Search results for " Spectroscopy"
showing 10 items of 6851 documents
Methylmercury and inorganic mercury determination in fish by cold vapour generation atomic absorption spectrometry
2000
Abstract Given that organic mercury is more dangerous than the inorganic form and that it is converted into methylmercury by biological methylation, we have studied and optimized a simple method for measuring both organic and inorganic mercury contents in fish, using a spectroscopic vapour generation technique, with a sequential reduction of the digested sample with stannous chloride and sodium tetrahydroborate. Prior to applying the method the sample was subjected to alkaline wet digestion. Due to the matrix interferences calibration curves with matrix addition were needed for mercury determinations. The analytical parameters of the method were: linearity from 10 to 200 ng of Hg in the red…
Arsenic content of Spanish cows' milk determined by dry ashing hydride generation atomic absorption spectrometry.
1994
SummaryThe arsenic content of cows' milk consumed in Spain was determined. A procedure using dry ashing hydride generation atomic absorption spectrometry was developed for the purpose. Experimental conditions for the destruction of organic matter were established and an interference study was carried out. The method developed has a detection limit of 0·1 ng/g, a relative SD of 5%, and a recovery (mean ± CSI) of 100 ± 4%. The accuracy of the method was checked by analysis of a certified sample of IAEA milk powder (mean ± CSI: certified, 4·85 ± 0·32 ng/g; found, 5·04 ± 0·81 ng/g). The proposed procedure was used to analyse cows' milk samples. The extremely low arsenic levels found do not pres…
Determination of sertraline in rat plasma by HPLC and fluorescence detection and its application toin vivopharmacokinetic studies
2012
A simple, rapid, and sensitive HPLC method based on 9H-fluoren-9-ylmethyl chloroformate derivatization for the quantification of sertraline in rat plasma has been developed, requiring a plasma sample of only 0.1 mL, which was deproteinized and derivatized for 5 min in two single steps. The obtained derivative was stable at room temperature and was determined by HPLC using a fluorescence detector. The analytical column was a C(18) column and the mobile phase was acetonitrile and water (80:20, v/v). Calibration curves were linear in the range of 10-500 ng/mL. The limit of detection was approximately 3 ng/mL, and the lower limit of quantification was established at 10 ng/mL. The bias of the me…
A validated and fast procedure for FTIR determination of Cypermethrin and Chlorpyrifos.
2005
Abstract A FTIR methodology has been developed for the simultaneous determination of Cypermethrin and Chlorpyrifos in pesticide commercially available formulations. The method involves the extraction of both active principles with CHCl3 and direct measurement of the peak area values between 1747 and 1737 cm−1 corrected with a baseline defined at 2000 cm−1 for Cypermethrin and peak height values established at 1549 cm−1 corrected using a baseline situated at 1650 cm−1 for Chlorpyrifos. The limits of detection achieved were of the order of 0.7 and 0.4% (w/w), and the relative standard deviation 0.4 and 0.2% for Cypermethrin and Chlorpyrifos, respectively. The developed procedure provided stat…
Direct determination of ethanol and methanol in liquid samples by means of vapor phase-Fourier transform infrared spectroscopy
1997
Abstract A FTIR procedure is proposed for the direct determination of methanol and ethanol in liquid samples, such as alcoholic beverages and eau-de-cologne, based on vapor generation from small injected volumes of untreated samples into a heated Pyrex glass reactor in which, at a temperature of 80°C, ethanol and methanol are volatilized and introduced into a long-path IR gas cell by means of a N2 carrier flow. The IR spectra obtained present two characteristic ethanol bands (1050 and 880 cm−1) and a single characteristic methanol band (1030 cm−1). The measurement of the area of the transient recording obtained for the wavenumber range between 1025–950 and 950–820 cm−1 allows us the determi…
Spark source mass spectrometric assessment of boron and nitrogen concentrations in crystalline gallium arsenide
1999
The residual or doped element concentration [E] in GaAs measured by SSMS is only accurate with respect to the relative sensitivity coefficient RSCE. For a trace element concentration, the RSCE = [E]SSMS/[E]TRUE is set to unity, if no reference material or method is available to approximate the concentration to the true value. For boron a relative sensitivity coefficient of RSCB = 0.94 ± 0.08 was obtained using TI-IDMS as a reference method. RSCN = 1 is used for nitrogen determinations. A boron and nitrogen detection limit of 4.4 × 1013 cm–3 is achieved. SSMS was used as reference method to calibrate the FTIR factor fE = [E] / Iα due to the integrated local vibrational mode absorption Iα of …
Direct FIA—AS determination of potassium and magnesium in cement samples by use of the slurries approach
1992
A direct procedure has been developed for the flame atomic determination of potassium and magnesium in cement samples. A 50-mg sample is dispersed in 25 ml of 0.13M nitric acid; 100 mul of this slurry is injected in a double channel FIA manifold simultaneously with 100 mul of a 10% (w/v) lanthanum solution. This procedure allows the rapid extraction of potassium and magnesium by leaching of the sample; nitric acid is not necessary if only potassium must be determined and the sample can be diluted with only distilled water. Aqueous standards are used. The manifold employed includes a well-stirred mixing chamber, which provides an adequate on-line dilution of the sample, in order to obtain em…
On-line gel permeation chromatography–attenuated total reflectance–Fourier transform infrared determination of lecithin and soybean oil in dietary su…
2007
Gel permeation chromatography (GPC) with attenuated total reflectance-Fourier transform infrared (ATR-FTIR) spectrometry detection has been proposed for the simultaneous determination of lecithin and soybean oil in dietary supplements. The method involves the extraction of analytes with dichloromethane in an ultrasound water bath and the injection of 2 ml of centrifuged and filtered extracts into the system integrated by two Envirogel GPC columns (19 mm x150 mm, 19 mm x 300 mm) coupled on-line. Dichloromethane was used as mobile phase. A method has been developed to select the most appropriated wavenumber to be used for the determination of each considered compound from the calculation of a…
Active alkaline traps to determine acidic-gas ratios in volcanic plumes: Sampling techniques and analytical methods
2014
In situ measurements have been the basis for monitoring volcanic gas emissions for many years and—being complemented by remote sensing techniques—still play an important role to date. Con- cerning in situ techniques for sampling a dilute plume, an increase in accuracy and a reduction of detection limits are still necessary for most gases (e.g., CO2, SO2, HCl, HF, HBr, HI). In this work, the Raschig-Tube tech- nique (RT) is modified and utilized for application on volcanic plumes. The theoretical and experimental absorption properties of the RT and the Drechsel bottle (DB) setups are characterized and both are applied simultaneously to the well-established Filter packs technique (FP) in the …
On-line bi-directional electrostacking for As speciation/preconcentration using electrothermal atomic absorption spectrometry.
2006
A method using bi-directional electrostacking (BDES) in a flow system is presented for As preconcentration and speciation analysis. Some parameters such as electrostacking time and applied voltage, support buffers and their concentrations were investigated. Boric acid plus sodium hydroxide at 0.1mol/l concentration was selected as support buffer to improve the pre-concentration factor (PF) for As(V). An analytical range from 2.0 to 50.0mugl(-1), and 0.35mugl(-1) as limit of detection, when applied 750V for 20min, were achieved. Under these conditions, a pre-concentration factor of 4.8 was obtained. The proposed method was applied to determine As(V) in mineral water and natural water samples…