Search results for "25"
showing 10 items of 3263 documents
Validación de un Cuestionario Multidimensional de Adaptación a la Enfermedad para Pacientes Renales en Diálisis (CMAE-RD) diseñado a partir de un cue…
2020
espanolObjetivos: El objetivo de este trabajo es estudiar las propiedades psicometricas de un cuestionario multidimensional de adaptacion a la enfermedad para pacientes con enfermedad renal en dialisis (CMAE-RD).Metodos: Esta herramienta esta disenada para ser administrada por un profesional de la psicologia en forma de entrevista semiestructurada y fue disenado a partir de un cuestionario previo para pacientes oncohematologicos. Un total de 113 pacientes en hemodialisis fueron entrevistados mediante el CMAE-RD y completaron dos cuestionarios adicionales con propositos de validacion: el HADS (para evaluar ansiedad y depresion) y el CDRISC-2 (para evaluar resiliencia).Resultados: La consiste…
Mixing dynamics in uncovered unbaffled stirred tanks
2014
Abstract The present work is aimed at providing experimental information on mixing rates in an unbaffled vessel under free surface vortexing conditions. The planar laser induced fluorescence (PLIF) technique was used for measuring the dispersion dynamics of a passive tracer over a vertical section of the vessel. In agreement with the quite scant literature information available for these systems, results confirm the existence of two well defined, partially segregated, zones that give rise to a double mixing dynamics behavior. A suitable mixing time definition is proposed and applied to a number of experimental runs with different stirrer geometries and agitation speeds. Results confirm that…
CFD simulations of dense sloid-liquid suspensions in baffled stirred tanks: Prediction of suspension curves
2011
Mixing of solid particles into liquids within contactors mechanically agitated by stirrers is a topic of primary importance for several industrial applications. A great research effort has been devoted to the assessment of the minimum impeller speed (Njs) able to guarantee the suspension of all particles. Conversely, only little attention has been paid so far to the evaluation of the amount of solid particles that are suspended at impeller speeds lower than Njs. In some cases the loss in available interfacial area between particles and liquid could be reasonably counterbalanced by a decreased mechanical power, making it of interest to evaluate the percentage of suspended solids at different…
CFD simulation of channels for direct and reverse electrodialysis
2012
Flows within very thin channels, typically filled with spacers, can be often encountered in many processes such as electrodialysis (ED) and reverse electrodialysis (RED). Although the ED and the RED processes have been studied for a long time, the optimization of the fluid dynamics within the channels is still an open problem. In the present work, realized within the EU-FP7 funded REAPower project, computational fluid dynamics simulations were carried out in order to predict the fluid flow field inside a single ED/RED channel. Some different configurations were tested which includes: an empty channel, a channel provided with a spacer, and a channel filled with a purposely manufactured fiber…
The Transverse Crack Tension test revisited
2016
Several problems arise when measuring the mode II interlaminar fracture toughness using a Transverse Crack Tension specimen; in particular, the fracture toughness depends on the geometry of the specimen and cannot be considered a material parameter. A preliminary experimental campaign was conducted on TCTs of different sizes but no fracture toughness was measured because the TCTs failed in an unacceptable way, invalidating the tests. A comprehensive numerical and experimental investigation is conducted to identify the main causes of this behaviour and a modification of the geometry of the specimen is proposed. It is believed that the obtained results represent a significant contribution in …
Photovoltaic plant array reconfiguration: Design of a new device
2014
An efficient strategy to improve unequally irradiated PV plants performances is based on the reconfiguration of the connections between the modules. In this paper, an algorithm, for this purpose conceived, is presented. Moreover, the design, realization and finally also the set up of a new reconfiguration system device is fully shown and discussed. The algorithm conceived simulates several possible series-parallel connections under varying irradiation conditions, and determines the optimal modules connection in order to get the maximum output power. In this way, the reconfiguration system may set up the reconfiguration strategy. The reconfiguration system prototype set up, basically consist…
Residence time distribution of solid particles in a continuous, high-aspect-ratio multiple-impeller stirred vessel
2004
Abstract In this paper experimental information on the retention time distribution (RTD) of solid particles in a high-aspect-ratio vessel, stirred by three equally spaced Rushton turbines, is presented. The relevant data were obtained by a special technique named twin system approach (TSA) that greatly simplifies the handling of particle-laden streams and is therefore particularly suited for investigating particle RTD in flow systems. The technique fundamentals are first summarized, together with the data analysis procedure. This lastly requires a numerical deconvolution operation that is easily performed with the help of Z -transforms. Two different approaches for excluding the spurious co…
Analysis and simulation of scale-up potentials in reverse electrodialysis
2015
The Reverse Electrodialysis (RED) process has been widely accepted as a viable and promising technology to produce electric energy from salinity difference (salinity gradient power - e.g. using river water/seawater, or seawater and concentrated brines). Recent R&D efforts demonstrated how an appropriate design of the RED unit and a suitable selection of process conditions may crucially enhance the process performance. With this regard, a process simulator was developed and validated with experimental data collected on a lab-scale unit, providing a new modelling tool for process optimisation. In this work, performed within the REAPower project (www.reapower.eu), a process simulator previousl…
On the assessment of power consumption and critical impeller speed in vortexing unbaffled stirred tanks
2017
Abstract Unbaffled stirred tanks are increasingly recognized as a viable alternative to common baffled tanks for a number of processes and bio-processes where the presence of baffles is undesirable. Notwithstanding the increasing industrial interest towards unbaffled tanks, available experimental information on their behaviour is still very poor, even for important parameters such as mechanical power drawn and critical impeller speed (Ncr) at which the transition between non-aerated (sub-critical regime) and aerated (super-critical regime) conditions occurs. In this work the influence of Reynolds and Froude numbers on power consumption characteristics of unbaffled stirred tanks is presented…
A simulation tool for analysis and design of reverse electrodialysis using concentrated brines
2015
Abstract Reverse electrodialysis (SGP-RE or RED) represents a viable technology for the conversion of the salinity gradient power into electric power. A comprehensive model is proposed for the RED process using sea or brackish water and concentrated brine as feed solutions. The goals were (i) reliably describing the physical phenomena involved in the process and (ii) providing information for optimal equipment design. For such purposes, the model has been developed at two different scales of description: a lower scale for the repeating unit of the system (cell pair), and a higher scale for the entire equipment (stack). The model was implemented in a process simulator, validated against orig…