Search results for " cathode"

Optimization of the performance of an air-cathode MFC by changing solid retention time

2017

Structural, Spectroscopic and Electrical Features of Undoped and Mn Doped LiTi2(PO4)3

2010

The study of the ionic conducting material LiTi2(PO 4)3 and of its Mn-substituted derivate reveals that the Mn distribution is strictly related to the synthetic method. The results of the structural refinement of X-ray and neutron (ToF) powder diffraction data and of XPS analysis demonstrate that Mn2+ ions are located on the lithium octahedral site, while Mn3+ and Mn4+ ions occupy the titanium ones. The Mn2+ amount on the lithium site seems to be the main factor responsible for the conductivity decrease observed in doped samples. The EPR spectra evidence clustering effects of Mn on both Li and Ti sites and the presence of more insulated Mn2+ ions. The effect of the major Mn amount on Ti sit…

Spatial distribution of air kerma rate and impact of accelerating voltage on the quality of an ultra soft X-ray beam generated by a cold cathode tube…

2015

Abstract Ultrasoft X-ray characteristic aluminum K alpha line (Al Kα with energy of 1.5 keV) is used in radiobiological experiments to study the effect of radiation on biological matter. A simple method to generate a continuous beam of those X-ray radiations is to bombarding an aluminum target with accelerated electrons using high voltage (HV). In this work, by varying the HV we study the characteristics of a photon beam generated by means of a cold cathode transmission X-ray tube. The anode is a thin (16 μm) aluminum foil supported by a copper grid. The spatial distribution of air kerma is measured using gafchromic films of HD-810 calibrated with a parallel plate free-air ionization chambe…

Electrochemical conversion of carbon dioxide in pressurized electrochemical cells

2019

To limit the negative effect of carbon dioxide as a greenhouse gas, an interesting approach is the utilization of Carbon Capture and Conversion (CCC) methodology, which is focused on the use of CO2 waste as a feedstock to produce added-value products by using the excess electric energy from renewable source [1]. In this framework, an increasing attention has been devoted to the electrochemical conversion of carbon dioxide to formic acid in water [2-3] or CO [1]. Since the main hurdle of the CO2 reduction from aqueous solution is the low CO2 solubility in water, in this work, the utilization of pressurized electrochemical cells is evaluated. The effect of various operating parameters, includ…

Nuovi materiali per celle a combustibile ad ossidi solidi a temperatura intermedia (IT-SOFC): sintesi, caratterizzazione e correlazione struttura-pro…

2014

Photocatalytic and photoelectrocatalytic H2 evolution combined with valuable furfural production

2023

In this work the photocatalytic (PC) and photoelectrocatalytic (PEC) reforming of furfuryl alcohol (FA) under environmental friendly conditions was investigated. Both H2 evolution and partial oxidation to furfuraldehyde were followed. For the first time TiO2 based photocatalysts were studied and the photocatalytic activity of home prepared photocatalysts was compared with that of commercial ones under both UVA and simulated solar irradiation. PEC tests were performed by using home prepared TiO2 nanotubes (TiO2 NTs) as photoanode and Pt free Ni foam as cathode to improve the Hydrogen Evolution Reaction (HER). Both the partial FA oxidation reaction rate and H2 evolution rate were normalized f…

The influence of sludge retention time on mixed culture microbial fuel cell start-ups

2017

Abstract In this work, the start-ups of air-cathode microbial fuel cells (MFCs) seeds with conventional activated sludge cultivated at different solid retention times (SRTs) are compared. A clear influence of the SRT of the inoculum was observed, corresponding to an SRT of 10 days to the higher current density exerted, about 0.2 A m −2 . This observation points out that, in this type of electrochemical device, it is recommended to use high SRT seeds. The work also points out that in order to promote an efficient start-up, it is not only necessary to use high SRT seeds, but also to feed a high COD concentration. When feeding 10,000 ppm COD and keeping SRT of 10 d differences of current densi…

Electrochemical reduction of carbon dioxide to formic acid at a tin cathode in divided and undivided cells: effect of carbon dioxide pressure and oth…

2016

Abstract The reduction of carbon dioxide to formic acid at a tin cathode was studied in both divided and undivided cells. In the first stage of the study, the effect of some operating parameters, including the working potential and the nature of the supporting electrolyte and of the cathode, on both the cathodic reduction of CO2 and the anodic oxidation of formic acid was investigated in a divided cell. In a second stage, the reduction of carbon dioxide was performed in an undivided cell with the aim of studying the effect on the generation of formic acid of various operating parameters such as current density, cathode to anode area ratio, mixing rate and nature of the anode and of the supp…

Novel Configuration for a C-Band Axial Vircator With High Output Power

2022

We present a novel configuration for an axial virtual cathode oscillator (Vircator) operating in the C-band and designed for high output power applications. In order to enhance the efficiency, we have employed a geometry with up to seven reflectors along the drift space. While in previous research works this optimization process has been performed only varying the reflectors radii while using a fixed distance between reflectors,in our work we propose an optimization in terms of both reflectors radii and distances. Our optimized structure for the axial Vircator is able to provide an efficiency up to 15.6% and an output power of 1.6 GW in the C-band, with a working voltage of 510 kV and a cat…

Effect of pressure on the electrochemical generation of hydrogen peroxide in undivided cells on carbon felt electrodes

2017

The electrochemical generation of H2O2can be performed in aqueous solutions by cathodic reduction at carbonaceous cathodes of oxygen coming from air. The performances of the process in terms of concentration of H2O2and current efficiency (CE) are limited by the low solubility of oxygen in water at atmospheric pressure. However, the solubility of oxygen can be increased upon enhancing the air pressure. The effect of pressure on the electrochemical generation of hydrogen peroxide was studied in undivided cells changing the pressure from 0 to 30 relative bar and the current density from 1 to 100 mA cm−2. Simple carbon felt and compact graphite cathodes were first used. A dramatic effect of…