Search results for "ATIS"
showing 10 items of 15276 documents
Isothermal relaxation of discommensurations in K2ZnCl4
1994
At the incommensurate-ferroelectric transition temperature T c of K 2 ZnCl 4 , the dielectric susceptibility contains an anomalous contribution both above and below T c . Previous quasi-static dielectric measurements and hysteresis loops demonstrated that this anomalous part arises from the peculiar dynamics of discommensurations. We have used isothermal dielectric measurements to get some insight into the long time dynamics of these discommensurations. We have found that the characteristic relaxation times τ are of the order of 10 4 s in the incommensurate and in the ferroelectric phase. Even more unusual is a non-monotonous relaxation which is observed in a restricted temperature range ab…
Mechanical properties of macroscopic magnetocrystals
2019
Abstract We studied experimentally and by numerical simulations the mechanical response of arrays of macroscopic magnetic spheres when an external stress is applied. First, the tensile strength of single chains and ribbons was analyzed. Then, simple cubic (cP), hexagonal (Hx) and hybrid (cP-Hx) structures, called here magnetocrystals , were assembled and subjected to tensile stress, bending stress and torsion until failure was reached. Atomistic crystalline structures are isotropic, but in the case of magnetocrystals, even when geometric isotropy is obeyed, dipolar magnetic interactions introduce a physical anisotropy which modifies, in a non-usual manner, the structures response to the kin…
Magneto-optical properties of two-layer film systems based on Fe and Cr
2020
The results of the investigation of two-layer Fe/Cr systems using the magneto-optical Kerr effect (MOKE) are presented in this paper. The samples were obtained by thermal evaporation in a vacuum with a thickness of individual layers from 2 nm to 50 nm. It was found that the presence of the Cr layer significantly affects the values of the coercivity and the Kerr angle. At a substrate temperature of 450 K, the value of the coercivity is almost half that of the same sample obtained at room temperature of the substrate. In addition, the influence of the order of deposition of layers, as well as the effect of a thin gold protective layer on the parameters measured by the Kerr method, is shown. …
Non-Linearity Extremum in Niobium Doped Potassium Tantalate
1997
We report non-linear dielectric measurements in the KTaO 3 :Nb system (x Nb ≤ 0.05). The non-linear susceptibility diverges at low temperatures and reaches maximum values in the intermediate range (0.0075 ≤ x Nb ≤ 0.02). To account for this extremum non linearity, we propose a model of temperature dependent clusters which fits with a number of experimental reports. We also suggest that this model may be applied to the related compounds SrTiO 3 :Ca and KTaO 3 :Na.
Multiscale model approach for magnetization dynamics simulations
2016
Simulations of magnetization dynamics in a multiscale environment enable the rapid evaluation of the Landau-Lifshitz-Gilbert equation in a mesoscopic sample with nanoscopic accuracy in areas where such accuracy is required. We have developed a multiscale magnetization dynamics simulation approach that can be applied to large systems with spin structures that vary locally on small length scales. To implement this, the conventional micromagnetic simulation framework has been expanded to include a multiscale solving routine. The software selectively simulates different regions of a ferromagnetic sample according to the spin structures located within in order to employ a suitable discretization…
Two-neutron correlations at small relative momenta in ^40Ar + ^197Au collisions at 60 MeV/nucleon
2000
Two-neutron correlation functions are measured in the 40Ar + 197Au reaction at 60 MeV/nucleon to study the space-time characteristics of neutron emitting sources. The source temperatures and velocities are deduced by fitting the single-neutron energy spectra with a three-source model. A comparison of the correlation data with the predictions of the model of moving sources and with the dynamical Landau-Vlasov model suggests the relevance of a multisource description. Particular care has been paid to the influence of the relative source abundance on the shape of the correlation function.
Data-driven Fault Diagnosis of Induction Motors Using a Stacked Autoencoder Network
2019
Current signatures from an induction motor are normally used to detect anomalies in the condition of the motor based on signal processing techniques. However, false alarms might occur if using signal processing analysis alone since missing frequencies associated with faults in spectral analyses does not guarantee that a motor is fully healthy. To enhance fault diagnosis performance, this paper proposes a machinelearning based method using in-built motor currents to detect common faults in induction motors, namely inter-turn stator winding-, bearing- and broken rotor bar faults. This approach utilizes single-phase current data, being pre-processed using Welch’s method for spectral density es…
Diagrammatic Expansion for Positive Spectral Functions in the Steady-State Limit
2019
Recently, a method was presented for constructing self-energies within many-body perturbation theory that are guaranteed to produce a positive spectral function for equilibrium systems, by representing the self-energy as a product of half-diagrams on the forward and backward branches of the Keldysh contour. We derive an alternative half-diagram representation that is based on products of retarded diagrams. Our approach extends the method to systems out of equilibrium. When a steady-state limit exists, we show that our approach yields a positive definite spectral function in the frequency domain.
Metrological Properties of the Test Setup for Determination Shielding Effectiveness of the Industrial Cable Connectors
2017
Abstract The paper presents results related to assessment of the repeatability and reproducibility of the measurement test setup for determination the relative value of the shielding effectiveness coefficient of the industrial connectors. The construction of the proposed test setup, the measurement method and the procedure for the analysis of measurement results were described. To determine the value of the repeatability and reproducibility coefficient, the two–way analysis of variance was used, which additionally allows for an assessment of the influence of individual sources of variance. The measurements and their analysis were conducted for several frequencies in the range up to 1 GHz. A…
Parametric Models for Predicting the Performance of Wind Turbines
2020
Abstract Performances of eight parametric power curve models for wind turbines, which can be used for the planning and management of wind energy projects, are compared in this study. Initially, the manufacturer’s power curves of four wind turbines are compared with their field performances. Then, the parametric models are developed for these turbines which are tested with their site performances. Out of the models, WERA showed the best performance in case of all the turbines. Finally, a method for using WERA in extrapolating the performance of turbines with limited test data is demonstrated with the case of a 1 kW turbine.