Search results for " surface"

<title>Fibers supporting super-Gaussian beams: cladding effects</title>

1996

We define a matching function that describes the amplitude variations produced over supergaussian beams, by cladding optical fibers that, if uncladded, can sustain this type of beams as Eigenmodes.

STOP 13: Inland dune field near Daugavpils, East-Latvian Lowland

2014

Influence of initial treatments of aluminium on the morphological features of electrochemically formed alumina membranes

2003

Abstract The fabrication of alumina membranes by electrochemical oxidation of annealed aluminium was investigated. Porous layers were grown in 0.4 M H3PO4 at −1 and 5 °C at different anodising times. The morphology of the outer surface was found to be dependent on temperature and charge density, with both determining the extent of chemical dissolution of the anodic oxide. The inner-surface morphology was found to depend on the applied voltage only. The chemical dissolution rate of anodic oxide grown on annealed aluminium was found to be lower than that formed on unannealed aluminium under otherwise identical conditions. Such a difference in behaviour is explained in terms of a higher finish…

The Effect of Electronic Properties of Anodized and Hard Anodized Ti and Ti6Al4V on Their Reactivity in Simulated Body Fluid

2022

The electronic properties of barrier and porous layers on Ti and Ti6Al4V were studied. Barrier anodic oxides grown to 40 V on Ti and on Ti6Al4V are both n-type semiconductors with a band gap of 3.3 eV and 3.4 eV respectively, in agreement with the formation of amorphous TiO2. Anodizing to 200 V at 20 mA cm−2 in calcium acetate and β-glycerol phosphate disodium pentahydrate leads to the formation of Ca and P containing porous films with a photoelectrochemical behaviour dependent on the metallic substrate. A band gap of 3.2 eV and the flat band potential of −0.5 V vs Ag/AgCl were measured for the porous oxide on Ti, while optical transitions at 2.15 eV and a significantly more positive flat b…

Influence of mass transport on the competition between corrosion of aluminium alloy surface and the release of primer containing inhibitors : validat…

2014

The conventional aircraft paint scheme for corrosion protection of aluminum structures is partly based on application of a primer containing inhibitors. In such coatings, release of the inhibiting species enables fast healing of a bare metal surface after a mechanical damage of the protective layers. Nevertheless, considering possible depletion of inhibitors by uncontrolled leaching, it appears important to estimate the corrosion risk integrating “corrosion” sensors in the structure. The objective of this work was to understand the operating mode of a sensor simulating a damaged paint coating whose concept is based on the competition between the triggering of localized corrosion and the pas…

On the formation of inclusion complexes at the solid/liquid interface of anchored temperature-responsive PNIPAAM diblock copolymers with γ-cyclodextr…

2017

The thermal responsive behavior of adsorbed layers of diblock copolymers of poly(N-isopropylacrylamide) (PNIPAAM) and poly((3-acrylamidopropyl)trimethylammonium chloride) (PAMPTMA(+)) with γ-cyclodextrin (γ-CD) at the solid/liquid interface has been investigated using three in situ techniques: null ellipsometry, quartz–crystal microbalance with dissipation monitoring, and neutron reflectometry. The measurements provided information about the adsorbed amounts, the layer thickness, hydration and viscoelastic properties, and the interfacial structure and composition. The copolymers adsorb to silica with the cationic PAMPTMA(+) blocks sitting as anchors in a flat conformation and the PNIPAAM ch…

Nontemplate Synthesis of CH3NH3PbBr3 Perovskite Nanoparticles

2014

To date, there is no example in the literature of free, nanometer-sized, organolead halide CH3NH3PbBr3 perovskites. We report here the preparation of 6 nm-sized nanoparticles of this type by a simple and fast method based on the use of an ammonium bromide with a medium-sized chain that keeps the nanoparticles dispersed in a wide range of organic solvents. These nanoparticles can be maintained stable in the solid state as well as in concentrated solutions for more than three months, without requiring a mesoporous material. This makes it possible to prepare homogeneous thin films of these nanoparticles by spin-coating on a quartz substrate. Both the colloidal solution and the thin film emit l…

How self-assembly of amphiphilic molecules can generate complexity in the nanoscale

2015

Abstract Given the importance of nanomaterials and nanostructures in modern technology, in the past decades much effort has been directed to set up efficient bottom up protocols for the piloted self-assembly of molecules. However, molecules are generally disinclined to adopt the desired structural organization because they behave according to their own specific intermolecular interactions. Thus, only some selected classes of chemical compounds are capable to lead to useful self-assembled structures. Amphiphiles, simultaneously possessing polar and apolar moieties within their molecular architecture, can give a wide scenario of possible intermolecular interactions: polar–polar, polar–apolar,…

Optical gain, spontaneous and stimulated emission of surface plasmon polaritons in confined plasmonic waveguide

2010

International audience; We develop a theoretical model to compute the local density of states in a confined plasmonic waveguide. Based on this model, we derive a simple formula with a clear physical interpretation for the lifetime modification of emitters embedded in the waveguide. The gain distribution within the active medium is then computed following the formalism developed in a recent work [Phys. Rev. B 78, 161401 (2008)], by taking rigorously into account the pump irradiance and emitters lifetime modifications in the system. We finally apply this formalism to describe gain–assisted propagation in a dielectric–loaded surface plasmon polariton waveguide.

Polysorbate 80 controls Morphology, structure and stability of human insulin Amyloid-Like spherulites

2022

AbstractAmyloid protein aggregates are not only associated with neurodegenerative diseases and may also occur as unwanted by-products in protein-based therapeutics. Surfactants are often employed to stabilize protein formulations and reduce the risk of aggregation. However, surfactants alter protein-protein interactions and may thus modulate the physicochemical characteristics of any aggregates formed. Human insulin aggregation was induced at low pH in the presence of varying concentrations of the surfactant polysorbate 80. Various spectroscopic and imaging methods were used to study the aggregation kinetics, as well as structure and morphology of the formed aggregates. Molecular dynamics s…