Search results for " Oxidation"

showing 10 items of 675 documents

Low and very low density lipoprotein composition and resistance to copper-induced oxidation are not notably modified in smokers.

1997

To study whether tobacco use was associated with oxidative phenomena affecting lipoproteins, we estimated susceptibility of LDL and VLDL to an in vitro copper-mediated oxidation, and measured serum autoantibody titers against oxidized LDL in 45 middle-age healthy nonsmokers, 35 smokers and 37 ex-smokers of both sexes, taking into account the detailed lipid composition of the lipoproteins. VLDL from female smokers had higher triglyceride, phospholipid, apolipoprotein E and alpha-tocopherol content and showed a higher rate of copper-induced oxidation in comparison with those from nonsmokers (P < or = 0.05) whereas the relative composition of these particles in saturated, mono- or poly-unsatur…

Apolipoprotein EAdultMalemedicine.medical_specialtyVery low-density lipoproteinAdolescentmedicine.medical_treatmentClinical BiochemistryPhospholipidLipoproteins VLDLBiochemistrychemistry.chemical_compoundInternal medicinemedicineHumansVitamin ELipoprotein oxidationAgedAutoantibodieschemistry.chemical_classificationTriglycerideVitamin EBiochemistry (medical)SmokingProteinsGeneral MedicineMiddle AgedLipidsLipoproteins LDLEndocrinologychemistryBiochemistryLow-density lipoproteinlipids (amino acids peptides and proteins)FemaleOxidation-ReductionCopperPolyunsaturated fatty acidClinica chimica acta; international journal of clinical chemistry
researchProduct

Reactor model for fast reactions in the micro-bubble column and validation

2007

A simple reactor model for predicting conversions in a micro-bubble column is described. It assumes fast reactions so that the gaseous component is readily consumed at the gas-liquid interface. Then, gas-liquid mass transfer becomes determining. As input parameters for the model, the hydrodynamics, specific interfacial area, and mass transport need to be described. Two fast model reactions, the catalytic oxidation of butyraldehyde and the absorption of CO2 in aqueous NaOH, show the applicability of the model but also its limits. The model was used for predicting reaction performance in dependence of operating conditions, in particular to get maximum conversion with the antagonistic paramete…

Aqueous solutionGeneral Chemical EngineeringAnalytical chemistryThermodynamicsGeneral ChemistryResidence time (fluid dynamics)TolueneIndustrial and Manufacturing EngineeringVolumetric flow ratechemistry.chemical_compoundchemistryCatalytic oxidationMass transferPhysics::Chemical PhysicsAbsorption (electromagnetic radiation)ButyraldehydeIndustrial and Engineering Chemistry Research
researchProduct

Chromia on silica and zirconia oxides as recyclable oxidizing system: structural and surface characterization of the active chromium species for oxid…

2004

Chromium oxide samples supported over silica and zirconia were prepared by wet impregnation of the supports with aqueous solution of CrO3. In order to investigate the influence of the preparation method on the chromium dispersion and oxidation state, one sample was prepared by sol-gel technique. The materials were structurally characterized by XRD analysis. The oxidation states of chromium species were investigated by XPS, DRS and TPR/TPO techniques. EPR analyses were also carried out for the sample Cr/SiO2, that due to the low crystalline state exhibits broad XPS signals. In this case, particular attention was paid to the presence of Cr(V) and Cr (III) species and their concentration. The …

Aqueous solutionInorganic chemistrychemistry.chemical_elementGeneral ChemistryRedoxTPR/FPO cycleCatalysisChromiaCatalysisChromiumchemistry.chemical_compoundchemistryOxidation stateBenzyl alcoholOxidizing agentchromium supported oxideXPSbenzyl alcohol oxidation
researchProduct

Chemical heterogeneities in nanometric titanomagnetites prepared by soft chemistry and studied ex situ : evidence for fe-segregation and oxidation ki…

2001

Nanocrystalline Fe-based spinels with composition Fe3-xTixO4 are synthesized using soft chemistry. Two steps are involved:  precipitation in an aqueous solution followed by thermal annealing under a reducing mixture of N2/H2/H2O gases. Fe-segregation is found inside stoichiometric particles when the powders are studied ex situ; they exhibit a strong surface iron enrichment. This heterogeneity is related to kinetic effects linked to the difference of mobility between Fe2+ and Ti4+ cations during the partial oxidation of cations occurring ex situ. Stresses in the grains induced by oxidation govern the oxidation kinetics and lead to an abrupt compositional variation inside each particle. These…

