Search results for " optimization."
showing 10 items of 2333 documents
A sizing approach for stand-alone hybrid photovoltaic-wind-battery systems: A Sicilian case study
2018
Abstract Solar and wind energy are the two most available renewable energy resources in the world. In this paper, a high-resolution analysis that allows sizing a hybrid photovoltaic-wind turbine-battery banks has been carried out. The analysis aims to minimize the annualized cost of the systems satisfying two reliability constraints. The solution has been obtained numerically by means of an iterative technique. The decision variables are the photovoltaic area, wind turbine radius, and battery capacity. A high-resolution model, based on fuzzy logic inference system, has been developed to evaluate the number of active occupants and the domestic electricity consumption. In order to allow a mor…
Robust control in uncertain multi-inventory systems and consensus problems
2008
Abstract We consider a continuous time linear multi–inventory system with unknown demands bounded within ellipsoids and controls bounded within polytopes. We address the problem of ∈-stabilizing the inventory since this implies some reduction of the inventory costs. The main results are certain conditions under which ∈-stabilizability is possible through a saturated linear state feedback control. The idea of this approach is similar to the consensus problem solution for a network of continuous time dynamic agents, where each agent evolves according to a first order dynamics has bounded control and it is subject to unknown but bounded disturbances. In this context, we derive conditions under…
Thrust Vector Controller Comparison for a Finless Rocket
2023
The paper focuses on comparing applicability, tuning, and performance of different controllers implemented and tested on a finless rocket during its boost phase. The objective was to evaluate the advantages and disadvantages of each controller, such that the most appropriate one would then be developed and implemented in real-time in the finless rocket. The compared controllers were Linear Quadratic Regulator (LQR), Linear Quadratic Gaussian (LQG), and Proportional Integral Derivative (PID). To control the attitude of the rocket, emphasis is given to the Thrust Vector Control (TVC) component (sub-system) through the gimballing of the rocket engine. The launcher is commanded through the cont…
Production technologies in stochastic continuous time models
2011
Abstract Properties of dynamic stochastic general equilibrium models can be revealed by either using numerical solutions or qualitative analysis. Very precise and intuition-building results are obtained by working with models which provide closed-form solutions. Closed-form solutions are known for a large class of models some of which, however, have some undesirable features such as potentially negative output. This paper offers closed-form solutions for models which are just as tractable but do not suffer from these shortcomings.
An affine scaling method using a class of differential barrier functions: primal approach
2020
International audience; In this paper we propose a family of affine scaling interior point algorithms, called galpv4, using a primal approach, based on a large class of differential barrier functions. We show that these algorithms are in fact an extension and generalization of the classical affine scaling algorithm based on the well-known log barrier function. After carrying out a complete convergence analysis, we select some of these algorithms for comparison with the classical affine scaling algorithm, performed with the help of the familiar Netlib test set.
Lead optimization of pyrazolo[1,2-a]-benzo-[1,2,3,4]-tetrazin-3-one nucleus to increase the biological properties as anticancer compounds
Minimum Leading Edge Protection Application Length to Combat Rain-Induced Erosion of Wind Turbine Blades
2021
Leading edge erosion (LEE) repairs of wind turbine blades (WTBs) involve infield application of leading edge protection (LEP) solutions. The industry is currently aiming to use factory based LEP coatings that can applied to the WTBs before they are shipped out for installation. However, one of the main challenges related to these solutions is the choice of a minimum LEP application length to be applied in the spanwise direction of the WTBs. Generally, coating suppliers apply 10–20 m of LEP onto the blades starting from the tip of the blade using the “rule of thumb”, and no studies in the literature exist that stipulate how these LEP lengths can be calculated. In this study, we extend the sc…
Dynamic Ordering of Firewall Rules Using a Novel Swapping Window-based Paradigm
2016
Designing and implementing efficient firewall strategies in the age of the Internet of Things (IoT) is far from trivial. This is because, as time proceeds, an increasing number of devices will be connected, accessed and controlled on the Internet. Additionally, an ever-increasingly amount of sensitive information will be stored on various networks. A good and effi- cient firewall strategy will attempt to secure this information, and to also manage the large amount of inevitable network traffic that these devices create. The goal of this paper is to propose a framework for designing optimized firewalls for the IoT. This paper deals with two fundamental challenges/problems encountered in such…
Explicit Algorithms for a New Time Dependent Model Based on Level Set Motion for Nonlinear Deblurring and Noise Removal
2000
In this paper we formulate a time dependent model to approximate the solution to the nonlinear total variation optimization problem for deblurring and noise removal introduced by Rudin and Osher [ Total variation based image restoration with free local constraints, in Proceedings IEEE Internat. Conf. Imag. Proc., IEEE Press, Piscataway, NJ, (1994), pp. 31--35] and Rudin, Osher, and Fatemi [ Phys. D, 60 (1992), pp. 259--268], respectively. Our model is based on level set motion whose steady state is quickly reached by means of an explicit procedure based on Roe's scheme [ J. Comput. Phys., 43 (1981), pp. 357--372], used in fluid dynamics. We show numerical evidence of the speed of resolution…
The minimal cost maximum matching of a graph (supplementary remarks)
1971
In addition to the preceding paper, it will be shown that (1) the matching problem is closely related to the linear assignment problem and how (2) this property can be taken advantage of for solving the matching problem.