Search results for "Absorption"
showing 10 items of 2701 documents
Photoconductivity & photoelectron emission of LiGaO2 crystal excited in intrinsic absorption range
2019
This research is funded by the Latvian Council of Science, project “Research of luminescence mechanisms and dosimeter properties in prospective nitrides and oxides using TL and OSL methods], project No. lzp-2018/0361.
Sensitization of nanocrystalline TiO2 with 3,4,9,10-perylene tetracarboxylic acid
2014
Optical properties of 3,4,9,10-perylene tetracarboxylic acid (PTCA) in the presence of nanocrystalline TiO2 (nominal diameter 15 nm) have been investigated in ethanol solution and in the solid state by UV-Vis absorption spectroscopy and steady-state and time-resolved fluorescence. Experimental results show that, in ethanol, the presence of TiO2 nanoparticles causes significant changes in the typical absorption and fluorescence bands of PTCA and in the fluorescence relaxation time. Similar effects are also detected in solid samples, obtained by electrospray deposition technique. The nonlinear optical properties of the PTCA-TiO2 in ethanol solutions were investigated using the single-beam Z-s…
Preconcentration and speciation of chromium in waters using solid-phase extraction and atomic absorption spectrometry
2000
Abstract A method for the preconcentration and speciation of chromium was developed. After formation of an anionic compound with ethylenediaminetetraacetic acid (CrY − ), Cr (VI) and Cr (III) are retained on a strong anionic phase (SAX) and controlled elution with 0.5 M NaCl permits their speciation. The retention and elution conditions were optimised, and interferences due to the presence of other ions such as Mg(II), Mn(II), Sn(II), Fe(III), Ba(II), Al(III), Ca(II), chloride, iodine, bromide, fluoride, sulphate, phosphate, bicarbonate and nitrate were studied. The detection limits were 0.4 μg l −1 and 1.1 μg l −1 for Cr(III) and Cr(VI), respectively, and reproducibility was 9%. The result…
The Daily Consumption of Cola Can Determine Hypocalcemia: A Case Report of Postsurgical Hypoparathyroidism-Related Hypocalcemia Refractory to Supplem…
2017
The consumption of soft drinks is a crucial factor in determining persistent hypocalcemia. The aim of the study is to evaluate the biochemical mechanisms inducing hypocalcemia in a female patient with usual high consumption of cola drink and persistent hypocalcemia, who failed to respond to high doses of calcium and calcitriol supplementation. At baseline and after pentagastrin injection, gastric secretion (Gs) and duodenal secretion (Ds) samples were collected and calcium and total phosphorus (Ptot) concentrations were evaluated. At the same time, blood calcium, Ptot, sodium, potassium, chloride, magnesium concentrations, and vitamin D were sampled. After intake of cola (1 L) over 180 min,…
Absorption And Transferring Of The Coghlear Fluids
1968
The perilymph is absorbed in the loose connective tissue of the modio-lum, the endolymph is absorbed in the planum limbi and the interstitial liquid of the organ of Corti in the inner spiral sulcus. The basin of the vein of the aqueduct of the cochlea in a fetal phase transfers almost only perilymph. When fully developed, many veins of the above-said basin are obliterated and the remaining ones transfer more blood than perilymph. From the interstitial spaces of the limbus the endolymph flows into the capillaries towards the inner auditory veins and the interstitial liquid of the organ of Corti flows towards the same veins by means of short lymphatic vessels.
Neutron irradiation defects in gallium sulfide: Optical absorption measurements
1997
Gallium sulfide single crystals have been irradiated with different thermal neutron doses. Defects introduced by neutron irradiation turn out to be optically active, giving rise to absorption bands with energies ranging from 1.2 to 3.2 eV. Bands lying in the band-gap exhibit Gaussian shape. Their energies and widths are independent of the irradiation dose, but their intensities are proportional to it. Thermal annealing is completed in two stages, ending at around 500 and 720 K, respectively. Centers responsible for the absorption bands are proposed to be gallium-vacancy-galliuminterstitial complexes in which the distance between the vacancy (acceptor) and the interstitial (donor) determines…
A comparative evaluation of crashworthy composite sandwich structures
2007
Abstract This paper describes an experimental evaluation of the energy absorption properties of a series of novel designs for cost-effective crashworthy composite sandwich structures. All the designs are based on the concept of the “tied-core” sandwich, i.e. the use of additional core reinforcements that act to tie the opposing facings of a sandwich together, thus preventing catastrophic failure under edgewise loading. The design, manufacture and crush testing of hollow rectangular tubes fabricated from six different tied-core concepts is described. Factors that are shown to promote high energy absorption include large, continuous areas of contact between the facings and the ties, non-thin …
Absorption equipment for energy savings: A case study in Sicily
2013
Abstract This paper considers a feasibility study on the recovery of the reject heat available from an electric utility with two units operating with 120-MW gas turbines; these units have a heat recovery system that feeds the district heating pipeline of an industrial consortium. Thus, feeding the expeller of the absorption equipment installed in a cooling plant for foodstuff stocking represents an opportunity for the feasibility study. This plant operates at both 0 °C and −18 °C. The feasibility study covers two aspects: (1) the technical feasibility of a suitable absorption cooling plant that uses two separate pieces of absorption equipment working with the pair ammonia–water and (2) the …
Lower and Upper Bounds of Manufacturing Cost in FMS
1993
Abstract The use of traditional techniques of product costing, cost control and performance evaluation in advanced manufacturing environment supplies poor results to operations management. In this paper, after a brief review of the major drawbacks of traditional machining economics, a new framework for product costing will be presented. The basis of the proposed approach lies on an analysis of the production process aimed at single out proper cost drivers for the use of the various employed manufacturing resources. As a consequence, the quota of the manufacturing cost of uncertain allocation is drastically reduced. A lower and an upper bound value of the unit production cost are also define…
A measurement methodology for monitoring a CHCP pilot plant for an office building
2003
Abstract In Mediterranean areas, climate conditions determine quite equal demand both for thermal and cooling energy. The possibility to convert a cooling demand in thermal one through an absorption chiller allows to extend widely the number of running hours of a cogeneration plant. A trigeneration pilot plant for two office building is described, in which an integrated lay-out includes a NG prime mover with heat exchanger, an absorption chiller and a reversible heat pump. The pilot plant is completed and pre-running test were performed. Different fluid dynamics parameters will be monitored, in order to build the actual cumulative curve for thermal power. The measurement methodology is also…