Search results for " clay"

Pyrazole[3,4-d]pyrimidine derivatives loaded into halloysite as potential CDK inhibitors

2021

Uncontrolled cell proliferation is a hallmark of cancer as a result of rapid and deregulated progression through the cell cycle. The inhibition of cyclin-dependent kinases (CDKs) activities is a promising therapeutic strategy to block cell cycle of tumor cells. In this work we reported a new example of nanocomposites based on halloysite nanotubes (HNTs)/pyrazolo[3,4-d]pyrimidine derivatives (Si306 and Si113) as anticancer agents and CDK inhibitors. HNTs/Si306 and HNTs/Si113 nanocomposites were synthesized and characterized. The release kinetics were also investigated. Antitumoral activity was evaluated on three cancer cell lines (HeLa, MDA-MB-231 and HCT116) and the effects on cell cycle ar…

Discussion on “Experimental Deformation of Opalinus Clay at Elevated Temperature and Pressure Conditions: Mechanical Properties and the Influence of …

2021

AbstractThe testing procedure and results on saturated samples of Opalinus Clay in the work of Schuster et al. (Rock Mech Rock Eng https://doi.org/10.1007/s00603-021-02474-3, 2021) were conducted and presented using strain rates two to four orders of magnitudes higher than the rates needed to allow pore pressure equilibrium in the material, both in drained and undrained conditions. This leads to an erroneous estimation of the mechanical properties in saturated conditions. We discuss this aspect in the context of shale testing. We also discuss the effect of drying-induced fissuring on the mechanical properties of geomaterials tested in dry conditions.

Suitability of Illite Based Clays of Latvia for Chemical and Thermal Activation

2014

Materials has been synthesized in the temperature range from 600-800 0C from illite based clays of Latvia under activation of KOH and NaOH solutions (4-6 M). Compressive strength and apparent porosity were measured. The effect of the concentration of KOH and NaOH solutions on the material mechanical properties was investigated by means of infrared spectroscopy (IR). Compressive strength data of the materials showed that via such activation building materials with good quality can be obtained.

One dimensional consolidation of Opalinus Clay from shallow depth

2017

First experimental results on Opalinus Clay from shallow depth (< 30 m depth) are presented and compared to results on cores from Mont Terri Underground Rock Laboratory (~ 300 m depth). Samples were tested in one dimensional condition using an advanced experimental technique. The samples from the two sites show similar properties in terms of geotechnical characterization and one dimensional compressibility/swelling indexes, despite the different source depths.

Traditional knowledge and practice of the Triassic variegated clay from Silesia (Krasiejów), Poland, in human medicine.

2021

AbstractBackgroundKrasiejów clay (in German: Krascheow) became famous following the discovery of numerous fossilised bones of Upper Triassic amphibians and reptiles, which have been extracted from clay deposits since the 1980s. These organic remnants remained in Krasiejów clay due to the large amount of slime deposits and the optimal concentration of basal mineral salts.The main aims of the paper are to determine the historical evolution of the use of clay in Silesia for therapeutic purposes and to provide a summary of the historical uses of Krasiejów clay as a medical treatment, based on the knowledge of the local population.MethodsThe mode of utilisation of Triassic variegated claystone t…

Degradation of Polymer Clay-Nanocomposites: a Novel Approach to Enhancing Service Life Performance

2015

The problem of degradation of polymer-clay nanocomposites was addressed by sdopting a novel clay-stabilisation methodology prior tothe incorporation of the clay for reinforcement

Hydro-mechanical behaviour of shallow Opalinus Clay shale

2019

In Switzerland, Opalinus Clay shale has been selected as the host formation for radioactive waste disposal. The minimum required depth of the repository is related to the long-lasting isolation required for the disposal (1 million years). During this period, possible erosion scenarios affecting the repository need to be analysed. Opalinus Clay from shallow depths (< 70 m) was sourced from a borehole in Northern Switzerland, where the formation was affected by a considerable exhumation process. This work aims to investigate the impact of the mentioned phenomenon on the hydro-mechanical behaviour of Opalinus Clay through one-dimensional consolidation and permeability measurements. Laboratory …

X-ray diffraction line broadening on vibrating dry-milled Two Crows sepiolite

2006

A reference sample of sepiolite and products of its comminution by vibrating dry-milling have been studied using X-ray diffraction (XRD) line-broadening analysis, complementary field emission scanning electron microscopy (FESEM) images and surface area measurements. The apparent crystallite sizes determined via XRD are in agreement with observations on FESEM images. The sepiolite aggregates consist of lath-shaped agglutinations of prisms and pinacoids elongated along [001], each lath including several crystallites in that direction. The surface area magnitudes are in the range of previous experimental measurements of other sepiolites. The results obtained show the effectiveness of vibro-mil…

Synthesis, Characterization, and Study, of New Nanostructured Materials

The use of lightweight expanded clay aggregate (LECA) as sorbent for PAHs removal from water.

2012

Author's version of an article in the journal: Journal of Hazardous Materials. Also available from the publisher at: http://dx.doi.org/10.1016/j.jhazmat.2012.03.038 Lightweight expanded clay aggregate (LECA) has been explored as a sorbent for the removal of PAHs (phenanthrene, fluoranthene and pyrene) from water. The efficacy of LECA as a sorbent for PAHs was assessed using contact time, mass of sorbent and sorption isotherms in a series of batch experiments. Maximum (optimum) sorption was reached at 21 h after which the amount of PAHs sorbed remained almost constant. Batch experiments were conducted by shaking a 100 ml solution mixture of individual PAHs (containing 0.02 mg/L) with LECA. T…