Search results for "Amperometry"
showing 10 items of 28 documents
Electrochemical deposition of aniline derivatives for conductometric gas sensors
2019
International audience; Polymer film of poly(2,3,5,6-tetrafluoroaniline) (PTFA) were electroplated on ITO substrate from acidic medium by chronoamperometry. Electrochemical and morphological characterizations were performed and compared to polyaniline properties similarly coated. It seemed that PTFA film had an irreversible redox response with poor conductivity due to the absence of acid-base doping. This film were then incorporated in a patented device called MSDI heterojunction to perform ammonia sensing in humid atmosphere.
Amperometric detection of extended-spectrum β-lactamase activity : application to the characterization of resistant E.coli strains
2015
EA MERS CT3; International audience; The amperometric detection of extended-spectrum β-lactamase (ESBL) with carbon screen-printed sensors was investigated in the presence of the Nitrocefin, a commercially-available β-lactamase chromogenic cephalosporin substrate. Using an ESBL isolated from a clinical sample, it was shown for the first time that the intensity of a specific anodic pic current (EP = [similar]+0.3 V vs. Ag/AgCl) resulting from the catalytic hydrolysis of the β-lactam ring was proportional to the amount of ESBL. The proof-of-principle of a novel susceptibility assay for the rapid and accurate identification of ESBL- producing bacteria was then demonstrated. The detection schem…
Spatially limited diffusion coupled with ohmic potential drop and/or slow interfacial exchange: a new method to determine the diffusion time constant…
2004
Abstract We have analyzed chronoamperometric curves, I ( t ), after small-amplitude potential steps Δ E (PITT technique) for the model of linear diffusion of a species inside an electroactive film, taking into account ohmic effects in the external media (solution and electrode) as well as a finite rate of the interfacial exchange. For its short-time interval, t ≪ τ d ( τ d is the diffusion time constant, corresponding to unlimited diffusion from the interface), three approximate analytical expressions have been proposed. One of these represents an interpolation formula between the value of the current at the start of the diffusion process, I (0)=Δ E / R ext (after the end of the EDL chargin…
Gaseous sensors based on solid proton conductors
1992
Abstract he chemical sensors for different gaseous (alcohol, acetone, ammonia, water vapour) detection at room temperature are developed by using polycrystalline β-alumina and xerogel of antimonic acid hydrate (AAH). The sensitivity and selectivity of sensors depend on the ion-exchange and preparative methods. The possibility of producing different types of potentiometric, amperometric, voltammetric and resistance sensors on the basis of these ion-conducting materials is shown. More success is achieved by producing ammonia-sensitive devices on β-alumina as well as on AAH xerogel.
Determination of hydroquinone and metal in photographic developer by reversed-phase ion-pair chromatography with amperometric detection
1988
Abstract Sodium 1-heptanesulphonate is used as an ion-pair reagent for the chromatographic separation of the two developing agents on a phenylsilica micro-column, with amperometric detection at an applied potential of + 0.75 V (vs. Ag/AgCl). No pretreatment of the developer is necessary. Linear calibration graphs were obtained in the range 10 −5 -1.5 × 10 −4 M.
Direct injection of physiological fluids in micellar liquid chromatography
2000
Abstract Micellar liquid chromatography (MLC), which uses mobile phases of surfactants above the critical micellar concentration, provides a solution to the direct injection of physiological samples by solubilizing the protein components, and coating the analytical column with surfactant monomers to avoid clogging. A review showing the advantages and limitations of this technique over other chromatographic techniques used in drug analysis, working protocols, and examples of application is presented. The possibility of direct sample introduction simplifies and greatly expedites the treatments with reduced cost, improving the accuracy of the procedures. Surfactant monomers and micelles appear…
Electrochemical incineration of oxalic acid at boron doped diamond anodes: Role of operative parameters
2008
The electrochemical incineration of oxalic acid (OA) at boron doped diamond (BDD) anodes was investigated both theoretically and experimentally in order to find the influence of the operative parameters on the performances of the process. Polarization curves and chronoamperometric measurements indicate the probable occurrence of a direct electrochemical oxidation of OA at the surface of the BDD anode at low pH and of a hydroxyl radical-mediated reaction at high pH. When incineration electrolyses are performed at low pH with potentiostatic alimentation, a dramatic influence of the potential is observed. In amperostatic incineration, high CE are obtained when most part of the process was unde…
An electrochemical quartz crystal microbalance study of lithium insertion into thin films of tungsten trioxide II. Experimental results and compariso…
1995
Abstract Lithium insertion into amorphous thin films of tungsten trioxide (a-WO 3 ) prepared by thermal vacuum evaporation of WO 3 powder has been studied experimentally by chronoamperometry, cyclic voltammetry and ac impedance spectroscopy associated with electrochemical quartz crystal microbalance (EQCM). During cathodic polarization of the electrode and at short times two antagonistic processes occur. One is a non faradaic process and is associated with the expulsion of anions from the electrode surface under the effect of the electric field built in the electrolyte when a potential difference is imposed between the electrodes. The other one is the faradaic insertion of non-solvated lith…
Electrochemical performance of activated screen printed carbon electrodes for hydrogen peroxide and phenol derivatives sensing
2019
Screen-printed carbon electrodes (SPCEs) are widely used for the electroanalysis of a plethora of organic and inorganic compounds. These devices offer unique properties to address electroanalytical chemistry challenges and can successfully compete in numerous aspects with conventional carbon-based electrodes. However, heterogeneous kinetics on SPCEs surfaces is comparatively sluggish, which is why the electrochemical activation of inks is sometimes required to improve electron transfer rates and to enhance sensing performance. In this work, SPCEs were subjected to different electrochemical activation methods and the response to H2O2 electroanalysis was used as a testing probe. Changes in to…
An electrochemical quartz crystal microbalance study of lithium insertion into thin films of tungsten trioxide I. Modeling of the ionic insertion mec…
1995
A theoretical description of the mechanism of lithium insertion into amorphous thin films of tungsten trioxide (a-WO3) prepared by thermal vacuum evaporation of WO3 powder is presented. The model developed is based on the experimental results obtained by chronoamperometry and ac impedance spectroscopy associated with electrochemical quartz crystal microbalance (EQCM). The electrode mass change and the current flowing through the electrochemical cell during cathodic polarization are simulta neously recorded. As expected, it can be observed that the insertion process is associated with a gain of mass of the inserted electrode at long times (t > 1 s). On the other hand at short times (t < 1 s)…