Search results for "ACOUSTIC"
showing 10 items of 1590 documents
Lock-In Signal Post-Processing Techniques in Infra-Red Thermography for Materials Structural Evaluation
2013
This paper describes the potential of off-line thermographic signal processing by means of Lock-In Correlation algorithms, in order to implement structural health monitoring and stress analysis techniques. Thermal datasets acquired by infrared thermocameras are locked-in and correlated numerically with opportune reference signals, and amplitude and phase values of various harmonics retrieved by means of a Fast Fourier Transform and time averaging based filtering. This information is then processed for NDT defect probing and for evaluating the Thermoelastic Effect induced temperature changes. Two case studies in particular are discussed, implementing the proposed signal lock-in processing: a…
Quantitative thermoelastic stress analysis by means of low-cost setups
2020
Abstract A low-cost Thermoelastic Stress Analysis (TSA) experimental setup is proposed which uses an ordinary micro-bolometer and in-house developed signal processing scripts. The setup is evaluated by analysing the thermoelastic signal from a tensile and a SENT specimen made of stainless steel AISI 304L, and the bolometer performances are compared with those of a state of the art photon detector. Signal processing is based on off-line cross-correlation, using a self-reference signal which is retrieved from the acquired thermal data. Procedures are in particular developed to recognise, quantify and correct errors due to spectral leakage and loss of streamed frames. The thermoelastic signal …
On the performance of multi-GPU-based expert systems for acoustic localization involving massive microphone arrays
2015
Sound source localization is an important topic in expert systems involving microphone arrays, such as automatic camera steering systems, human-machine interaction, video gaming or audio surveillance. The Steered Response Power with Phase Transform (SRP-PHAT) algorithm is a well-known approach for sound source localization due to its robust performance in noisy and reverberant environments. This algorithm analyzes the sound power captured by an acoustic beamformer on a defined spatial grid, estimating the source location as the point that maximizes the output power. Since localization accuracy can be improved by using high-resolution spatial grids and a high number of microphones, accurate …
Spectral estimators for Doppler analysis of intracoronary ultrasound catheters
2002
With the zero-cross-detection method (ZCD) it has been shown that it is not possible to achieve a reproducible quantitative, and robust evaluation of an inter-coronary audio signal. The authors define spectral estimators to analyze the Doppler-audio signal. Measurements in a blood flow model have shown that the ZCD method underestimates the expected velocity at all speeds. Spectral analysis allows the determination of the actual and peak velocity more robustly and precisely. >
Background studies for acoustic neutrino detection at the South Pole
2011
The detection of acoustic signals from ultra-high energy neutrino interactions is a promising method to measure the tiny flux of cosmogenic neutrinos expected on Earth. The energy threshold for this process depends strongly on the absolute noise level in the target material. The South Pole Acoustic Test Setup (SPATS), deployed in the upper part of four boreholes of the IceCube Neutrino Observatory, has monitored the noise in Antarctic ice at the geographic South Pole for more than two years down to 500 m depth. The noise is very stable and Gaussian distributed. Lacking an in-situ calibration up to now, laboratory measurements have been used to estimate the absolute noise level in the 10 to …
The effects of intensity, frequency, static load, and shore hardness on different parameters in vibration sensitivity measurements.
1987
The effects of shore hardness, static load, frequency, and intensity of vibration on the amplitude and dynamic force effects of vibration were studied in conditions corresponding to those occurring in vibrotactile sensitivity measurements. The measurements were performed on three silicon plates of known shore hardness. The results indicated that the effect of differences in elasticity on the vibration amplitudes was evident at lower frequencies up to about 200 Hz whereas at higher frequencies the amplitudes remained at the same level, regardless of elasticity. On dynamic force the effect of elasticity was observed at all frequencies studied (50-500 Hz). The static load of the contractor had…
Evaluating pulp stiffness from fibre bundles by ultrasound
2012
A non-destructive ultrasonic tester was developed to measure the stiffness of pulp bundles. The mechanical properties of pulp are important when estimating the behaviour of paper under stress. Currently available pulp tests are tedious and alter the fibres structurally and mechanically. The developed tester employs (933 ± 15) kHz tweezer-like ultrasonic transducers and time-of-flight measurement through (9.0 ± 2.5) mm long and (0.8 ± 0.1) mm thick fibre bundles kept at (19.1 ± 0.4) °C and (62 ± 1)% RH. We determined the stiffness of soft wood pulps produced by three kraft pulping modifications: standard kraft pulp, (5.2 ± 0.4) GPa, prehydrolysis kraft pulp, (4.3 ± 0.4) GPa, and alkali extra…
On the effectiveness of vocal imitations and verbal descriptions of sounds
2014
cote interne IRCAM: Lemaitre14b; None / None; International audience; Describing unidentified sounds with words is a frustrating task and vocally imitating them is often a convenient way to address the issue. This article reports on a study that compared the effectiveness of vocal imitations and verbalizations to communicate different referent sounds. The stimuli included mechanical and synthesized sounds and were selected on the basis of participants' confidence in identifying the cause of the sounds, ranging from easy-to-identify to unidentifiable sounds. The study used a selection of vocal imitations and verbalizations deemed adequate descriptions of the referent sounds. These descriptio…
Innovative Tools for Sound Sketching Combining Vocalizations and Gestures
2016
International audience; Designers are used to produce a variety of physical and digital representations at different stages of the design process. These intermediary objects (IOs) do support the externalization of ideas and the mediation with the different stakeholders. In the same manner, sound designers deliver several intermediate sounds to their clients, through iteration and refinement. In fact, these preliminary sounds are sound sketches representing the intermediate steps of an evolving creation. In this paper we reflect on the method of sketching sounds through vocalizations and gestures, and how a technological support, grounded in the understanding of the design practice, can fost…
Linearizing Auditory Distance Estimates by Means of Virtual Acoustics
2008
Auditory distance estimates are not linearly related to physical distances: people tend to overestimate close physical distances, and underestimate far distances [I]. We have modeled a virtual listening environment whose objective is to provide a linear relationship between perceived and physical distance. The simulated environment consists of a trapezoidal membrane with specific absorbing properties at the boundaries. A physics-based model simulates acoustic wave propagation in this virtual space and provides auditory distance cues, namely intensity and direct-to-reverberant energy ratio. Simulations predict the linearity of the psychophysical function relating physical distance to perceiv…