Search results for " mixed oxide"
showing 10 items of 21 documents
Dielectric Properties of Al-Nb Amorphous Mixed Oxides
2013
Submitted by Paula Candeias (paula.candeias@lneg.pt) on 2014-02-25T11:53:22Z No. of bitstreams: 1 ECSJournalSolidStateScienceTechnology_N205.pdf: 205716 bytes, checksum: 7b6ac8703b59f9bc280a9cb4082ee0f2 (MD5) Approved for entry into archive by Paula Candeias (paula.candeias@lneg.pt) on 2014-02-25T11:53:42Z (GMT) No. of bitstreams: 1 ECSJournalSolidStateScienceTechnology_N205.pdf: 205716 bytes, checksum: 7b6ac8703b59f9bc280a9cb4082ee0f2 (MD5) Approved for entry into archive by Paula Candeias (paula.candeias@lneg.pt) on 2014-02-25T11:54:01Z (GMT) No. of bitstreams: 1 ECSJournalSolidStateScienceTechnology_N205.pdf: 205716 bytes, checksum: 7b6ac8703b59f9bc280a9cb4082ee0f2 (MD5) Made available i…
Electrochemical fabrication of metal/oxide/conducting polymer junction
2011
After discovery of conducting polymers and the possibility to modify their electrical properties from insulating to metallic like behavior by doping and a careful choice of the processing conditions, a large amount of research effort has been devoted to the theoretical understanding of their solid state properties as well as to exploit the possible application of conducting polymers in many technological fields including large area organic electronics, polymer photovoltaic cell, and sensors. 1-4 Organic thin film transistors appear very promising devices for the development of low cost, flexible, and disposable plastic electronics. In order to reduce the operating voltage it has been sugges…
Selective propane oxidation over MoVSbO catalysts. On the preparation, characterization and catalytic behavior of M1 phase
2009
Nb-free (SbO)(2)M(20)O(56) catalysts (M = Mo, V) presenting pure M1 phase have been prepared by a post-synthesis treatment with hydrogen peroxide of a heat-treated MoVSbO mixed metal oxide catalyst previously prepared by hydrothermal method. The characterization of catalysts and their results for propane oxidation suggest that the optimization in the preparation of the M1 phase depends strongly on the washing procedure. The optimal removing of Sb species formed during post-synthesis treatment can explain the improvement in the catalytic activity; while the better selectivity to acrylic acid of the catalysts obtained by post-synthesis treatment can be explained by the elimination of M2 phase…
Catalytic performance of CoAlZn and NiAlZn mixed oxides in hydrogen production by bio-ethanol partial oxidation
2013
CoAlZn and NiAlZn mixed oxides were prepared by sol-gel method and tested in partial oxidation of bio-ethanol (POE). At lower temperatures, CoAlZn showed higher ethanol conversion and higher selectivity to H2 and CO than NiAlZn. At higher temperatures, ethanol conversion on both catalysts reached 100%, while selectivity (S) to H2 and CO became higher on NiAlZn. At 750 C, NiAlZn showed S(H2) of 95%, S(CO) of 90%, while for CoAlZn these values were 90% and 83% respectively. Both catalysts were resistant to coking, but the amount of carbon deposits was still lower on NiAlZn. During 50 h on-stream, ethanol conversion and selectivity to H2 and CO on NiAlZn remained unchanged demonstrating stable…
The Effect of Anodizing Bath Composition on the Electronic Properties of Anodic Ta-Nb Mixed Oxides
2022
Anodic oxides were grown to 50 V on Ta-Nb sputtering deposited alloys, with high Nb content, in acetate ions containing an aqueous solution to study the effect of the anodizing bath composition on anodic layers’ dielectric properties. Photoelectrochemical measurements proved the presence of a photocurrent in the band gap of photon energy lower than oxides, due to optical transitions involving localized electronic states as a consequence of acetate ions incorporation. Flat band potential value estimates assessed the insulating nature of the anodic oxides grown in the acetate buffer solution. Differential capacitance measurements showed that the highest capacitance value was measured for the …
Photoelectrochemical Polymerization of 3-4 Ethylene dioxythiophene on Anodic Niobium- Tantalum Mixed Oxides.
2012
Photoelectrochemical Polymerization of 3-4 Ethylenedioxythiophene on High k Niobium-Tantalum Mixed Oxides.
2012
Solid State Properties of Anodic Hf-Nb Mixed Oxides
2016
In last decades, HfO2 and Nb2O5 have been extensively studied due to their many potential applications, from corrosion protection to CMOS (as high-k gate dielectrics) [1-2] and ReRAM technologies [3-4]. For these technological applications compact, uniform and flat oxides are necessary, and a detailed understanding of their physical properties as a function of the fabrication conditions is needful. Scientific community gradually shifted its interest from pure metal oxides to mixed metal oxides trying to exploit the advantages of pure oxides and to suppress their disadvantages. Mixed oxides can be grown on valve metals alloys by anodizing, a simple and low cost electrochemical process for pr…