Search results for "Bragg Grating"
showing 10 items of 159 documents
Automatic tunable and reconfigurable fiberoptic microwave filters based on a broadband optical source sliced by uniform fiber Bragg gratings.
2002
We demonstrate an automatic tunable transversal notch filter based on uniform fiber Bragg gratings and a broadband optical source. High tunability can be performed by stretching the fiber with the gratings written in series. Also, high sidelobe supression can be achieved by introducing tunable attenuators in a parallel configuration of the gratings.
Tunable and reconfigurable microwave filter by use of a Bragg-grating-based acousto-optic superlattice modulator
2005
We present an all-optical novel configuration for implementing multitap transversal filters by use of a broadband source sliced by fiber Bragg grating arrays generated by propagating an acoustic wave along a strong uniform fiber Bragg grating. The tunability and reconfigurability of the microwave filter are demonstrated.
Accurate tuning of mismatched twin-core fiber filters
1998
We have demonstrated a reproducible and accurate way of tuning the coupling wavelength of a mismatched twin-core filter. This method allows high quality all-fiber filters to be implemented with low loss at any desired wavelength over a range of few hundred nanometers from the same fiber. An ~500-nm tuning range is demonstrated, limited only by the measurement setup and not by the technique itself. Highly accurate control of the filtering wavelength in combination with control of filtering strength by adjustment of the length of the twin-core fibers allows complex filter profiles to be implemented by cascading of several different filters. These filters are also very stable to a change in te…
Simultaneous measurement of temperature and strain in glass fiber/epoxy composites by embedded fiber optic sensors: II. Post-cure testing
2007
In this paper the use of fiber optic sensors embedded into GFRP laminates for structural health monitoring of thermo-mechanical loads is presented. The proposed sensing system, consisting of two coupled fiber Bragg grating (FBG) sensors, allows the simultaneous measurement of both temperature and strain by decoupling the change in reflected wavelength induced by temperature variations from that induced by either mechanical or apparent strain, with significant advantages either for monitoring the composite cure kinetics, as described in the accompanying paper (Part I), or for assessing the structural response to thermo-mechanical loads. Both thermal ramp and mechanical static/dynamic bending…
All-Optical Fiber Hanbury Brown & Twiss Interferometer to study 1300 nm single photon emission of a metamorphic InAs Quantum Dot
2016
[EN] New optical fiber based spectroscopic tools open the possibility to develop more robust and efficient characterization experiments. Spectral filtering and light reflection have been used to produce compact and versatile fiber based optical cavities and sensors. Moreover, these technologies would be also suitable to study N-photon correlations, where high collection efficiency and frequency tunability is desirable. We demonstrated single photon emission of a single quantum dot emitting at 1300 nm, using a Fiber Bragg Grating for wavelength filtering and InGaAs Avalanche Photodiodes operated in Geiger mode for single photon detection. As we do not observe any significant fine structure s…
Ultraviolet holographic recording in photopolymers
2011
Norland Optical Adhesive (NOA) acrylate based photopolymers were studied as a medium for Bragg grating fabrication. NOA photopolymers have absorption maximum in near UV region, but they are transparent in visible light region. Photopolymers were irradiated by He-Cd laser 325 nm line interference patterns during holographic recording. In light irradiated regions photopolymerization takes place and volume grating can be recorded. Diffraction efficiency in dependence on sample thickness, recording beams polarization state and intensity was investigated on transmission mode. Enlargement of sample thickness allows to achieve better angular selectivity of diffracted beam, therefore thickness of p…
Experimental observation of temporal dispersion gratings in fiber optics
2017
We experimentally demonstrate a temporal analog to the diffraction optical grating in the Fraunhofer formalism. Using amplitude and phase temporal periodic modulations, we show that the accumulation of dispersion in fiber optics induces the development of temporally well-separated sidebands similar to the spatial orders of diffraction that are commonly observed in an optical grating operating in the far field.
High-efficiency Q-switched erbium fiber laser using a Bragg grating-based modulator
2002
Abstract In this work we analyze the behavior of an erbium-doped fiber laser which is based on a simple scheme. Excitation of the active medium is performed in the 980 nm pump band with a CW semiconductor laser source. Two fiber Bragg gratings acting as mirrors of the Fabry–Perot laser cavity were used. One of these gratings was mounted over a piezoelectric (PZT) element. By applying voltage pulses to the piezoelectric, the laser cavity was temporally modulated and Q-switched laser pulses up to 530 mW peak powers at 3 kHz were obtained. Typical laser emission of 2–3 μs temporal widths and 0.1 nm of optical bandwidth have been achieved when the system was operated at 18.5 kHz repetition rate…
Single-frequency active Q-switched Distributed Fiber Laser Using Acoustic Waves
2007
This letter presents a single mode, actively Q-switched distributed feedback fiber laser. Acoustic pulses are launched into an erbium-doped fiber Bragg grating, resulting in the introduction of a traveling defect. Thus, a transmission peak appears in the reflection band while the pulse travels along the grating. This effect allows the laser to operate in a Q-switched regime, providing optical pulses which repetition rate was continuously tuned up to 10 kHz. Pulses of 168 mW of peak power and 73 ns of temporal width were obtained at low repetition rate.
Polarization switchable Erbium-doped all-fiber laser
2008
We report an experimental study of an erbium-doped all-fiber laser with electrically switchable output polarization. Fiber Bragg grating written in a polarization maintaining optical fiber and attached to a piezo-ceramic actuator is used to commute the polarization state of the laser emission. The laser oscillates at one of two orthogonal polarizations depending on voltage applied to the actuator.