Search results for "BAND"
showing 10 items of 2610 documents
Estimation of solar-induced vegetation fluorescence from space measurements
2007
[1] A characteristic spectral emission is observed in vegetation chlorophyll under excitation by solar radiation. This emission, known as solar-induced chlorophyll fluorescence, occurs in the red and near infra-red spectral regions. In this paper a new methodology for the estimation of solar-induced chlorophyll fluorescence from spaceborne and airborne sensors is presented. The fluorescence signal is included in an atmospheric radiative transfer scheme so that chlorophyll fluorescence and surface reflectance are retrieved consistently from the measured at-sensor radiance. This methodology is tested on images acquired by the Medium Resolution Imaging Spectrometer (MERIS) on board the ENVIron…
Soot particle properties in the microwave range
1993
This paper outlines the study of Diesel soot particle properties in the frequency band 2.0-40.0 GHz. Using a transmission/reflection as well as a cavity perturbation method, the complex dielectric constant ?* = ?1 - j?2 was measured for multiple of samples (soot particles produced in a Diesel engine and deposited on paper filter). From the analysis of the experimental data the following conclusions appear: The complex dielectric constant - i.e. the HF electrical conductivity and the microwave power absorption efficiency - are dependent on the frequency and the soot particle thickness. Increasing the soot particle thickness causes the reflection to be stronger and results in less influence o…
Optimization of anodizing process of tantalum for Ta2O5-based capacitors
2020
Anodic oxides were grown to 50 V on Ta in several organic ions containing anodizing baths. Their properties were compared with anodic Ta oxide film grown to the same formation voltage in 0.1 M NaOH. Anodizing process carried out in sodium citrate led to the growth of the anodic oxide with the best blocking properties whilst, when Ta is anodized in sodium adipate, a significant part of the circulated charge is wasted in side reactions, such as oxygen evolution. Photoelectrochemical measurements showed the presence of optical transitions at energy lower than the band gap for the anodic films grown in citrate and tartrate electrolytes, attributed to localized electronic states located close to…
Electron transfer in ZnO–Fe2O3 aqueous slurry systems and its effects on visible light photocatalytic activity
2017
ZnFex (x = 0.025, 0.05, and 0.1) nanocomposites and pure ZnO and Fe2O3 photocatalysts were synthesized by a simple sol–gel route and characterized by means of specific surface area (SSA) analysis, X-ray diffraction (XRD), diffuse reflectance spectroscopy (DRS), and transmission electron microscopy/energy dispersive X-ray spectroscopy (TEM/EDS). Their photocatalytic activity was investigated under visible light by using methylene blue (MB) and benzoic acid (BA) as model compounds. Coupling ZnO and Fe2O3 results in higher photocatalytic activity with respect to the pure materials. Photoelectrochemical characterization performed in slurry systems allowed the elucidation of the electronic struc…
The influence of Al doping on the photocatalytic activity of nanostructured ZnO: The role of adsorbed water
2018
Abstract Al doped ZnO nanoparticles (labeled as x% A-ZnO, x = 0.0, 0.5, 1.0, and 1.5) were synthesized by a simple sol-gel method, characterized and tested as photocatalysts for the degradation of a model compound under UV-light irradiation. Diffuse reflectance spectroscopy (DRS) and photoelectrochemical analysis have been performed to evidence their optical and electronic behavior. The structural features of the powders were highlighted by means of specific surface area (SSA) analysis, X-ray diffraction (XRD), Fourier-transform infrared (FTIR) and Raman spectroscopy. Al doping results in enhanced photocatalytic activity of the modified powders with respect to pure ZnO. In particular, the h…
Enhancement of calcium copper titanium oxide photoelectrochemical performance using boron nitride nanosheets
2020
International audience; Photoelectrochemical water splitting under visible light has attracted attention for renewable hydrogen production. Despite prevalent investigations, many challenges still hindered an efficient energy conversion, such as enhancing the reaction efficiency in visible light. Thus controlling the photoelectrode materials is an essential step in designing new materials for water splitting. CaCu3Ti4O12 (CCTO) has received great attention as photocatalyst under solar light due to its combined band gap as result of the presence in its structure of TiO2 active in UV light and CuO active under visible light. In this work, a cubic CCTO with different amount of exfoliated hexago…
Photoactivity under visible light of metal loaded TiO2 catalysts prepared by low frequency ultrasound treatment
2017
Abstract Visible-light responsive bare and metal loaded (Pt, Ag, Rh, Pd) TiO 2 photocatalysts were prepared by using a simple ultrasound treatment. This method induced bulk oxygen deficiency resulting in a narrowing bandgap (from 3.18 to 3.04 eV) and in visible light absorption. The samples were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), BET specific surface area (SSA) and pore size distribution (PSD), UV–vis diffuse reflectance spectroscopy (DRS), Raman spectroscopy and X-ray photoelectron spectroscopy (XPS). The photocatalytic activity of the samples was evaluated by using the 4-nitrophenol oxidation reaction and the photocatalytic oxidation of glucose w…
C-, N-, S-, and Fe-Doped TiO2 and SrTiO3 Nanotubes for Visible-Light-Driven Photocatalytic Water Splitting: Prediction from First Principles
2015
The ground state electronic structure and the formation energies of both TiO2 and SrTiO3 nanotubes (NTs) containing CO, NO, SO, and FeTi substitutional impurities are studied using first-principles calculations. We observe that N and S dopants in TiO2 NTs lead to an enhancement of their visible-light-driven photocatalytic response, thereby increasing their ability to split H2O molecules. The differences between the highest occupied and lowest unoccupied impurity levels inside the band gap (HOIL and LUIL, respectively) are reduced in these defective nanotubes down to 2.4 and 2.5 eV for N and S doping, respectively. The band gap of an NO+SO codoped titania nanotube is narrowed down to 2.2 eV …
Electronic structure of MnAl3+- and MnAl2+-doped YAlO3: Prediction from the first principles
2018
Abstract The atomic structure and electronic properties of Mn3+ and Mn2+ ions substituted for the host Al at YAlO3 have been studied from the first principles. The 2 × 2 × 2 supercell adopted for the bulk crystal phase of P b n m symmetry allows us to simulate substitutional point defect with concentration of about 3%. To perform ab initio modeling of Mn-doped YAlO3 we were using approach of hybrid exchange-correlation functional HSE within density functional theory. We predict a decrease of the Mn O bond covalency in the doped crystal with respect to the Al O bond of ideal orthorhombic YAlO3. Relatively large displacement of Y and Al atoms nearest to the F 0 -center inserted to stabilize t…
Quantum chemical simulations of doped ZnO nanowires for photocatalytic hydrogen generation
2016
Zinc oxide (ZnO) is considered in general as a promising material for solar water splitting. Its wurtzite-structured bulk samples, however, can be considered as active for photocatalytic applications only under UV irradiation, where they possess ∼1% efficiency of sunlight energy conversion due to their wide band gap (3.4 eV). Although pristine ZnO nanowires (NWs) possess noticeably narrower band gaps than the bulk, the tendency of band gap reduction with increasing NW diameter is insufficient, and further modification is required. We have contributed to filling this gap by performing a series of ab initio calculations on ZnO NWs of different diameters (dNW), which are mono-doped by metal (A…