Search results for " alumina membrane"
showing 10 items of 45 documents
Processo di produzione di filamenti nanometrici in lega amorfa Sn-Co
2008
Fabrication of CIS and CIGS nanowires for application in micro-photovoltaic device
2009
Fabrication and Characterization of Different Nanostructures
2007
Fabrication and characterization of nanostructured materials
2008
Nanostructured anode and cathode materials for Li-ion batteries
2010
Sn-Co nanowire-based anodes for lithium-ion batteries
2010
The demand of improvement in lithium-ion battery technology in terms of specific capacity and safety has stimulated the search for anode materials alternative to graphite. Among them, tin-based materials have been widely studied because tin can intercalate lithium up to atomic ratio Li/Sn of 4.4 to deliver a impressive specific capacity of 993 mAhg−1 (while graphite gives 372 mAhg−1). Unfortunately the high volume change of about 300%, which is related to the insertion/removal of lithium, causes the alloy pulverization and loss of electric contact that causes a poor cycle life. The synthesis of nanometric materials, intermetallic compounds and carbon composites are strategies that have been…
Nanostructured alloys for energy devices
2009
Electrodeposition of lead dioxide nanowires with a high aspect ratio
2008
Nanoporous alumina membranes filled with solid acid for thin film fuel cells at intermediate temperatures
2004
Thin film fuel cells have been fabricated by impregnation of inorganic porous membranes with inorganic proton conductor. Anodic alumina membranes (50 μm thick and pore diameter of 200 nm), filled with CsHSO4 salt have been used as protonic conductor in a hydrogen-oxygen fuel cell working between 423 and 443 K in dry atmosphere. Polarization curves at 433 K showing ohmic control with open circuit values near 0.8 V and short circuit current around 8 mA cm−2 have been obtained. Possible causes of degradation as well as alternative routes to overcome some of the problems encountered with this approach will be reported. Keywords: Solid acid, Anodic alumina membranes, Pore filling, Thin film fuel…
Electrosynthesis of Sn-Co nanowires in alumina membranes
2010
A fabrication process of amorphous nanowires of Sn-Co alloys, based on electrodeposition into anodic alumina membranes, is described. It is shown that nanowires of tin-cobalt alloys with different compositions can be produced by varying electrodeposition time and concentration ratio of salts dissolved into the electrolytic bath. Importance of the chelating agent to produce amorphous Sn-Co alloys has also been addressed. Electrodepositions were carried out potentiostatically at -1 V versus Saturated Calomel Electrode and 60 degrees C for times ranging from 10 to 90 minutes; the atomic fraction of Co2+ in the aqueous electrolyte (Co2+/(Co2+ + Sn2+)) was varied from 0.33 to 0.67. Nanowires asp…