Search results for "Breakdown"
showing 10 items of 97 documents
Effect of 20 MeV Electron Radiation on Long Term Reliability of SiC Power MOSFETs
2023
The effect of 20 MeV electron radiation on the lifetime of the silicon carbide power MOSFETs was investigated. Accelerated constant voltage stress (CVS) was applied on the pristine and irradiated devices and time-to-breakdown ( T BD ) and charge-to-breakdown ( Q BD ) of gate oxide were extracted and compared. The effect of electron radiation on the device lifetime reduction can be observed at lower stress gate-to-source voltage ( V GS ) levels. The models of T BD and Q BD dependence on the initial gate current ( I G0 ) are proposed which can be used to describe the device breakdown behaviour. peerReviewed
Gaining deeper insight into aroma perception: An integrative study of the oral processing of breads with different structures
2017
WOS:000394071900015; International audience; The objective of this study was to investigate for the first time the influence of bread structure, volatile compounds, and oral processing on aroma perception. 3 types of French baguette were created using the same raw ingredients but different bread-making processes; they consequently varied in their crumb and crust structures. We characterized the initial volatile profiles of two bread structural subtypes-namely bread crumb and bread crumb with crust-using proton transfer reaction-mass spectrometry (PTR-MS) headspace analysis. Three types of bread were characterized by thirty-nine ion fragments from m/z 45 to 139. We then conducted a study in …
Tensiostatic studies on formation and breakdown of anodic oxide films on tungsten in acidic chloride solutions
1977
Abstract The anodic behaviour of tungsten in HCl and HCl + KCl solutions has been extensively studied. For each solution, the applied voltage was increased from 1 V up to the breakdown voltage. Values of the current and open circuit voltage decays were recorded. The HCl concentration was varied from 0.05 M to 12 M while appropriate addition to KCl was made to reach assigned molarities of the Cl − ion. The results are discussed and qualitatively interpreted in terms of the different influence of the H + and Cl − ions.
APDs as single-photon detectors for visible and near-infrared wavelengths down to Hz rates
2012
For the SPECTRAP experiment at GSI, Germany, detectors with Single-Photon counting capability in the visible and near-infrared regime are required. For the wavelength region up to 1100 nm we investigate the performance of 2x2 mm^2 avalanche photo diodes (APDs) of type S0223 manufactured by Radiation Monitoring Devices. To minimize thermal noise, the APDs are cooled to approximately -170 deg. C using liquid nitrogen. By operating the diodes close to the breakdown voltage it is possible to achieve relative gains in excess of 2x10^4. Custom-made low noise preamplifiers are used to read out the devices. The measurements presented in this paper have been obtained at a relative gain of 2.2x10^4. …
Breakdown transient study of plasma distributions in a 2.45 GHz hydrogen discharge
2015
Plasma distribution transients associated with the breakdown of a 2.45 GHz hydrogen discharge similar to high current microwave ion sources are studied by means of an ultra-fast frame image acquisition system in visible light range. Eight different plasma distributions have been studied by photographing the 2D projections of the discharge through a transparent plasma electrode. The temporal evolution of images in Balmer-alpha and Fulcher band wavelengths have been recorded associated to atomic and molecular excitation and ionization processes. Some unexpected plasma distributions transient behaviors during breakdown are reported.
Preliminary radiation hardness tests of single photon Si detectors
2010
Single photon Si detectors were fabricated by STMicroelectronics and fully characterized in standard operation conditions and after irradiations. Both single cells and arrays, of dimensions ranging from 5x5 up to 64x64, were electrically tested. The devices operation was studied as a function of the temperature from -25 degrees C to 65 degrees C varying the voltage over breakdown, from 5% up to 20% of the breakdown voltage before and after irradiation using both light ions, 10 MeV B ions to doses in the range 3x10(7)-5x10(10) cm(-2), and X-rays irradiations in the range 0.5-20 krad(Si). Optical characterization was performed using a laser at 659 nm and opportunely chosen filters to vary the…
Influence of low amounts of nanostructured silica and calcium carbonate fillers on the large-area dielectric breakdown performance of bi-axially orie…
2014
Influence of low amounts (1.0-2.0wt-%) of nanostructured silica and calcium carbonate fillers on the large area dielectric breakdown performance of bi-axially oriented polypropylene (BOPP) is analyzed. A multi-breakdown measurement method based on the self-healing breakdown capability of metallized film is utilized for the breakdown characterization in order to cover relatively large total film areas, thus leading to results of higher relevance from the practical point-of-view. The dispersion and distribution qualities of filler particles at the nanoscale are evaluated with transmission electron microscopy (TEM) imaging. Weibull statistical analysis suggests that the breakdown distribution …
Failure analysis of normally-off GaN HEMTs under avalanche conditions
2020
Gallium nitride (GaN) high electron-mobility transistors (HEMTs) are promising devices in the power electronics field owing to their wide bandgap (WBG). However, all the potential advantages provided by their WBG require reliability improvement. In industrial applications, robustness is one of the main factors considered by circuit designers. This study focuses on the observation of the degradation behavior of the main waveforms of unclamped inductive-switching (UIS) test circuits of two different commercial GaN HEMT structures. The relevance of this study lies in the potential applications of these devices to high-voltage applications and automotive systems where they are subjected to many…
Evaluation of carotenoids and furosine content in air dried carrots and parsnips pre-treated with pulsed electric field (PEF)
2019
Carrot and parsnip slices were subjected to hot drying at 50, 60 and 70 °C with or without pulsed electric field (PEF) pre-treatment at 0.9 kV/cm and 1000 and 10,000 pulses. The effect of drying on processed samples was assessed by analysis of carotenoids, the furosine value, total phenols and the Whiteness Index (WI). PEF pre-treatment is effective in reducing drying times, but the degree of cellular breakdown makes the compounds more susceptible to chemical and enzymatic reactions. In our condition PEF pre-treatment increased the carotenoid degradation and promoted the Maillard reaction above all at the highest temperature of 70 °C. The assessment of carotenoid stability, together with th…
Suppliers’ software development project start-up practices
2017
Purpose The purpose of this paper is to present a life cycle phase of a software development project which is substantial for the success of the project. This paper visualizes the project start-up phase from suppliers’ perspective. Design/methodology/approach The method is a theory building from case studies. The data were collected from three software supplier firms by conducting process modeling separately in each firm. Findings The study resulted in a model of a supplier’s software project start-up which includes start-up practices and involved roles. The results indicate that project start-up is an integral and structured phase of project life cycle, which influences the execution of a…