Aqueous solutionMaterials sciencePrecipitation (chemistry)Analytical chemistry02 engineering and technology[SPI.MAT] Engineering Sciences [physics]/Materials010402 general chemistry021001 nanoscience & nanotechnology01 natural sciencesSoft chemistryNanocrystalline material0104 chemical sciencesSurfaces Coatings and Films[SPI.MAT]Engineering Sciences [physics]/MaterialsX-ray photoelectron spectroscopyMaterials ChemistryParticlePartial oxidationPhysical and Theoretical Chemistry0210 nano-technologyStoichiometryComputingMilieux_MISCELLANEOUS
researchProduct

Photocatalytic green synthesis of piperonal in aqueous TiO2 suspension

2014

Abstract Piperonal (heliotropine or 3,4-methylenedioxybenzaldehyde) has been synthesized by oxidizing piperonyl alcohol in aqueous UV-irradiated TiO2 suspensions. This compound was identified by GC–MS chromatography, 1H NMR and melting point determination. The other products of the photoprocess were 1,3-bis(3,4-(methylenedioxy)benzyl) ether (found in traces) and CO2, derived from the parallel pathway of photo-mineralization. Commercial and home-prepared TiO2 samples have been tested and the best selectivity (ca. 35%) was obtained by using the home-prepared ones. The reported green process allows to obtain an added value product (piperonal), upon partial oxidation of a cheap reagent.

Aqueous solutionProcess Chemistry and TechnologyEtherCatalysisMethylenedioxyPiperonalchemistry.chemical_compoundchemistryReagentOxidizing agentOrganic chemistrySettore CHIM/07 - Fondamenti Chimici Delle TecnologiePartial oxidationSelectivityPhotocatalysisGreen synthesisPiperonalTiO2suspensionGeneral Environmental ScienceApplied Catalysis B: Environmental
researchProduct

The influence of ultrasound on the RuI3-catalyzed oxidation of phenol: Catalyst study and experimental design

2009

Abstract The influence of ultrasound at 24 kHz on the heterogeneous aqueous oxidation of phenol over RuI3 with hydrogen peroxide (H2O2) was studied isothermally at 298 K. Effect of ultrasound irradiation on catalytic properties and performance of RuI3 has been studied in details by means of scanning electron microscopy (SEM), X-ray powder diffraction (XRD), dispersion analyzer and a surface analyzer. Turn over frequency of the catalyst was also calculated. In this work, experimental design methodology was applied to optimize the degradation of phenol in aqueous solution, while minimizing an excessive consumption of chemical reagents. The independent variables considered were the catalyst lo…

Aqueous solutionStereochemistryChemistryProcess Chemistry and TechnologyInorganic chemistryHeterogeneous catalysisCatalysisCatalysischemistry.chemical_compoundCatalytic oxidationReagentPhenolLeaching (metallurgy)Hydrogen peroxideGeneral Environmental ScienceApplied Catalysis B: Environmental
researchProduct

Ti(iv)-amino triphenolate complexes as effective catalysts for sulfoxidation

2010

C 3 -symmetric Ti (IV) amino triphenolate complexes efficiently catalyze, without previous activation and in excellent yields, the oxidation of sulfides at room temperature, using both CHP and the more environment friendly aqueous hydrogen peroxide as terminal oxidants, with catalyst loadings down to 0.01%. The Ti(IV) catalysts and the intermediate Ti(IV)-peroxo complexes have been characterized in solution by 1H NMR and ESI-MS techniques and via density functional studies.

