Search results for "BEAMS"

Characterisation and mitigation of beam-induced backgrounds observed in the ATLAS detector during the 2011 proton-proton run

2013

This paper presents a summary of beam-induced backgrounds observed in the ATLAS detector and discusses methods to tag and remove background contaminated events in data. Triggerrate based monitoring of beam-related backgrounds is presented. The correlations of backgrounds with machine conditions, such as residual pressure in the beam-pipe, are discussed. Results from dedicated beam-background simulations are shown, and their qualitative agreement with data is evaluated. Data taken during the passage of unpaired, i.e. non-colliding, proton bunches is used to obtain background-enriched data samples. These are used to identify characteristic features of beam-induced backgrounds, which then are …

The positioning system of the ANTARES Neutrino Telescope

2012

The ANTARES neutrino telescope, located 40km off the coast of Toulon in the Mediterranean Sea at a mooring depth of about 2475m, consists of twelve detection lines equipped typically with 25 storeys. Every storey carries three optical modules that detect Cherenkov light induced by charged secondary particles (typically muons) coming from neutrino interactions. As these lines are flexible structures fixed to the sea bed and held taut by a buoy, sea currents cause the lines to move and the storeys to rotate. The knowledge of the position of the optical modules with a precision better than 10cm is essential for a good reconstruction of particle tracks. In this paper the ANTARES positioning sys…

Failure analysis of normally-off GaN HEMTs under avalanche conditions

2020

Gallium nitride (GaN) high electron-mobility transistors (HEMTs) are promising devices in the power electronics field owing to their wide bandgap (WBG). However, all the potential advantages provided by their WBG require reliability improvement. In industrial applications, robustness is one of the main factors considered by circuit designers. This study focuses on the observation of the degradation behavior of the main waveforms of unclamped inductive-switching (UIS) test circuits of two different commercial GaN HEMT structures. The relevance of this study lies in the potential applications of these devices to high-voltage applications and automotive systems where they are subjected to many…

Measurement of proton electromagnetic form factors in the time-like region using initial state radiation at BESIII

2021

Physics letters / B 817, 136328 (2021). doi:10.1016/j.physletb.2021.136328

Tevatron Combination of Single-Top-Quark Cross Sections and Determination of the Magnitude of the Cabibbo-Kobayashi-Maskawa Matrix Element Vtb

2015

et al.

2021

Purpose First, this experimental study aims at comparing out-of-field doses delivered by three radiotherapy techniques (3DCRT, VMAT (two different accelerators), and tomotherapy) for a pediatric renal treatment. Secondly, the accuracy of treatment planning systems (TPS) for out-of-field calculation is evaluated. Methods EBT3 films were positioned in pediatric phantoms (5 and 10 yr old). They were irradiated according to four plans: 3DCRT (Clinac 2100CS, Varian), VMAT (Clinac 2100CS and Halcyon, Varian), and tomotherapy for a same target volume. 3D dose determination was performed with an in-house Matlab tool using linear interpolation of film measurements. 1D and 3D comparisons were made be…

Optimizing charge breeding techniques for ISOL facilities in Europe: conclusions from the EMILIE project

2015

ThuM07; International audience; The present paper summarizes the results obtained from the past few years in the framework ofthe Enhanced Multi-Ionization of short-Lived Isotopes for Eurisol (EMILIE) project. The EMILIEproject aims at improving the charge breeding techniques with both Electron Cyclotron ResonanceIon Sources (ECRIS) and Electron Beam Ion Sources (EBISs) for European Radioactive Ion Beam(RIB) facilities. Within EMILIE, an original technique for debunching the beam from EBIS chargebreeders is being developed, for making an optimal use of the capabilities of CW post-acceleratorsof the future facilities. Such a debunching technique should eventually resolve duty cycle andtime st…

Elastic scattering studies of 16C at 50 MeV/A on proton and deuteron targets with the CHIMERA multidetector at INFN-LNS

2012

At the Laboratori Nazionali del Sud (LNS) in Catania (Italy), light radioactive ion beams have been produced through the In Flight Fragmentation method, using 18O and 13C at 55 MeV/A as primary beams impinging on a 9Be production target. Elastic scattering angular distributions of 16C+p and 16C+d at 50 MeV/A, 10Be+p at 56 MeV/A and 13B+d at 52 MeV/A systems were measured by using the CHIMERA (Charge Heavy Ion Mass and Energy Resolving Array) multidetector and kinematical coincidence technique. The experimental data are fitted by using the optical model. © Published under licence by IOP Publishing Ltd.

A complementary laser system for ISOLDE RILIS

2011

The Resonance Ionization Laser Ion Source (RILIS) is a powerful tool for efficient and selective production of radioactive ion beams at Isotope Separator On Line (ISOL) facilities. To avoid isobaric background, highly selective stepwise resonant ionization is applied, using up to three different laser wavelengths. Due to their advantages in terms of stability and reliability, an all solid-state titanium:sapphire (Ti:Sa) system is used or is planned to be installed at the majority of on-line facilities worldwide. Such an all solid-state Ti:Sa laser system is going to be installed at the ISOLDE RILIS at CERN alongside the well-established dye laser system.

The Miniball spectrometer

2013

The Miniball germanium detector array has been operational at the REX (Radioactive ion beam EXperiment) post accelerator at the Isotope Separator On-Line facility ISOLDE at CERN since 2001. During the last decade, a series of successful Coulomb excitation and transfer reaction studies have been performed with this array, utilizing the unique and high-quality radioactive ion beams which are available at ISOLDE. In this article, an overview is given of the technical details of the full Miniball setup, including a description of the γ-ray and particle detectors, beam monitoring devices and methods to deal with beam contamination. The specific timing properties of the REX-ISOLDE facility are hi…