Search results for "35"
showing 10 items of 2413 documents
FUEL CELL POWERED WITH CANOLA OIL EMULSION
2017
The paper presents possibility of using canola oil as active substance to fuel cell powering. For this purpose a prototype fuel cell was built. Cell was powered with canola oil emulsion. As a detergent Syntanol DS-10 was used. The mesh electrode with Pt catalyst was used as a anode, and mesh electrode with Ni-Co catalyst was used as a cathode. The measurements conducted in the temperature range 293-333K. The maximum current density reached the level of 2 mA/cm2, and maximum power reached the level of 21 mW (at temp. 333K). So, the possibility of delivery of canola oil (in emulsion form) directly to the anode was shown. The obtain power is low, but was shown that it is possible to build the …
ELECTROOXIDATION OF USED SYNTHETIC ENGINE OIL IN AQUEOUS SOLUTION OF H2SO4
2017
The paper presents possibility of using used synthetic engine oil to direct electricity production. The measurements conducted in the temperature range 293-333 K. Were measured electrooxidation of used synthetic engine oil emulsion on a smooth platinum electrode in an aqueous solution of H2SO4. The emulsion prepared on the basis of a nonionic surfactant Syntanol DS-10. The maximum current density reached the level of 22 mA/cm2 (temp. 333 K). Measurements shows possibility of direct electricity production from used synthetic engine oil emulsion, so powering fuel cell of this oil.
USE OF Ni-Co ALLOY AS CATHODE CATALYST IN SINGLE CHAMBER MICROBIAL FUEL CELL
2017
Technology of microbial fuel cells allowing for the direct production of electricity from biodegradable materials can provide only energy production, but also wastewater treatment. This technology is seen as supporting of the traditional wastewater treatment. One of the problems with microbial fuel cells is a low current density of those energy sources. Nonetheless, it is possible to increase the current density by using the catalyst for electrodes (anode and cathode). The possibility of wastewater treatment using the Ni-Co alloy as catalyst for single chamber microbial fuel cells is presented in this paper. The studies have included measurements of H2O2 reduction on Ni-Co catalyst, power o…
River-bed erosion due to changing boundary conditions: performance of a protective measure
2018
Abstract. Due to the introduction of man-made sediment barriers along a river, the amount of sediment load entering the downstream river reach is different to that leaving the reach, and erosion processes occur downstream of the barrier itself. Designers are often required to take into account the scouring process and to include adequate protective measures against the local scour. This paper addresses the performance of bio-engineering protective measures against the erosion process. In particular, a green carpet, realized with real flexible vegetation, has been used as the protective measure against erosion processes downstream of a rigid bed. Analyses are based on experimental work carri…
Direct electricity production from coconut oil - the electrooxidation of coconut oil in an acid electrolyte
2018
Supplying more and more energy is an essential task of today's energy industry. In the last few decades, in addition to traditional methods of energy production, alternative energy sources have been developing at a fast rate. One of the devices that can use these sources is the fuel cell (FC). FCs can be a power source of the future mainly due to their high efficiency, their low impact on the environment and the possibility of powering with different fuels. Most often, FCs are powered by hydrogen. However, issues with its cheap production and storage are the reasons for seeking new fuels for FCs. Yet it must be a fuel that will provide a zero or low emission level. One of these fuels can be…
Possibility of direct electricity production from waste canola oil
2017
Powering high-efficiency devices, such as fuel cells, with waste products will allow for a broader development of renewable energy sources and utilisation of by- products. This publication presents the possibility of electrooxidation of the emulsion of waste rapeseed oil, prepared on the basis of the detergent Syntanol DS-10. The process of electrooxidation was carried out on platinum electrode in alkaline (KOH) and acidic (H 2 SO 4 ) electrolyte, in the temperature range of 293-333 K. In each analysed case the process of electrooxidation took place. The maximum current density obtained was 7 mA cm -2 . Thus, it has been shown that it is possible to generate electricity directly from the em…
Evaluation of plankton communities in small highly humic bog lakes in Latvia
1998
This paper reports the results of a study performed at the Teici State Reserve in Latvia The results indicated that algal communities in brown water lakes were formed by species that were tolerant to a low pH and high humic substance concentration. The composition of the species of phytoplankton and zooplankton was comparatively simple. A significant correlation was found between the number of species of phytoplankton, zooplankton, and the pH value. Similarly there was a clear relationship between the taxonomic composition of phytoplankton, zooplankton, and the trophic state of the lakes. Dyseutrophic lakes were characterized by comparatively higher biodiversity of planktonic communities th…
Modelling the shrub encroachment in a grassland with a Cellular Automata Model
2018
Abstract. Arid and semi-arid grasslands of southwestern North America have changed dramatically over the last 150 years as a result of shrub encroachment, i.e. the increase in density, cover and biomass of indigenous shrubby plants in grasslands. Numerous studies have documented the expansion of shrublands in the southwestern American grasslands; in particular shrub encroachment has occurred strongly in part of the northern Chihuahuan desert since 1860. This encroachment has been simulated using an ecohydrological Cellular Automata model, CATGraSS. It is a spatially distributed model driven by spatially explicit irradiance and runs on a fine-resolution gridded domain. Plant competition is m…
Hydro-mechanical behaviour of a sandy silt from a river embankment
2020
The paper presents the results of an experimental campaign aimed at characterizing the hydro-mechanical behaviour of a sandy silt from a river embankment. Due to continuous river level fluctuations and changing climatic and environmental conditions, flood embankment materials experience frequent variations in degree of saturation and suction values. Such variations strongly impact the earthwork performance both in terms of seepage and stability conditions. For these reasons, a detailed characterization of the material behaviour in unsaturated conditions was carried out. Experiments were designed in order to highlight the response of the involved soil in terms of changes in matric suction an…
Assessment of the changes of COD and color in rivers of Latvia during the last twenty years
1998
Analysis of long-term records of the concentrations of water color and chemical oxygen demand for nine river sites in Latvia is reported. The period of observations lasted for the last 20 years. Characteristic features of data include non-normal distributions, serial correlation, seasonality and presence of mostly significant downward trends. In Latvia, the main water quality changes could be explained by the changes of anthropogenic impact and the type of catchment management over the last 20 years.