Search results for "ACOUSTIC"
showing 10 items of 1590 documents
The impact of noise on the population of an urban centre in Valencia (Spain)
1997
Acoustic contamination in residential areas is a generalized problem. This paper reports the results of a survey trying to evaluate this contamination in the historical center of Valencia and about its effects upon that district's residents. A total of 700 residents in 11 different neighbourhoods of the city of Valencia were interviewed; at the same time environmental noise was determined at 225 different points within the area of study. In the historical center of Valencia, there exists an important problem of environmental noise and the daily levels clearly exceed the recommended limits.
Active photonic crystals based on surface acoustic waves
2003
An active photonic crystal (PC) based on the modulation of a one-dimensional cavity resonator by electrically-generated surface acoustic waves is described. The high nonthermal population of surface modes combined with the enhanced Brillouin scattering in the cavity increases the intensity of the scattered light to values comparable to the excitation intensity. This process is employed to switch and modulate light beams in PCs.
Distortion product otoacoustic emissions in healthy newborns: normative data.
1995
Distortion product otoacoustic emissions (DPOAE) offer an alternative to transiently evoked otoacoustic emissions (TEOAE) as an audiological test. The former can be used as a screening technique, and may also provide frequency-specific information about the functional state of the cochlea. We recorded DPOAE in a group of healthy newborns to establish the Characteristics of a DPOAE “audiogram” (DP-gram) in this population. The DP-gram can be obtained with characteristics quite similar to those observed in adults, with two sharp peaks of maximum amplitude at F2 frequencies of 2 kHz and 5-6 kHz, and a decline in DPOAE amplitude in mid frequencies. The results confirm the limitations of DPOAE r…
Acoustic, myoelectric, and aerodynamic parameters of euphonic and dysphonic voices: a systematic review of clinical studies
2021
Background: At present, there is no clinical consensus on the concept of normal and dysphonic voices. For many years, the establishment of a consensus on the terminology related to normal and pathological voices has been studied, in order to facilitate the communication between professionals in the field of the voice. Aim: systematically review the literature to compare and learn more precisely the measurable and objective characteristics of the acoustic, aerodynamic and surface electromyographic parameters of the normal and dysphonic voices. Methods: The PRISMA 2020 methodology was used as a review protocol together with the PICO procedure to answer the research question through six databa…
Prospectives to tractor cabin design with computational acoustics tools
2011
Computational acoustical models allow automated optimization of tractor design with respect to acoustic properties, which could speed up significantly the design process of tractor cabin prototypes. This article gives insightful prospectives to the tractor design process by considering modern computational acoustics technology. Mathematical formulation for a system consisting of vibrating elastic tractor structure and airfilled acoustic enclosure are given and a related numerical solution technique with finite element method (FEM) is presented. Simulation results produced with commercially available software are reviewed. nonPeerReviewed
Topological surface wave metamaterials for robust vibration attenuation and energy harvesting
2021
International audience; We propose topological metamaterials working in Hertz frequency range, constituted of concrete pillars on the soil ground in a honeycomb lattice. Based on the analog of the quantum valley Hall effect, a non-trivial bandgap is formed by breaking the inversion symmetry of the unit cell. A topological interface is created between two different crystal phases whose robustness against various defects and disorders is quantitatively analyzed. Finally, we take advantage of the robust and compact topological edge state for designing a harvesting energy device. The results demonstrate the functionality of the proposed structure for both robust surface vibration reduction and …
FLUMO: FLexible Underwater MOdem
2019
The last years have seen a growing interest in underwater acoustic communications because of its applications in marine research, oceanography, marine commercial operations, the offshore oil industry and defense. High-speed communication in the underwater acoustic channel has been challenging because of limited bandwidth, extended multipath, refractive properties of the medium, severe fading, rapid time variation and large Doppler shifts. In this paper, we show an implementation of a flexible Software-Defined Acoustic (SDA) underwater modem, where modulation parameters are completely tunable to optimize performance. In particular, we develop the system architecture following two key ideas. …
Source Mechanisms of Laboratory Earthquakes During Fault Nucleation and Formation
2021
Identifying deformation and pre-failure mechanisms preceding faulting is key for fault mechanics and for interpreting precursors to fault rupture. This study presents the results of a new and robust derivation of first motion polarity focal mechanism solutions (FMS) applied to acoustic emission (AE). FMS are solved using a least squares minimization of the fit between projected polarity measurements and the deviatoric stress field induced by dilatational (T-type), shearing (S-type), and compressional (C-type) sources. 4 × 10 cm cylindrical samples of Alzo Granite (AG, porosity <1%) and Darley Dale Sandstone (DDS, porosity ≈14%) underwent conventional triaxial tests in order to investigat…
An optimization-based approach for solving a time-harmonic multiphysical wave problem with higher-order schemes
2013
This study considers developing numerical solution techniques for the computer simulations of time-harmonic fluid-structure interaction between acoustic and elastic waves. The focus is on the efficiency of an iterative solution method based on a controllability approach and spectral elements. We concentrate on the model, in which the acoustic waves in the fluid domain are modeled by using the velocity potential and the elastic waves in the structure domain are modeled by using displacement.Traditionally, the complex-valued time-harmonic equations are used for solving the time-harmonic problems. Instead of that, we focus on finding periodic solutions without solving the time-harmonic problem…
Tailoring the excitation of fundamental flexural guide waves in coated bone by phase-delayed array: Two-dimensional simulations
2015
The fundamental flexural guided wave (FFGW) enables ultrasonic assessment of cortical bone thickness. In vivo, it is challenging to detect this mode, as its power ratio with respect to disturbing ultrasound is reduced by soft tissue covering the bone. A phase-delayed ultrasound source is proposed to tailor the FFGW excitation in order to improve its power ratio. This situation is analyzed by 2D finite-element simulations. The soft tissue coating (7-mm thick) was simulated as a fluid covering an elastic plate (bone, 2–6 mm thick). A six-element array of emitters on top of the coating was excited by 50-kHz tone bursts so that each emitter was appropriately delayed from the previous one. Respo…