Search results for "Biomedical"
showing 10 items of 2328 documents
Connected pathway relative permeability from pore-scale imaging of imbibition
2016
Abstract Pore-scale images obtained from a synchrotron-based X-ray computed micro-tomography (µCT) imbibition experiment in sandstone rock were used to conduct Navier–Stokes flow simulations on the connected pathways of water and oil phases. The resulting relative permeability was compared with steady-state Darcy-scale imbibition experiments on 5 cm large twin samples from the same outcrop sandstone material. While the relative permeability curves display a large degree of similarity, the endpoint saturations for the µCT data are 10% in saturation units higher than the experimental data. However, the two datasets match well when normalizing to the mobile saturation range. The agreement is p…
Preparation and antioxidant activity of Radix Astragali residues extracts rich in calycosin and formononetin
2011
Abstract Radix Astragali is considered an excellent source of Traditional Chinese Medicine and a kind of famous restorative food. To make full usage of Radix Astragali, calycosin and formononetin were enriched through various macroporous resins from its residues, HPD500 resin, compared with other resins, offered the best effectiveness for the enrichment and separation of compounds. 35 °C was selected for its highest adoption capacity during static adsorption process, which can be obtained from adsorption isotherms. And then dynamic adsorption and desorption tests were carried out to optimize the operating parameters. After one run treatment with HPD500 resin, the contents of calycosin and f…
Free surface oxygen transfer in large aspect ratio unbaffled bio-reactors, with or without draft-tube
2015
Abstract It is widely accepted that animal cell damage in aerated bioreactors is mainly related to the bursting of bubbles at the air–liquid interface. A viable alternative to sparged bioreactors may be represented by uncovered unbaffled stirred tanks, which have been recently found to be able to provide sufficient mass transfer through the deep free surface vortex which takes place under agitation conditions. As a matter of fact, if the vortex is not allowed to reach impeller blades, no bubble formation and subsequent bursting at the free-surface, along with relevant cells damage, occurs. In this work oxygen transfer performance of large aspect ratio unbaffled stirred bioreactors, either e…
BIOALGA reactor: preliminary studies for heavy metals removal
2002
Abstract Microalgae have a high affinity for polyvalent metals, for that reason they could be used to reduce the concentration of heavy metals present in water and wastewater. In the present work an evaluation of a rotary biofilm reactor for algae immobilization (BIOALGA) with the subject of heavy metal removal was investigated. The BIOALGA reactor consisted of a pilot scale model that was operated with synthetic wastewater with an initial concentration of 3000 μg/l of cobalt ion. Scenedesmus obliquus was immobilized in the reactor, which was operated in batch mode for a period of 20 days. The rotary velocity used, 2 rpm, was constant during the experiment. A maximum removal of cobalt ion o…
Greenhouse gases from sequential batch membrane bioreactors: A pilot plant case study
2016
Abstract The paper reports the results of nitrous oxide (N 2 O) emissions from aerobic and anoxic tank of a Sequential Batch Membrane Bioreactor (SB-MBR) pilot plant. The influence of salinity variation on N 2 O emission was analyzed by gradually increasing the inlet salt concentration from 0 to 10 g NaCl L −1 . The observed results showed that the N 2 O concentration of the gaseous samples was strongly influenced by the salt concentration. This result was likely related to a worsening of the nitrification activity due to the effect of salinity on autotrophic bacteria. Dissolved oxygen concentration and salinity were found to be the key factors affecting N 2 O concentration in the gaseous s…
Mathematical and numerical modeling of an airlift perfusion bioreactor for tissue engineering applications
2022
The Tissue Engineering (TE) strategy is widely focused on the development of perfusion bioreactors to promote the production of three-dimensional (3D) functional tissues. To optimize tissue production, it is worth investigating the engineering parameters of a bioreactor system for identifying a beneficial range of operation variables. Mathematical and numerical modeling of a perfusion bioreactor is capable to provide relevant insights into the fluid flow and nutrients transport while predicting experimental data and exploring the impact of changing operating parameters, such as fluid velocities. In this work, the hydrodynamic parameters and oxygen transport were investigated using mathemati…
Moving bed membrane bioreactors for carbon and nutrient removal: The effect of C/N variation
2017
In this paper, an experimental campaign was carried out on a University of Cape Town Integrated Fixed Film Activated Sludge Membrane Bioreactor (UCT-IFAS-MBR) pilot plant. The aim of the study was to evaluate the effect of the influent C/N ratio on the system performance in terms of organic carbon, nitrogen and phosphorus removal, biomass viability (through respirometry), activated sludge features and membrane filtration properties. The experiments were organized into three phases, characterized by a variation of the C/N ratio (namely, Phase I: C/N= 5, Phase II: C/N =10; Phase III: C/N = 2). The results highlighted that the system performance was significantly affected by C/N ratio. The rem…
The role of EPS in the foaming and fouling for a MBR operated in intermittent aeration conditions
2016
Abstract This work investigates the causes of foaming and fouling in an Intermittent Aerated – Membrane BioReactor (IA-MBR) used for wastewater treatment. The experiment was divided into three periods with different aerated regimes expressed with different t aeration /t cycle ratio (Period I: 60 min/180 min, Period II: 80 min/180 min, Period III: 30 min/90 min). The advanced foaming tests used allow the study of the role of extracellular polymeric substances (EPSs) on foaming and fouling. In general, in the Periods I and II, good correlations between the EPSs and the Modified Scum Index without purification (MSI 0 ) and the Foam Power were observed. The results shown that the filamentous mi…
Standards not that standard
2015
There is a general assent on the key role of standards in Synthetic Biology. In two consecutive letters to this journal, suggestions on the assembly methods for the Registry of standard biological parts have been described. We fully agree with those authors on the need of a more flexible building strategy and we highlight in the present work two major functional challenges standardization efforts have to deal with: the need of both universal and orthogonal behaviors. We provide experimental data that clearly indicate that such engineering requirements should not be taken for granted in Synthetic Biology. Electronic supplementary material The online version of this article (doi:10.1186/s1303…