Search results for " Soil hydraulic conductivity"

Testing laboratory methods to determine the anisotropy of saturated hydraulic conductivity in a sandy–loam soil

2009

Abstract Anisotropy, a (the log of the ratio of horizontal to vertical conductivity, log 10 ( K h / K v )), of saturated soil hydraulic conductivity, K s , affects transport processes in soil but is not routinely measured, probably because practical and validated methods are lacking. The objective of this investigation was to determine the effects of different constant-head laboratory and sampling procedures on anisotropy of saturated hydraulic conductivity measurements. The sequence of K s measurements was varied (vertical conductivity, K v , first, then horizontal, K h , second and vice versa) for an experimental set-up considering five variables: 1) water ponding type (Mariotte or siphon…

Comparing Beerkan infiltration tests with rainfall simulation experiments for hydraulic characterization of a sandy-loam soil

2017

[EN] Saturated soil hydraulic conductivity, K-s, data collected by ponding infiltrometer methods and usual experimental procedures could be unusable for interpreting field hydrological processes and particularly rainfall infiltration. The K-s values determined by an infiltrometer experiment carried out by applying water at a relatively large distance from the soil surface could however be more appropriate to explain surface runoff generation phenomena during intense rainfall events. In this study, a link between rainfall simulation and ponding infiltrometer experiments was established for a sandy-loam soil. The height of water pouring for the infiltrometer run was chosen, establishing a sim…

Run duration effects on the hydrodynamic properties of a loam soil estimated by steady-state infiltration methods

2020

Steady-state methods for the analysis of single-ring infiltration data are commonly applied. However, the duration of an infiltrometer experiment is often established quite subjectively based on the assumption that in general infiltration stabilizes rather quickly in the field. For a loam soil, the effect of the duration of a beerkan run on sorptivity, S, and saturated hydraulic conductivity, Ks, was tested by using the BEST (Beerkan Estimation of Soil Transfer parameters)-steady method and SSBI (Steady version of the Simplified method based on a Beerkan Infiltration run) method for data analysis. The standard experiment, based on a total of 15 water volumes each establishing an initial pon…

Improvement of BEST (Beerkan Estimation of Soil Transfer parameters) method for soil hydraulic characterization

Interpreting and modeling soil hydrological processes require the determination of the soil hydraulic characteristic curves, i.e. the relationships between volumetric soil water content, pressure head, and hydraulic conductivity. Using traditional methods to determine these properties is expensive and time consuming. Haverkamp et al. (1996) pioneered a specific method for soil hydraulic characterization known as the “Beerkan method”. An improved version of this methodology, called the Beerkan Estimation of Soil Transfer parameters (BEST) procedure, was developed by Lassabatère et al. (2006) to simplify soil hydraulic characterization. BEST considers certain analytic formulae for hydraulic c…

An assessment of the Beerkan method for determining the hydraulic properties of a sandy loam soil

2014

Abstract Establishing the ability of the Beerkan Estimation of Soil Transfer parameters (BEST) procedure to reproduce soil properties is necessary for specific soil types. In this investigation, the BEST predictions for a sandy loam soil were compared with water retention data obtained by a standard laboratory method and with the saturated soil hydraulic conductivity, K s , obtained by both the Wu et al. (1999) method, applied to the BEST infiltration data, and the Simplified Falling Head (SFH) technique. When the original BEST-slope algorithm with the infiltration constants fixed at β = 1.9 and γ = 0.79 was applied, the agreement between the predicted and the measured retention data was sa…

Testing steady-state analysis of single-ring and square pressure infiltrometer data

2016

Testing reliability of the saturated soil hydraulic conductivity, Ks, estimated by applying the steady-state single-ring (SR) model to the quasi steady-state infiltration rates obtained with a single-ring pressure infiltrometer (PI) increases confidence in the estimated Ks values. Determining a means to estimate Ks from infiltration data collected with a square infiltrometer allows the use of sources of different shapes. Using numerically simulated infiltration rates for six homogeneous soils ranging in texture from sand to silty clay loam, this investigation suggested an overall good performance of the SR model, with estimated Ks values differing by not more than 25% from the true values f…

Laboratory testing of Beerkan infiltration experiments for assessing the role of soil sealing on water infiltration

2018

Abstract Soil surface sealing is a major cause of decreased infiltration rates and increased surface runoff and erosion during a rainstorm. The objective of this paper is to quantify the effect of surface sealing on infiltration for 3 layered soils with different textures for the upper layer and investigate the capability of BEST procedure to catch the formation of the seal and related consequences on water infiltration. Rainfall experiments were carried out to induce the formation of the seal. Meanwhile, Beerkan infiltration runs were carried out pouring water at different distances from the soil surface (BEST-H versus BEST-L runs, with a High and Low water pouring heights, respectively) f…

Factors Influencing Point Measurement of Near-surface Saturated Soil Hydraulic Conductivity in a Small Sicilian Basin

2017

Hydraulic conductivity of saturated soil, Ks, controls many hydrological processes. Parameterization of basin hydrological models in terms of Ks is complicated and uncertain owing to the very high spatial variability of this soil property. A small Sicilian basin was intensively sampled by the simplified falling head technique to obtain spatially distributed Ks data, and an attempt to explain their spatial variability on the basis of soil physical characteristics, digital elevation model-derived topographic attributes and land cover was carried out. High Ks values were obtained when clay content was low and both elevation and mean slope were high. Moreover, differences in Ks among land cover…

Estimating saturated soil hydraulic conductivity by the near steady-state phase of a Beerkan infiltration test

2017

Abstract Single-ring infiltration experiments carried out in the field, such as the Beerkan runs, allow easy and inexpensive characterization of soil hydraulic properties, and specifically saturated soil hydraulic conductivity, Ks, by maintaining the functional connection of the sampled soil volume with the surrounding soil. However, a single infiltration experiment is not enough to determine Ks. The simplest way to obtain the necessary additional data is based on the assessment of the soil texture and structure characteristics. In this investigation, a simplified method, named SSBI (Steady version of the Simplified method based on a Beerkan infiltration run), was developed to estimate Ks b…

Testing Soil Encasing Materials for Measuring Hydraulic Conductivity of a Sandy-Loam Soil by the Cube Methods

2008

The Cube Method (CM) and the Modified Cube Method (MCM) were developed for measuring vertical (K v ) and horizontal (K h ) saturated hydraulic conductivity of a single soil sample. By these methods, a cube of soil is carved out in situ and a suitable material is applied to enclose the cube in a tightly fitting casing before moving the sample to the laboratory. Problems may be associated with the use of gypsum, originally used to encase soil. The suitability of molten wax and expandable polyurethane foam to encase a soil cube was tested for a sandy-loam soil. Wax-treated samples yielded lower conductivity results than untreated samples by a maximum factor of 3.7. The observed discrepancies w…