Search results for " transition"
showing 10 items of 2751 documents
Diffusion of spherical micronetworks in polymer diluent systems and melts studied by dynamic light scattering techniques
1994
Spherical polystyrene (PS) micronetworks can be prepared in microemulsion with bulk radii of 5–60 nm and different cross-linking densities. The diffusion of these PS spheres has been studied in polymer diluent systems ranging from dilute solutions to plasticized melts by using forced Rayleigh scattering and photon correlation spectroscopy. On increasing the PS concentration, a colloid glass transition is observed at a volume fraction ΦC ≈ 0.64 of the swollen spheres. At higher concentration inside the “colloid glass” state the sphere diffusion is slowed down and becomes very complex but can be observed up to the limit of a melt of collapsed spheres.
Effect of cooling rate on the viscoelastic properties in the plastic zone of solid polymers
1979
PMMA and PC samples were subjected to several cooling rates from the glass transition temperature.
Extension of the Concept of Intrinsic Viscosities to Arbitrary Polymer Concentration: From [η] via {η} to Intrinsic Bulkiness
2019
The capabilities of an alternative definition of intrinsic viscosities [η] published some years ago is being studied by means of comprehensive viscometric data reported in the early days of polymer science. It introduces the generalized intrinsic viscosity {η} as the specific hydrodynamic volume at arbitrary polymer concentration c. {η} quantifies the size of the flow unit and decreases monotonously for T ≫ Tg (glass transition temperature) as a function of c but passes a pronounced minimum as T approaches Tg. In the limit of the pure polymer melt, {η} becomes ; this newly introduced property is termed intrinsic bulkiness, by analogy to the intrinsic viscosity, and provides noncalorimetric …
The glass transition behaviour of salted nylon 6
1981
Glass transition measurements of nylon-6/lithium halides mixtures have been carried out in wide range of frequency with the aid of different experimental techniques. The results show an increase of the glass transition temperature when the salt is present and prove the larger effectiveness of lithium chloride with respect of lithium bromide. This effect, in line with the large reduction of the specific volume caused by the salt, is due to the formation of a pseudo-cross-linking between lithium ions and the carbonyl-oxygen groups of the polyamide.
Molecular Mobility in Oriented and Unoriented Membranes Based on Poly[2-(Aziridin-1-yl)ethanol]
2021
Unoriented and oriented membranes based on dendronized polymers and copolymers obtained by chemical modification of poly[2-(aziridin-1-yl) ethanol] (PAZE) with the dendron 3,4,5-tris[4-(n-dodecan-1-yloxy)benzyloxy]benzoate were considered. DSC, XRD, CP-MAS NMR and DETA, contribute to characterize the tendency to crystallize, the molecular mobility of the benzyloxy substituent, the dendritic liquid crystalline group and the clearing transition. The orientation of the mesogenic chain somewhat hindered this molecular motion, especially in the full substituted PAZE. The fragility, free volume and thermal expansion coefficients of these membranes near the glass transition are related to the orie…
The effect of macromolecular architecture of ethylene copolymers with multi-alkenylsilsesquioxane on morphological, rheological and dynamic mechanica…
2021
Abstract The influence of the degree and the way of incorporation of multi-alkenylsilsesquioxane into the polymer chain on morphological, rheological and dynamic mechanical parameters were determined. It was found that POSS incorporated into the polymer chain was located outside the crystalline structure of lamella in amorphous phase. The incorporation of POSS-6-2 as a pendant group resulted in significant increase of separation of macromolecules. The key factor in rheological and dynamic mechanical behavior of copolymers turned out to be the way of POSS incorporation into the polymer chain. The incorporation of POSS into the polymer chain as a pendant group resulted in decreased relaxation…
The glass transition in polymer melts
1994
This paper presents some results of a Monte Carlo simulation for the glass transition in two- and three-dimensional polymer melts. The melt was simulated by the bond-fluctuation model on a d-dimensional cubic lattice which was combined with a two-level hamiltonian favouring long bonds in order to generate a competition between the energetic and topological constraints in the system. This competition prevents crystallization and makes the melt freeze in an amorphous structure as soon as the internal relaxation times match the observation time of the simulation set by the cooling rate. The freezing point of the melt, i.e the glass transition temperature Tg, thus depends upon the cooling rate …
Novel Amphiphilic Styrene-Based Block Copolymers for Induced Surface Reconstruction
2008
This paper describes the synthesis of amphiphilic block copolymers by living radical polymerization (NMP) of new styrene-like monomers. The polar monomers (ethylene oxide side chains and free hydroxyl- or amino-groups after deprotection) were polymerized in a “protected form” to adjust the solubility of the monomers. In this way high molar mass polymers with a narrow polydispersity (around or below 1.2) were accessible. In the bulk state hydrophobic and hydrophilic domains demix. By exposing thin films of these polymers to vacuum (air) or alternatively to water or a hydrophilic surface it becomes possible to switch the surface polarity reversibly between contact angles of about 105° and 83°…
Mechanical relaxation in miscible polymer systems: the glass transition regime in poly(vinylmethylether) (PVME)-cross-polystyrene (PS) semi-interpene…
1990
Abstract Miscible semi-interpenetrating polymer networks (semi-IPN) of varying composition are prepared by crosslinking polystyrene containing few maleic anhydride groups with a diamine in the presence of linear poly(vinylmethylether) (PVME). The resulting PVME-c-P(ScoMA) semi-IPNs are characterized by their thermal and thermomechanical behaviour. Comparison with the corresponding uncrosslinked material proves that weak crosslinking has a negligible effect on the location of the glass transition as measured by d.s.c. Both the Tg data and the temperatures of the loss modulus maximum E″ (at 1 rad/s) show the same non-linear curved composition dependence. Contrary to this the tan δ maximum var…
Excess viscosity and glass transition
2001
Abstract Literature data on the viscosity of solutions of poly(butyl methacrylate) (PBMA) and poly(methyl methacrylate) (PMMA) in diethyl phthalate (DEP) for different temperatures, including the range around and below T g , the glass transition temperatures of the pure polymers, were evaluated by means of an approach that uses surface fractions as composition variables. The discussion of these results together with information on solutions of the isomeric polymers, poly(vinyl acetate) (PVAc) and poly(methyl acrylate) (PM(A)), in the same solvent testifies that the previously published relations remain valid for T T g . They enable the determination of viscosities of the pure polymers below…