Search results for "Amorphous solid"

Annealing of radiation induced oxygen deficient point defects in amorphous silicon dioxide: evidence for a distribution of the reaction activation en…

2011

The selective annealing of point defects with different activation energies is studied, by performing sequences of thermal treatments on gamma irradiated silica samples in the temperature range 300-450 °C. Our experiments show that the dependence on time of the concentration of two irradiation induced point defects in silica, named ODC(II) (standing for oxygen deficient centre II) and the E(γ)(') centre, at a given temperature depends on the thermal history of the sample for both of the centres studied; moreover in the long time limit this concentration reaches an asymptotic value that depends on the treatment temperature alone. These results suggest the existence of a distribution of the a…

Low-temperature Zr mobility: An in-situ synchrotron-radiation XRF study of the effect of radiation damage in zircon on the element release in $H_{2}O…

2006

The release of Zr, U, and Pb from nearly metamict zircon and its recrystallized analog and of Zr from fully crystalline and slightly radiation-damaged zircon in H 2 O + HCl ± SiO 2 fluids was investigated in situ at temperatures between 200 and 500 °C using a hydrothermal diamond-anvil cell and time-resolved synchrotron-radiation XRF analyses. Dissolution of nearly metamict zircon proceeded much faster than that of zircon with little or no radiation damage and resulted in a 1.5 to 2 log units higher Zr molality in 6 to 7 m HCl fluids. Extensive recrystallization of the almost fully amorphous material started at 260 to 300 °C in H 2 O + HCl, and at about 360 °C if quartz was added, and was c…

Role of Water During Crystallization of Amorphous Cobalt Phosphate Nanoparticles

2016

The transformation of amorphous precursors into crystalline solids and the associated mechanisms are still poorly understood. We illuminate the formation and reactivity of an amorphous cobalt phosphate hydrate precursor and the role of water for its crystallization process. Amorphous cobalt phosphate hydrate nanoparticles (ACP) with diameters of ∼20 nm were prepared in the absence of additives from aqueous solutions at low concentrations and with short reaction times. To avoid the kinetically controlled transformation of metastable ACP into crystalline Co3(PO4)2 × 8 H2O (CPO) its separation must be fast. The crystallinity of ACP could be controlled through the temperature during precipitati…

Anhydrous Amorphous Calcium Oxalate Nanoparticles from Ionic Liquids: Stable Crystallization Intermediates in the Formation of Whewellite

2015

The mechanisms by which amorphous intermediates transform into crystalline materials are not well understood. To test the viability and the limits of the classical crystallization, new model systems for crystallization are needed. With a view to elucidating the formation of an amorphous precursor and its subsequent crystallization, the crystallization of calcium oxalate, a biomineral widely occurring in plants, is investigated. Amorphous calcium oxalate (ACO) precipitated from an aqueous solution is described as a hydrated metastable phase, as often observed during low-temperature inorganic synthesis and biomineralization. In the presence of water, ACO rapidly transforms into hydrated whewe…

O2 Diffusion in Amorphous SiO2 Nanoparticles Probed by Outgassing

2012

An experimental study of the O2 diffusion process in nanoparticles of amorphous SiO2 in the temperature range from 98 to 157 °C was carried out by Raman and photoluminescence techniques. We studied O2 diffusion in high purity silica nanoparticles with a mean diameter of 14, 20, and 40 nm detecting the outgassing of molecules trapped during the manufacturing. The kinetics of diffusion is well described for all the investigated nanoparticles by the Fick’s equation proving its applicability to nanoscale systems. The diffusion coefficient features an Arrhenius law temperature dependence in the explored temperature range, and the diffusion coefficient values are in good agreement with extrapolat…

2017

Abstract. Eleven particle samples collected in the polar stratosphere during SOLVE (SAGE III Ozone loss and validation experiment) from January until March 2000 were characterized in detail by high-resolution transmission and scanning electron microscopy (TEM/SEM) combined with energy-dispersive X-ray microanalysis. A total of 4202 particles (TEM  =  3872; SEM  =  330) were analyzed from these samples, which were collected mostly inside the polar vortex in the altitude range between 17.3 and 19.9 km. Particles that were volatile in the microscope beams contained ammonium sulfates and hydrogen sulfates and dominated the samples. Some particles with diameters ranging from 20 to 830 nm were re…

Reactivity of H2S and H2S/H2 Mixture With Molybdenum Oxide Thin Films Epitaxied on CoO (100) : Characterization by Rheed and Auger Spectroscopy

2010

Molybdenum-Cobalt composite oxide films were prepared by the evaporation of molybdenum trioxide on a fresh cleaved CoO (100) surface (Thickness = 10 A). The MoO3-CoO interface has been characterized simultaneously by reflexion high electron diffraction (RHEED) and Auger Electron Spectroscopy (AES). The thin film structure and composition depend on the annealing temperature. After a 300°C treatment, metallic cobalt islands nucleate at the interface thin film - CoO (100) and crystallize with the cubic FCC symmetry. After a 700°C treatment cobalt molybdate (a CoMoO4) islands grow. The metastable crystallites are epitaxied on CoO (100). After a 900°C treatment, the thin film consists of flat tw…

Microstructural evolution of wear-resistant FeCrB and FeCrNiCoB coating alloys during high-energy mechanical attrition

2008

Mechanical milling/attrition provides a convenient scope of simulating the microstructural changes encountered by wear-resistant coating alloys subjected to deformation under high frequency and high-intensity impact loading or accelerated wear condition. In the present study, the microstructural evolution of two commercial coating materials, FeCrB (Armacor M) and FeCrNiCoB (Armacor C), in the course of low- and high-intensity mechanical attrition, was monitored by X-ray diffraction and high-resolution transmission electron microscopy. While low-intensity milling leads to marginal grain refinement but no change in phase-aggregate in FeCrB, similar mechanical attrition causes boride precipita…

<title>Performance problems of electrochromic coatings</title>

2003

The performance is actual problem of electrochromic coatings. The service and shelf life and cycling capacity are main performance characteristics. By solid-state ionics point of view any electrochromic cell based on phenomena with ion insertion - extraction processes is functioning as solid-state rechargeable battery. The main performance characteristics of electrochromic cells are similar. Performance of electrochromic coatings based on amorphous WO3 films and protons conducting electrolytes is limited by reversibility of ion insertion-extraction reactions, which causes degradation of cell components. The migration of water in the cell and hydration together with ion insertion-extraction …

Ordering the amorphous – Structures in PBD LED materials

2012

Abstract The class of 2,5 disubstituted-1,3,4-oxadiazoles containing a biphenyl unit on one side is intensively used as electron transport materials to enhance the performance of organic light emitting diodes (OLEDs). In contrast to the ongoing research on these materials insights in their structure-property relationships are still incomplete. To overcome the structural tentativeness and ambiguities the crystal structures of 2-(4-biphenylyl)-5-(4-tert-butylphenyl)-1,3,4-oxadiazole, that of the related compound 2-(4-biphenylyl)-5-phenyl-1,3,4-oxadiazole and of 2-(4-biphenylyl)-5-(2,6-dimethylphenyl)-1,3,4-oxadiazole are determined. A comparison with the results of GAUSSIAN03 calculations and…