Search results for " soil hydraulic conductivity"
showing 4 items of 24 documents
Source shape and data analysis procedure effects on hydraulic conductivity of a sandy-loam soil determined by ponding infiltration runs
2017
Performing ponding infiltration runs with non-circular sources could represent a good means to sample completely an area of interest. Regardless of the shape of the source, predicting the expected reliability of the collected data by infiltrometers should facilitate soil hydraulic characterisation and also allow a more conscious use of the field data. The influence of the shape of the infiltration source (i.e., circular or square) and the analysis procedure of the steady-state infiltration data on the saturated hydraulic conductivity, Ks, of a sandy-loam soil was tested in this investigation. Circular and square surfaces sampled with the pressure infiltrometer (PI) yielded similar estimates…
Variability of near-surface saturated hydraulic conductivity for the clay soils of a small Sicilian basin
2019
Abstract Proper characterization of saturated hydraulic conductivity, Ks, of clay soils in a hillslope or a basin is still a challenge for soil science. In this investigation, the clay soils of the Maganoce (Sicily, Italy) basin were sampled at 19 sampling sites by the BEST procedure of soil hydraulic characterization. More OM implied less compact conditions (decreasing dry soil bulk density; coefficient of determination, R2 = 0.67), more stability to water of the soil aggregates (increasing water stable aggregates; R2 = 0.83) and, consequently, higher Ks values (R2 = 0.54). Variability of Ks was lower in the steeper zones of the basin than in the flatter ones. A comparison with the Ks data…
A comparison between the single ring pressure infiltrometer and simplified falling head techniques
2013
Testing the relative performances of the single ring pressure infiltrometer (PI) and simplified falling head (SFH) techniques to determine the field saturated soil hydraulic conductivity, Kfs, at the near point scale may help to better establish the usability of these techniques for interpreting and simulating hydrological processes. A sampling of 10 Sicilian sites showed that the measured Kfs was generally higher with the SFH technique than the PI one, with statistically significant differences by a factor varying from 3 to 192, depending on the site. A short experiment with the SFH technique yielded higher Kfs values because a longer experiment with the PI probably promoted short-term swe…
Accuracy of Saturated Soil Hydraulic Conductivity Estimated from Numerically Simulated Single‐Ring Infiltrations
2019
The single-ring pressure infiltrometer (PI) method is widely used to determine saturated soil hydraulic conductivity, K s , directly in the field. The original and still most common way to analyze the data makes use of the steady-state model developed by the Canadian School in the 90s and two (two-ponding-depth, TPD, approach) or more (multiple-ponding-depth, MPD, approach) depths of ponding. The so-called Wu method based on a generalized infiltration equation allows analysis of the transient infiltration data collected by establishing a single ponding depth of water on the infiltration surface. This investigation, making use of simulated infiltration runs for initially unsaturated sand to …