Aqueous solutionoxidationChemistryhydrogen peroxideEnvironmentally friendlysulfoxidationCatalysisInorganic Chemistrychemistry.chemical_compoundtitanium complexes; sulfoxidation; hydrogen peroxide; tripodal ligands; c3 symmetry; oxidationProton NMROrganic chemistryFunctional studiestitanium complexesc3 symmetryHydrogen peroxidetripodal ligands
researchProduct

Photocatalytic formation of H2 and value-added chemicals in aqueous glucose (Pt)-TiO2 suspension

2016

Abstract Commercial and home prepared bare and Pt-supported TiO2 samples were used as the photocatalysts for the aqueous photo-conversion of glucose at ambient pressure and temperature. Aerobic and anaerobic conditions were used to study the products of glucose degradation both in the liquid (arabinose, erythrose, gluconic acid, glucaric acid, fructose and formic acid) and gaseous (H2 and CO2) phases. The distribution of these molecules was different in the presence of the various powders, depending on the structural and physico-chemical properties of the materials, and Pt resulted essential for the anaerobic production of H2. The home prepared samples resulted more active than the commerci…

ArabinoseFormic acidInorganic chemistryPartial oxidationEnergy Engineering and Power TechnologyCondensed Matter Physic02 engineering and technology010402 general chemistry01 natural sciencesGlucaric Acidchemistry.chemical_compoundPhotocatalysiTiO2Aqueous solutionRenewable Energy Sustainability and the EnvironmentBrookiteFructose021001 nanoscience & nanotechnologyCondensed Matter Physics0104 chemical sciencesGlucoseFuel TechnologychemistryErythrosevisual_artH2Gluconic acidvisual_art.visual_art_mediumHigh value chemicalSettore CHIM/07 - Fondamenti Chimici Delle Tecnologie0210 nano-technologyInternational Journal of Hydrogen Energy
researchProduct

Sulfur isotope's signal of nanopyrites enclosed in 2.7 Ga stromatolitic organic remains reveal microbial sulfate reduction.

2018

18 pages; International audience; Microbial sulfate reduction (MSR) is thought to have operated very early on Earth and is often invoked to explain the occurrence of sedimentary sulfides in the rock record. Sedimentary sulfides can also form from sulfides produced abiotically during late diagenesis or metamorphism. As both biotic and abiotic processes contribute to the bulk of sedimentary sulfides, tracing back the original microbial signature from the earliest Earth record is challenging. We present in situ sulfur isotope data from nanopyrites occurring in carbonaceous remains lining the domical shape of stromatolite knobs of the 2.7-Gyr-old Tumbiana Formation (Western Australia). The anal…

ArcheanBiogeochemical cycleGeologic Sediments010504 meteorology & atmospheric sciencesIronGeochemistrychemistry.chemical_elementSulfides010502 geochemistry & geophysics01 natural scienceschemistry.chemical_compoundδ34S[SDU.STU.GC]Sciences of the Universe [physics]/Earth Sciences/Geochemistry[ SDV.MP ] Life Sciences [q-bio]/Microbiology and ParasitologySulfur IsotopesMicrobial matAnaerobiosisstromatoliteSulfateEcology Evolution Behavior and Systematics0105 earth and related environmental sciencesGeneral Environmental SciencebiologyChemistrySulfatessulfur biogeochemical cycleWestern Australiabiology.organism_classification[ SDU.STU.GC ] Sciences of the Universe [physics]/Earth Sciences/GeochemistrySulfurDiagenesisTumbiana FormationStromatolite13. Climate actionAnaerobic oxidation of methaneGeneral Earth and Planetary SciencesOxidation-Reductionmicrobial sulfate reduction
researchProduct

Area‐Selective Atomic Layer Deposition on Functionalized Graphene Prepared by Reversible Laser Oxidation

2022

Publisher Copyright: © 2022 The Authors. Advanced Materials Interfaces published by Wiley-VCH GmbH. Area-selective atomic layer deposition (ALD) is a promising “bottom-up” alternative to current nanopatterning techniques. While it has been successfully implemented in traditional microelectronic processes, selective nucleation of ALD on 2D materials has so far remained an unsolved challenge. In this article, a precise control of the selective deposition of ZnO on graphene at low temperatures (<250 °C) is demonstrated. Maskless femtosecond laser writing is used to locally activate predefined surface areas (down to 300 nm) by functionalizing graphene to achieve excellent ALD selectivity (up to…

Area-selective atomic layer depositionnanorakenteetMechanics of Materialstwo-photon oxidationMechanical Engineeringatomic layer depositiongraphenesurface engineeringgrafeeninanotekniikkaatomikerroskasvatusnanopatterningAdvanced Materials Interfaces
researchProduct