Search results for "Automatic repeat request"
showing 10 items of 21 documents
Link Adaptation Thresholds for the IEEE 802.16 Base Station
2008
The IEEE 802.16 technology defines a number of modulation and coding schemes that the base station can use to achieve the best tradeoff between the spectrum efficiency and the resulting application level throughput. However, the 802.16 specification does not define any particular link level adaptation algorithm, neither does it specify the SNR thresholds to switch between modulation and coding schemes. In this paper we consider a link adaptation model and conduct a number of simulation runs to find transition thresholds for ARQ and HARQ retransmission mechanisms. All the simulations are done with the 802.16 extension for the NS-2 simulator.
Increasing the VoIP Capacity through MAP Overhead Reduction in the IEEE 802.16 OFDMa Systems
2010
One of the main issues with supporting VoIP service over 802.16 networks is the signalling overhead caused by the downlink MAP messages due to frequent transmissions and small packets. To decrease the MAP overhead, the 802.16 standard proposes some mechanisms, such as the compressed MAP and sub-MAPs. In this paper, we show by means of extensive dynamic simulations that sub-MAPs can reduce dramatically the signalling overhead associated with VoIP traffic and significantly improve overall VoIP capacity. At the same time, since sub-MAPs are more sensitive to packet drops, they tend to increase the number of HARQ retransmissions in downlink and transmission delays in the uplink direction.
Analysis of the Non-Transparent In-Band Relays in the IEEE 802.16 Multi-Hop System
2010
This paper presents extensive dynamic simulations of the non-transparent in-band relays working in the distributed scheduling mode. The simulation results show that in-band relays can improve noticeably the spectral efficiency without acquiring an additional radio spectrum. Also, packet transmission delays become smaller. An important outcome of the dynamic simulations is that it is very crucial to choose a correct relay zone size where the base station and relay nodes exchange data. Otherwise, throughput fairness of the whole system declines. It indicates an importance of the relay zone size adjustment algorithm that the base station must run.
ARQ parameters for VoIP in IEEE 802.16 networks
2009
IEEE 802.16 standard defines two data retransmission mechanisms. HARQ provides fast retransmissions in cost of slightly increased overhead. On the contrary, ARQ has less overhead in cost of bit longer delays. It is therefore often used with BE connections. In addition to delay tolerant applications, BE can also be used for real-time services. Therefore, in this paper we analyze the ARQ mechanism and provide guidelines on how to set the ARQ parameters to achieve a good balance between the VoIP delay and packet loss.
Impact of portable device restrictions on IEEE 802.16 performance
2008
IEEE 802.16 is a good alternative for fast wireless connection in the next generation portable information devices (PID). However it was not originally designed for portable devices, but mobility was added later to the specification. This means that the lack of resources on portable devices might have a significant impact on which IEEE 802.16 features should be chosen and how they should be used. Proper usage of ARQ can increase the IEEE 802.16 performance but it can also require much resources from PIDs. In this paper we focus on how ARQ features are affected by limited resources on PID and how much the limitations affect on the performance.
Formal verification of a Cooperative Automatic Repeat reQuest MAC protocol
2012
Author's version of an article published in the journal: Computer Standards & Interfaces. Also available from the publisher at: http://dx.doi.org/10.1016/j.csi.2011.12.001 Cooperative communications, in which a relay node helps the source node to deliver its packets to the destination node, are able to obtain significant benefits in terms of transmission reliability, coverage extension and energy efficiency. A Cooperative Automatic Repeat reQuest (C-ARQ) MAC protocol has been recently proposed to exploit cooperative diversity at the MAC layer. in this paper, we validate the integrity and the validity of the C-ARQ protocol using formal methods. The protocol logic is modeled in SDL and implem…
Optimization of the Relay Selection Scheme in Cooperative Retransmission Networks
2011
Cooperative MAC protocol design has attracted much attention recently thanks to the development of relaying techniques. In single-relay C-ARQ, the relay selection scheme cannot work efficiently in a dense network, due to high collision probability among different contending relays. In this paper, the throughput performance impairment from the collision is analysed in a typical network scenario. Thereby, we propose an optimized relay selection scheme aiming at maximizing system throughput by reducing collision probability. The throughput performance enhancement by the proposed optimal relay selection scheme is verified by simulations.
On the performance of hybrid-ARQ with code combining over double rayleigh fading channels
2011
In this paper, we study the performance of hybrid automatic repeat request (HARQ) with code combining (CC) over double Rayleigh channels. This channel can be utilized to model the fading envelope of vehicle-to-vehicle (V2V) channels. We derive analytical solutions for the characteristic quantities of double Rayleigh channels, such as the outage probability, the ergodic capacity, and the bit error probability (BEP). Moreover, we study the performance of HARQ with CC. Our analysis focuses on information theoretic aspects of HARQ with CC. closed-form analytical approximations are derived for the e-outage capacity, the average number of transmissions, and the average transmission rate of HARQ w…
An optimal energy efficient cooperative retransmission MAC scheme in wireless networks
2011
While the benefits of cooperative diversity have been well studied in the literature, cooperative MAC protocol design has also attracted much attention recently. In the single-relay Cooperative Automatic Repeat reQuest (C-ARQ) protocol, the best relay node is selected in a distributed manner by relays using different backoff time before packet retransmission. However, this relay selection scheme does not work efficiently in a dense network scenario, due to possible high collision probability among different contending relays. In this paper, we propose an optimized relay selection scheme to maximize system energy efficiency by reducing collision probability. The energy efficiency performance…
A Multi-Relay Cooperative Automatic Repeat Request Protocol in Wireless Networks
2010
This paper proposes a Multi-relay Cooperative Automatic Repeat ReQuest protocol (MC-ARQ) for IEEE 802.11 based wireless networks. The proposed distributed relay selection scheme not only selects the best relays but also solves the collision problem among multiple contending relays, by sorting the relays in the network according to their instantaneous channel quality with the destination node. No prior information or explicit signaling among relay nodes is required. Both analytical and simulation results show that significant benefits can be achieved with the MC-ARQ protocol, compared with both the recently proposed PRCSMA scheme and the original non-cooperative DCF scheme.