Search results for "Acoustics"
showing 10 items of 984 documents
Vibration of damaged beams under a moving mass: theory and experimental validation
2004
Abstract A theoretical and experimental study of the response of a damaged Euler–Bernoulli beam traversed by a moving mass is presented. Damage is modelled through rotational springs whose compliance is evaluated using linear elastic fracture mechanics. The analytical solution is based on the series expansion of the unknown deflection in a basis of the beam eigenfunctions. The latter are calculated using the transfer matrix method, taking into account the effective mass distribution of the beam. The convective acceleration terms, often omitted in similar studies, are considered here for a correct evaluation of the beam–moving mass interaction force. The analytical solution is then validated…
Nonlinear analysis of cylindrical and conical hysteretic whirl motions in rotor-dynamics
2014
Abstract The internal friction of a rotor–shaft-support system is mainly due to the shaft structural hysteresis and to some possible shrink-fit release of the assembly. The experimentation points out the destabilizing effect of the internal friction in the over-critical rotor running. Nevertheless, this detrimental influence may be efficiently counterbalanced by other external dissipative sources located in the supports or by a proper anisotropic configuration of the support stiffness. The present analysis considers a rotor–shaft system which is symmetric with respect to the mid-span and is constrained by viscous-flexible supports with different stiffness on two orthogonal planes. The cylin…
A study of noise transmission through cylindrical shell using modal truncation approach
2011
International audience; The study of the vibroacoustic behaviour of cylindrical structure like aircraft fuselage requires the establishment of very large models, and the numerical results which can be obtained are often difficult to interpret. On the other hand, the study of simple structures such as cylindrical shells is useful to validate the criteria and tools that can be used to simplify the models of complex structures. The presented study concerns the sound transmission through a cylindrical shell coupled to a cavity and subjected to an incident acoustic wave. Noise reduction is obtained and validated by a numerical method which uses structural and acoustical modes. A criterion for se…
Eddy current flaw detection with neural network applications
2005
Abstract Eddy current inspection is a fast and effective method for detecting and sizing most of the flaws in conducting materials. The inverse problem solution, i.e., inferencing about possible defect, based on the measurement signal from the eddy current probe, is a difficult task. In this paper an implementation of artificial neural networks for multi-frequency eddy current testing on conducting layers (aluminum, copper) and ferrous tubes has been presented.
Viscoelastic bearings with fractional constitutive law for fractional tuned mass dampers
2015
Abstract The paper aims at studying the effects of the inherent fractional constitutive law of viscoelastic bearings used as devices for tuned mass dampers. First, the proper constitutive law of the viscoelastic supports is determined by the local constitutive law. Then, the characteristic force–displacement relationship at the top of the bearing is found. Taking advantage of the whole bearing constitutive laws, the tuning of the mass damper is proposed by defining the damped fractional frequency, which is analogous to the classical damped frequency. The effectiveness of the optimal tuning procedure is validated by a numerical application on a system subjected to a Gaussian white noise.
Towards online bearing fault detection using envelope analysis of vibration signal and decision tree classification algorithm
2017
Online bearing fault detection is an important method for monitoring the health status of bearings in critical machines. This work proposes a classification algorithm, which can be extended towards an online bearing fault detection. The objective is to detect and classify the bearing faults in early stages. The overall design aspects of the online bearing fault detection and classification system are discussed. The proposed method is validated using experimental data, and a high accuracy of the fault classification was observed. Therefore, the proposed method can be applied for an online early fault detection and classification system.
Simple equipment to measure biomechanical quantities of muscles and organs which includes a polarity-programmable peak detector
1982
Biomechanical measurements of muscles and organs require appropriate measuring equipment. As far as the static properties are concerned, the excursion of the bender bar of stress should be without force. The bender bar of force, however, ideally should not elongate under load. Because natural frequency is the most important boundary condition, the bender bar should be developed with this in mind. The developed bars imposed an insignificant preload to the muscle or to the organ. The small changes in resistance occurring in the resistance strain gauges affixed to the bars require the use of a highly stable amplifier. A new amplifier was accordingly developed based on the principle of an instr…
<title>Modeling of eddy current sensors</title>
2001
In this paper two models of eddy current sensor have been presented. They are base don a one- and multi-turn coil model. The results of computer simulations present a relation of eddy current density on nonferromagnetic conducting materials versus some parameters viz: a coil radius, frequency of excitation current and conductivity of material.© (2001) COPYRIGHT SPIE--The International Society for Optical Engineering. Downloading of the abstract is permitted for personal use only.
Mismatches between objective parameters and measured perception assessment in room acoustics: a holistic approach
2014
Psychoacoustic research in the field of concert halls has revealed that many aspects concerning listening perception have yet to be totally understood. On the one hand, the objective room acoustics of performance spaces are reflected in parameters, some standardized and some not, but these are related to a limited number of perceptual attributes of human response. In general, these objective parameters cannot accurately describe the acoustic details due to their inherent simplification. Under these premises, impulse responses (576 receivers) are measured in 16 concert halls, according to standard procedures, and the perception and satisfaction of the occupants of the rooms are evaluated by …
A novel approach to current transformer characterization in the presence of harmonic distortion
2009
The current transformer (CT) performance under distorted waveform conditions is usually characterized by means of the frequency-response test. In this paper, a new way to characterize CTs, closer to real operation conditions, is proposed. The harmonic phase-angle and ratio errors are measured using a nonsinusoidal current composed of fundamental and one harmonic with adjustable phase shift. The new method was tested by determining the performance of two metering class CTs commonly used by the Italian power company. The errors measured using the proposed approach are larger than the ones obtained with the frequency response. This result suggests that the frequency-response approach for the e…