Search results for " thermal analysis"

Production and properties of doped PSN electro-optical ceramics

1997

Due to multifunctionality the transparent ferroelectric ceramics is attractive to solid state chemistry and physics as a promising material for active electro-optic elements. To study doping effects on the technological processing and properties, ceramic samples of Pb1-xZxSc1/2Nb1/2O3, have been prepared, where Z: (1) Ba (0 less than or equal to x less than or equal to 1), (2) rare-earth elements: Ce, Pr, Nd, Sm, Eu, Gd, Tb, Dy, Ho, Er, Tm, Yb, Lu (x equals 0.1), (3) PbSc1/2Nb1/2O3 doped with 5 wt.% of rare-earth oxides. Ceramic characteristics, dielectric and electro-optical parameters have been measured. Differential thermal analysis (DTA), and x-ray diffraction are used to study the infl…

Pyrolysis study of sol-gel derived TiO2powders

2004

An amorphous TiO2 gel was obtained by hydrolysing titanium(IV) isopropoxide with a stoichiometric amount of water using SnCl2 as catalyst. In these operative conditions, a TiO2 gel matrix containing a lower fraction of organic residual was obtained with respect to samples prepared by previously modifying the titanium alkoxide precursor with chelating ligands. Dried gel powders were characterized by N2 adsorption analyses, FT-IR and XRD measurements. Thermogravimetric (TG) and differential thermal analysis (DTA) coupled with mass spectrometric (MS) and gas chromatographic (GC) measurements were performed in order to identify the organic products released from TiO2 gel pyrolysis. The Tg-MS se…

Influence of the Preparation Temperature on the Photocatalytic Activity of 3D-Ordered Macroporous Anatase Formed with an Opal Polymer Template

2018

Even if many aspects of three-dimensionally ordered macroporous (3DOM) titania have been extensively studied, the interplay between the amorphous and crystalline components of their skeleton wall has not attracted too much attention, although it should strongly influence the properties of these materials. In order to gain new insight on this interplay, we have studied in detail the wall structure of three 3DOM titania samples prepared by heating the 3DOM titania precursor at 673, 773, and 873 K by X-ray diffraction, thermogravimetric analysis, differential thermal analysis, N2 adsorption/desorption, pore-size distribution, high-resolution transmission electron microscopy, and IHmagic-angle-…

Preparation and characterization of gels with garnet structure: A3B2C3O12, using ‘non-classical’ solvents

1992

Abstract Synthesis and characterization of some crystalline garnets by sol-gel techniques is described. The effects of emthanol, dimethyl sulfoxide (DMSO), CH2Cl2 and toluene solvents on gelation of TEOS are considered. Multicomponent gel formation in systems with stoichiometries 3CaO·Cr2O3·3SiO2 and 3CaO·Al2O2 was studied using DMSO, a polar solvent, and toluene, an apolar solvent. The dried gel was thermally treated and the powder was characterized by X-ray diffraction, differential thermal analysis/thermogravimetric analysis and scanning electron microscopy.

A new eco-friendly chemical treatment of natural fibres: Effect of sodium bicarbonate on properties of sisal fibre and its epoxy composites

2016

Abstract Several researchers have shown how sisal fibres possess remarkable tensile properties that yield them good candidates as reinforcement in biocomposite materials. This work aims to evaluate the effect of an eco-friendly and cost effective surface treatment method based on the use of commercial sodium bicarbonate (i.e. baking soda) on properties of sisal fibre and its epoxy composites. In particular, raw sisal fibres were treated with a 10%w/w of sodium bicarbonate solution for different periods (24, 120 and 240 h), at room temperature. Changes occurring in sisal fibres were characterized through scanning electron microscope, Fourier transform infrared spectroscopy, thermogravimetric…

Synthesis and characterization of α-hopeite, Zn3(PO4)2·4H2O

1999

Orthorhombic α-Zn3(PO4)2·4H2O, α-hopeite, was synthesized from an aqueous solution of zinc acetate and orthophosphoric acid. The synthesis from these starting materials yielded best results with respect to purity and crystallinity. Structural characteristics of the compound were investigated by X-ray diffraction (XRD), Fourier transform infrared (FT-IR), scanning electron microscopy (SEM), and thermogravimetric/differential thermal analysis (TG/DTA). Supplemental data came from surface area, particle size distribution, and density measurements. The obtained compound proved to be highly crystalline and stoichiometric. Dehydration of α-hopeite is accompanied by at least two endothermic effect…

Effect of some additives on the reactions in fly ASH-Ca(OH)2system

2004

Differential thermal analysis and thermogravimetry were used to evaluate the effect of some additives, such as CaSO4, CaCl2 and silica fume amorphous silica from ferrosilicon synthesis on the mechanism and kinetics of reactions occurring in fly ash-Ca(OH)2 system. The accelerating role of these additives was demonstrated from the data relating to Ca(OH)2 consumption in hydrated pastes, determined by TG measurements.

Preparation, thermal analysis and photoactivity of TiO2 samples

2012

Thermal Evolution of Titania Nanostructured Powders Obtained from Reverse Micelle Method

2012

DSC Studies and Stability of Frozen Foods

1991

This paper discusses the role played by the “WLF decrease in viscosity” above the temperature of the glass transition (Tg) in the temperature dependence of the stability of frozen foods. In the first part, the complex features observed before the melting endotherm on DSC/DTA thermograms of sugar-water solutions are examined; they are suggested to be representative of a glass transition associated with enthalpy relaxation. In the second part, the values of Tg for some complex foods are discussed. It is shown that ice melting adds an important contribution to the WLF effect on the decrease of the viscosity of the freeze-concentrated phase. The temperature dependence of the deterioration proce…