Search results for " multiple"
showing 10 items of 903 documents
RF-Based Human Activity Recognition: A Non-stationary Channel Model Incorporating the Impact of Phase Distortions
2019
This paper proposes a non-stationary channel model that captures the impact of the time-variant (TV) phase distortion caused by hardware imperfections. The model allows for studying the spectrogram of in-home radio channels influenced by walking activities of the home user under realistic non-stationary propagation conditions. The resolution of the spectrogram is investigated for the von-Mises distribution of the phase distortion. It is shown that high-entropy distributions considerably mask fingerprints of the user activity on the spectrogram of the channel. For an orthogonal frequency-division multiplexing (OFDM) system, a computationally simple method for mitigating the undesired phase r…
SINR analysis of OFDM systems using a geometry-based underwater acoustic channel model
2015
The Doppler effect is caused by the relative movement between the transmitter (Tx) and the receiver (Rx) and/or the surface motion (waves) in underwater acoustic (UWA) communication systems. The inter-channel interference (ICI) caused by the Doppler effect degrades the performance of orthogonal frequency-division multiplexing (OFDM) systems over UWA channels. This paper is devoted to the ICI plus noise analysis of UWA-OFDM systems over a geometry-based channel model for shallow UWA channels. We carry out the exact calculation of the ICI power, ambient noise power, and required transmit power, as well as their effects on the performance of UWA-OFDM systems. The signal-to-interference ratio (…
Multi-level optimization of a fiber transmission system via nonlinearity management
2006
Nonlinearity management is explored as a complete tool to obtain maximum transmission reach in a WDM fiber transmission system, making it possible to optimize multiple system parameters, including optimal dispersion pre-compensation, with fast simulations based on the continuous-wave approximation. © 2006 Optical Society of America.
Joint Usage of Dynamic Sensitivity Control and Time Division Multiple Access in Dense 802.11ax Networks
2016
It is well known that in case of high density deployments, Wi-Fi networks suffer from serious performance impairments due to hid- den and exposed nodes. The problem is explicitly considered by the IEEE 802.11ax developers in order to improve spectrum efficiency. In this pa- per, we propose and evaluate the joint usage of dynamic sensitivity con- trol (DSC) and time division multiple access (TDMA) for improving the spectrum allocation among overlapping 802.11ax BSSs. To validate the solution, apart from simulation, we used a testbed based on the Wireless MAC Processor (WMP), a prototype of a programmable wireless card.
Outage Analysis of Relay-Aided Non-Orthogonal Multiple Access with Partial Relay Selection
2018
Non-Orthogonal multiple access (NOMA) holds promise as a spectrally efficient multiple access scheme for 5G communication networks. This work investigates the performance of NOMA in a dual-hop amplify-and-forward (AF) relaying network, which is subject to Nakagami-$m$ fading. Specifically, we obtain a novel closed-form expression of the outage probability for the near and far users when the partial relay selection (PRS) scheme is used for selecting the best among $N$ intermediate relays. The users are considered to employ selection combining technique in order to combine the relayed and the direct transmission signals for an increased reliability of detection. Then, we evaluate the impact o…
Performance Comparison of Duobinary Modulation Formats for 40 Gb/s Long-Haul WDM Transmissions
2006
With their compact spectrum and high tolerance to residual chromatic dispersion, duobinary formats are attractive for the deployment of 40 Gb/s technology on 10 Gb/s WDM Long-Haul transmission infrastructures. Here, we compare the robustness of various duobinary formats when facing 40 Gb/s transmission impairments.
Multilevel system optimisation via nonlinearity management
2006
Nonlinearity management is explored as a multilevel tool to obtain maximum transmission reach in a WDM system. A technique for the fast calculation of the optimal dispersion pre-compensation in systems with distributed amplification is proposed.
Energy-Efficient Binary Power Control with Bit Error Rate Constraint in MIMO-OFDM Wireless Communication Systems
2012
Motivated by the demand for energy efficiency improvement in mobile communication industry, we explore an idea of optimizing energy efficiency for MIMO-OFDM wireless communication systems while maintaining users' quality of service (QoS) requirement. Based on the binary power control scheme,a power allocation criterion for energy efficiency optimization is derived under the total power constraint. From a bit error rate (BER) point of view, a protection constraint is configured to guarantee the system QoS. With the aim of energy efficiency optimization under QoS guarantee in MIMO-OFDM wireless communication systems, an energy-efficient binary power control with BER constraint (EBPCB) algorith…
Critical analysis of conventional thermoeconomic approaches to the diagnosis of multiple faults in air conditioning units: Capabilities, drawbacks an…
2013
Abstract Faults diagnosis in air conditioning systems is a crucial activity, since malfunctions may induce heavy degradation of performance. Among the available techniques, thermoeconomic diagnosis has played a marginal role due to the difficulties encountered when applying the methodology to refrigeration plants. In this paper a critical analysis on capabilities and limits of thermoeconomic diagnosis is proposed. The reference plant is a 120 kWc air-cooled air conditioning system; a simulator is used to evaluate thermodynamic data under normal and faulty conditions, setting up “virtual experiments” to simulate each fault. Five malfunctions are imposed, either individually or simultaneously…
Implementation and Deployment Evaluation of the DMAMAC Protocol for Wireless Sensor Actuator Networks
2016
Abstract The increased application of wireless technologies including Wireless Sensor Actuator Networks (WSAN) in industry has given rise to a plethora of protocol designs. These designs target metrics ranging from energy efficiency to real-time constraints. Protocol design typically starts with a requirements specification, and continues with analytic and model-based simulation analysis. State-of- the-art network simulators provide extensive physical environment emulation, but still have limitations due to model abstractions. Deployment testing on actual hardware is therefore vital in order to validate implementability and usability in the real environment. The contribution of this article…