Search results for "0204 chemical engineering"
showing 10 items of 273 documents
Numerical investigation of slag formation in an entrained-flow gasifier
2018
Photoelectrochemical removal of chlorfenvinphos by using WO3 nanorods: Influence of annealing temperature and operation pH
2019
[EN] A visible-light driven photoelectrochemical degradation process has been applied to a solution polluted with the organophosphate insecticide chlorfenvinphos. Different WO3 nanosheets/nanorods have been used as photoanodes. These nanostructured electrodes have been fabricated by anodization of tungsten and, subsequently, they have been subjected to a thermal treatment (annealing). The combined influence of annealing temperature (400¿°C and 600¿°C) and operation pH (1 and 3) on the photoelectrocatalytic behavior of these nanorods has been examined through a statistical analysis. Morphological, structural and photoelectrochemical characterizations have also been carried out. The chlorfenv…
A scalable three-dimensional porous λ-MnO2/rGO/Ca-alginate composite electroactive film with potential-responsive ion-pumping effect for selective re…
2021
Abstract A scalable three-dimensional (3D) porous composite electroactive film consisting of λ-MnO2, reduced graphene oxide (rGO) and calcium alginate (Ca-alg) was successfully fabricated and employed for the selective extraction of Li+ ions with low concentration via an electrochemically switched ion exchange (ESIX) technology. The Li+ ion adsorption capacity of the obtained λ-MnO2/rGO/Ca-alg composite electroactive film reached as high as 32.7 mg g−1 and more than 90% of its equilibrium adsorption capacity was achieved in 1 h. The λ-MnO2/rGO/Ca-alg composite electroactive film displayed evident selectivity towards Li+ ions. The separation factors for Li+/Na+ and Li+/Mg2+ reached 1040.57 a…
Reduction of oxygen to H2O2 at carbon felt cathode in undivided cells. Effect of the ratio between the anode and the cathode surfaces and of other op…
2019
Abstract In the last years, the electrochemical conversion of oxygen to hydrogen peroxide at carbon felt has been largely studied in order to define a new route for the production of H2O2 and to optimize the electro-Fenton process, which is based on the cathodic generation of H2O2. In particular, many studies regarding electro-Fenton process were carried out in undivided cells in order to avoid the costs of the separator and to reduce the cell potentials. Hence, in order to optimize the cathodic conversion of oxygen to H2O2 in undivided cells, the effect of many parameters linked to the anodic process were here evaluated. In particular, it was demonstrated that the performances of the proce…
PBI mixed matrix hollow fiber membrane: Influence of ZIF-8 filler over H2/CO2 separation performance at high temperature and pressure
2020
High performance and commercially attractive mixed-matrix membranes were developed for H2/CO2 separation via a scalable hollow fiber spinning process. Thin (~300 nm) and defect-free selective layers were successfully created with a uniform distribution of the nanosized (~60 nm) zeolitic-imidazole framework (ZIF-8) filler within the polymer (polybenzimidazole, PBI) matrix. These membranes were able to operate at high temperature (150 °C) and pressure (up to 30 bar) process conditions required in treatment of pre-combustion and syngas process gas streams. Compared with neat PBI hollow fibers, filler incorporation into the polymer matrix leads to a strong increase in H2 permeance from 65 GPU t…
N‑Oxide Polyethers as Kinetic Hydrate Inhibitors: Side Chain Ring Size Makes the Difference
2021
The formation of gas hydrates in flow lines is one of the most severe problems for flow assurance in the gas and oil industry. Developing effective kinetic hydrate inhibitors (KHIs) to avoid the problem of gas hydrate formation has attracted widespread attention. In this study, a series of poly(glycidyl amine N-oxide)s (PGAOs) with 5–7-membered rings as side chains, poly(pyrrolidine glycidyl amine N-oxide)s (PPyrGAOs), poly(piperidine glycidyl amine N-oxide)s (PPiGAOs), and poly(azepane glycidyl amine N-oxide)s (PAzGAOs), with varying molecular weights, have been synthesized. The KHI performance of these glycidyl amine N-oxide polyethers has been evaluated in high-pressure rocking cells wit…
Methyl-3-Hexenoate Combustion Chemistry: Experimental Study and Numerical Kinetic Simulation
2020
International audience; This work represents a detailed investigation of combustion and oxidation of methyl-3-hexenoate (CAS Number 2396-78-3), including experimental studies of combustion and oxidation characteristics, quantum chemistry calculations and kinetic model refinement. Following experiments have been carried out: Speciation measurements during oxidation in a jet-stirred reactor at 1 atm; chemical speciation measurements in a stoichiometric premixed flame at 1 atm using molecular-beam mass-spectrometry; ignition delay times measurements in a shock tube at 20 and 40 bar; and laminar burning velocity measurements at 1 atm using a heat-flux burner over a range of equivalence ratios. …
Oxidation of pentan-2-ol -Part II: Experimental and modeling study
2021
International audience; The oxidation of pentan-2-ol was investigated at high-pressure in a jet-stirred reactor and in a shock tube. Experiments in the JSR were carried out at 10 atm, between 500-1180 K, for five different equivalence ratios of = 0.35, 0.5, 1, 2, 4 and 1000 ppm of fuel, at a constant residence time of 0.7 s. Reactant, product and intermediate species mole fractions were quantified using Fourier transform infrared spectrometry (FTIR) and gas chromatography (GC). Ignition delay times were measured for pentan-2-ol/O 2 mixtures in argon in a shock tube at 20 and 40 bar, in a temperature range of 1070-1460 K and for equivalence ratios of = 0.5, 1 and 2. Ignition delay times of a…
Effect of the anode composition on the performance of reversible chlor-alkali electro-absorption cells
2020
Abstract In this work, the performances of a reversible electrochemical cell for the storage of energy using the chloralkaline process was investigated. The cell operates at room temperature with liquid electrolytes in both compartments. In the electrolyzer mode, the cell transforms a sodium chloride solution into hydrogen and chlorine, which is then disproportionated to form hypochlorous acid and hypochlorite. In fuel cell operation mode, the cell becomes an electro-absorber to oxidize hydrogen at the anode while reducing hypochlorous acid at the cathode. Because of the low solubility of hydrogen, a special mechanical device is used to produce hydrogen microbubbles in the anodic compartmen…
Phase Composition and Nanoporous Structure of Core and Surface in the Modified Granules of NH4NO3
2018
The article deals with the study of phase composition and crystal nanoporous structure of core and surface layer of porous ammonium nitrate (PAN). The research results, presented in the article, show that the proposed way to generate PAN allows to provide the granule porous structure without changing of its phase composition. The crystal structure of granules after the humidification and heat treatment has some changes due to the increase of the number of pores. The change of crystal structure, in turn, allows to open access to nanopores that are located in the volume of granules. This allows to increase the holding capacity indicator of granules. An important result of conducted researches…