Search results for "Acoustic Emission"
showing 10 items of 56 documents
Identification of a specific type of PD from acoustic emission frequency spectra
2001
The paper presents an attempt to apply spectral analysis tools in processing acoustic emission (AE) pulses generated by partial discharge (FD). The experimental part of the paper describes spark gaps generating four types of PD and specifies parameters of measured acoustic signals and recalls the system used for measurement and analysis of the frequency spectra. Also, a spectral analysis procedure is presented, and frequency-domain descriptors characterizing AE pulses are defined. The results of the analysis are given both as time plots and amplitude and energy density spectra, related to values of the associated descriptors. The spectral analysis results cover AE pulses generated in system…
Comparative analysis of acoustic emission signals generated by electrical discharges measured by the hydrophone and the wideband contact transducer
2005
The paper presents a comparative analysis of the acoustic emission (AE) pulses and signals generated by PDs. For this purpose the measurements of the acoustic emission signals generated by PDs were taken in the multipoint-plane system using a hydrophone placed directly in the area of discharge generation, and the AE pulses using a piezoelectric contact transducer which was on a side wall of a power transformer tub. Next, time runs and amplitude density spectra were drawn. Also the descriptors describing signals in the frequency domain were determined and the time-frequency analysis was carried out, which determined spectrograms for the energy density spectrum.
Acoustic Emission Waveform Picking with Time Delay Neural Networks during Rock Deformation Laboratory Experiments
2020
Abstract We report a new method using a time delay neural network to transform acoustic emission (AE) waveforms into a time series of instantaneous frequency content and permutation entropy. This permits periods of noise to be distinguished from signals. The model is trained in sequential batches, using an automated process that steadily improves signal recognition as new data are added. The model was validated using AE data from rock deformation experiments, using Darley Dale sandstone in fully drained conditions at a confining pressure of 20 MPa (approximately 800 m simulated depth). The model is initially trained by manual picking of five high-amplitude waveforms randomly selected from t…
The possibilities of using the acoustic emission method in expert systems for the evaluation of insulation systems of power transformers
2006
The paper presents the range and possibilities of using expert systems at diagnostic measurements of insulation systems of power appliances taken by the acoustic emission (AE) method. Multi-parametric descriptors characterizing the AE signals, which can be used in the knowledge base as criteria making the identification of basic partial discharge forms (PDs) possible, have been characterized in detail. The tables show descriptors describing the AE signals registered in time, frequency, time-frequency domains and statistical data. Moreover, computational tools that can be used in the process of conclusion drawing were suggested and the range of the research work done by the authors of the pa…
Application of wavelet analysis to acoustic emission pulses generated by partial discharges
2004
The subject matter of this paper refers to the improvement of the acoustic emission (AE) method when used for detection, measurement and location of partial discharges (PDs) in oil insulation systems of power appliances. The detailed subject matter refers to the issues connected with the application of modern methods of digital processing of signals obtained during technical high-power measurements. The paper presents the results of measurements and analyses of the AE pulses generated in setups making the modeling of basic PD forms that can occur in oil insulations possible. The research concentrated mainly on the following types of PDs: point-plane, multipoint-plane, multipoint-plane with …
High-velocity Impact Location on Aircraft panels Using Macro-fiber Composite piezoelectric Rosettes
2010
In this article, an approach based on an array of macro-fiber composite (MFC) transducers arranged as rosettes is proposed for high-velocity impact location on isotropic and composite aircraft panels. Each rosette, using the directivity behavior of three MFC sensors, provides the direction of an incoming wave generated by the impact source as a principal strain angle. A minimum of two rosettes is sufficient to determine the impact location by intersecting the wave directions. The piezoelectric rosette approach is easier to implement than the well-known time-of-flight-based triangulation of acoustic emissions because it does not require knowledge of the wave speed in the material. Hence, th…
Destructuration of typical Sicilian calcarenites
2010
The paper discusses some interesting features of Sicilian fine grain calcarenites. Uniaxial, triaxial, oedometer and isotropic compression tests were undertaken on intact specimens of two types of calcarenite in order to investigate their mechanical characteristics. It was found that the strength and deformability is significantly influenced by the structure (fabric and bonding) and by the destructuration processes. A better understanding of fracture development behavior is gained through a combination of acoustic emission and photographic monitoring on non-homogeneous samples with natural pre-existing heterogeneities due to cementation or to density. The results show that the destructurati…
The influence of the propagation path length on the results of the time–frequency analysis of the acoustic emission generated by partial discharges i…
2006
The paper presents the measurement results of the acoustic emission (AE) signals generated by partial discharges (PDs) at various thickness of the oil insulation layer. For the AE signals registered the time - frequency analysis was carried out based on the use of the short-time Fourier transform (STFT). Two- and three-dimensional spectrograms of the power spectrum density and the amplitude spectrum were determined. The evaluation of the influence of the propagation path length of the AE signal on the results of the time - frequency analysis was performed through the analysis of the spectrograms determined.
Tools for studying water vapor at high temperatures
2014
1. Kinetics and Oxidation Mechanisms 1.1 Experimental Devices that Produce Water Vapor1.2 Using the Jump Method to Understand Oxidation Mechanisms and Kinetics1.3 Detection of Breakaway Oxidation with Acoustic Emission during Thermal Oxide Scale Growth 1.4 Stress Analysis during and after Oxidation 2. Characterization 2.1 Use and Potential of Environmental SEM (ESEM) in High-Temperature Oxidation and Corrosion Studies in Wet Air 2.2 In Situ X-Ray Diffraction for Water Vapor Analyses2.3 Use of Synchrotron Beam for Evaluating the Influence of Water Vapor on the Corrosion of Metallic Materials 2.4 Raman Spectrometry2.5 In Situ Steam Oxidation Chamber Coupled to XPS 2.6 Hydrogen Profiling in Ox…
Behavioural and biochemical stress responses of Palinurus elephas after exposure to boat noise pollution in tank
2014
This study examined the effects of boat noise on the behavioural and biochemical parameters of the Mediterranean spiny lobster (Palinurus elephas).The experiment was conducted in a tank equipped with a video and audio recording system. 18 experimental trials, assigned to boat noise and control conditions, were performed using lobsters in single and group of 4 specimens. After a 1. h habituation period, we audio- and video-recorded the lobsters for 1. h. During the experimental phase, the animals assigned to the boat groups were exposed to boat noise pollution (a random sequence of boat noises). Exposure to the noise produced significant variations in locomotor behaviours and haemolymphatic …