 layer obtained from a tetraethylortosilicate sol. The films, after a thermal treatment at 673 K, mainly consisted of TiO 2 anatase. The samples were characterised by X-ray diffraction, UV–Vis spectroscopy, scanning electron microscopy and atomic force microscopy. The photoactivity of the various films was tested by using as probe reaction the photo-oxidation of 2-propanol in gas-solid regime. The photoreactivity results indicated that the TiO 2 films were efficient for degrading 2-propanol und…

AnataseSettore ING-IND/24 - Principi Di Ingegneria ChimicaMaterials sciencebusiness.industryScanning electron microscope2-Propanol photodegradation Dip-coating Structural properties Thin film Titanium dioxideMetals and AlloysSurfaces and InterfacesDip-coatingSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsTitanium oxidechemistry.chemical_compoundOpticsChemical engineeringchemistryTitanium dioxideMaterials ChemistryPhotocatalysisDip-coating Titanium dioxide Thin film 2-propanol Photodegradation Structural propertiesSettore CHIM/07 - Fondamenti Chimici Delle TecnologieThin filmbusinessSol-gel
researchProduct